- 您現在的位置：買賣IC網 > PDF目錄374047 > ADV7194KST (ANALOG DEVICES INC) Professional Extended-10⑩ Video Encoder with 54 MHz Oversampling PDF資料下載
參數資料
| 型號： | ADV7194KST |
| 廠商： | ANALOG DEVICES INC |
| 元件分類： | 顏色信號轉換 |
| 英文描述： | Professional Extended-10⑩ Video Encoder with 54 MHz Oversampling |
| 中文描述： | COLOR SIGNAL ENCODER, PQFP80 |
| 封裝： | LQFP-80 |
| 文件頁數： | 17/69頁 |
| 文件大小： | 647K |
| 代理商： | ADV7194KST |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁當前第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁
ADV7194
–17–
REV. 0
FEATURES—FUNCTIONAL DESCRIPTION
BLACK BURST OUTPUT
It is possible to output a black burst signal from two DACs. This
signal output is very useful for professional video equipment
since it enables two video sources to be locked together. (Mode
Register 9.)
BLACK BURST OUTPUT
CVBS
CVBS
DIGITAL DATA
GENERATOR
ADV7194
DIGITAL DATA
GENERATOR
ADV7194
Figure 27. Possible Application for the Black Burst Output
Signal
BRIGHTNESS DETECT
This feature is used to monitor the average brightness of the
incoming Y video signal on a field by field basis. The informa-
tion is read from the I
2
C and based on this information the color
saturation, contrast and brightness controls can be adjusted
(for example to compensate for very dark pictures). (Bright-
ness Detect Register.)
CHROMA/LUMA DELAY
The luminance data can be delayed by maximum of six clock
cycles. Additionally the Chroma can be delayed by a maximum
of eight clock cycles (one clock cycle at 27 MHz). (Timing Reg-
ister 0 and Mode Register 9.)
CHROMA DELAY
LUMA DELAY
Figure 28. Chroma Delay Figure 29. Luma Delay
CLAMP OUTPUT
The ADV7194 has a programmable clamp TTL output signal.
This clamp signal is programmable to the front and back porch.
The clamp signal can be varied by one to three clock cycles in
a positive and negative direction from the default position. (Mode
Register 5, Mode Register 7.)
CVBS
OUTPUT PIN
CLAMP
OUTPUT PIN
MR57 = 1
MR57 = 0
CLAMP O/P SIGNALS
Figure 30. Clamp Output Timing
CSO
,
HSO
AND
VSO
OUTPUTS
The ADV7194 supports three output timing signals,
CSO
(com-
posite sync signal),
HSO
(Horizontal Sync Signal) and
VSO
(Vertical Sync Signal). These output TTL signals are aligned
with the analog video outputs. See Figure 31 for an example
of these waveforms. (Mode Register 7.)
OUTPUT
VIDEO
525
1
2
3
4
5
6
7
8
9
10
11
–
19
EXAMPLE:- NTSC
CSO
HSO
VSO
Figure 31.
CSO
,
HSO
,
VSO
Timing Diagram
COLOR BAR GENERATION
The ADV7194 can be configured to generate 100/7.5/75/7.5
color bars for NTSC or 100/0/75/0 color bars for PAL. (Mode
Register 4.)
COLOR BURST SIGNAL CONTROL
The burst information can be switched on and off the composite
and chroma video output. (Mode Register 4.)
COLOR CONTROLS
The ADV7194 allows the user to control the brightness, contrast,
hue and saturation of the color. The control registers may be
double-buffered, meaning that any modification to the registers
will be done outside the active video region and, therefore, changes
made will not be visible during active video.
Contrast Control
Contrast adjustment is achieved by scaling the Y input data by a
factor programmed by the user. This factor allows the data to be
scaled between 0% and 150%. (Contrast Control Register.)
Brightness Control
The brightness is controlled by adding a programmable setup level
onto the scaled Y data. This brightness level may be added onto
the Y data. For NTSC with pedestal, the setup can vary from
0 IRE to 22.5 IRE. For NTSC without pedestal and PAL, the
setup can vary from –7.5 IRE to +15 IRE. (Brightness Control
Register.)
Color Saturation
Color adjustment is achieved by scaling the Cr and Cb input
data by a factor programmed by the user. This factor allows the
data to be scaled between 0% and 200%. (U Scale Register and
V Scale Register.)
Hue Adjust Control
The hue adjustment is achieved on the composite and chroma
outputs by adding a phase offset onto the color subcarrier in the
active video but leaving the color burst unmodified, i.e., only
the phase between the video and the colorburst is modified and
hence the hue is shifted. The ADV7194 provides a range of
±
22
°
in increments of 0.17578125
°
. (Hue Adjust Register.)
CHROMINANCE CONTROL
The color information can be switched on and off the com-
posite, chroma and color component video outputs. (Mode
Register 4.)
相關PDF資料 |
PDF描述 |
|---|---|
| ADV7194 | Professional Extended-10⑩ Video Encoder with 54 MHz Oversampling |
| ADV7202 | Simultaneous Sampling Video Rate Codec |
| ADV7300A | Multiformat SD, Progressive Scan/HDTV Video Encoder with Six NSV⑩ 12-Bit DACs |
| ADV7300AKST | Multiformat SD, Progressive Scan/HDTV Video Encoder with Six NSV⑩ 12-Bit DACs |
| ADV7301A | Multiformat SD, Progressive Scan/HDTV Video Encoder with Six NSV⑩ 12-Bit DACs |
相關代理商/技術參數 |
參數描述 |
|---|---|
| ADV7194KSTZ | 功能描述:IC ENCODER VIDEO EXT-10 80-LQFP RoHS:是 類別:集成電路 (IC) >> 接口 - 編碼器，解碼器，轉換器 系列:- 產品變化通告:Development Systems Discontinuation 26/Apr/2011 標準包裝:1 系列:- 類型:編碼器 應用:DVB-S.2 系統 電壓 - 電源，模擬:- 電壓 - 電源，數字:- 安裝類型:- 封裝/外殼:模塊 供應商設備封裝:模塊 包裝:散裝 其它名稱:Q4645799 |
| ADV7194KSTZ | 制造商:Analog Devices 功能描述:TV / Video IC |
| ADV7195 | 制造商:AD 制造商全稱:Analog Devices 功能描述:Multiformat Progressive Scan/HDTV Encoder with Three 11-Bit DACs and 10-Bit Data Input |
| ADV7195KS | 制造商:Analog Devices 功能描述:Video Encoder 3DAC 11-Bit 52-Pin MQFP 制造商:Rochester Electronics LLC 功能描述:MULTI-FORMAT VID+PROGSCAN/HDTV ENCODERIC - Bulk |
| ADV7195KST | 制造商:AD 制造商全稱:Analog Devices 功能描述:Multiformat Progressive Scan/HDTV Encoder with Three 11-Bit DACs and 10-Bit Data Input |
發布緊急采購，3分鐘左右您將得到回復。