- 您現在的位置：買賣IC網 > Datasheet目錄39 > CAT6095VP2-GT4 (ON Semiconductor)IC TEMP SENSOR STAND ALONE 8TDFN Datasheet資料下載
參數資料
| 型號： | CAT6095VP2-GT4 |
| 廠商： | ON Semiconductor |
| 文件頁數： | 8/15頁 |
| 文件大小： | 151K |
| 描述： | IC TEMP SENSOR STAND ALONE 8TDFN |
| 標準包裝： | 1 |
| 功能： | 溫度監控系統（傳感器） |
| 傳感器類型： | 內部 |
| 感應溫度： | -40°C ~ 125°C |
| 精確度： | ±3°C（最小值） |
| 拓撲： | ADC（三角積分型），比較器，寄存器庫 |
| 輸出類型： | I²C?/SMBus? |
| 輸出警報： | 是 |
| 輸出風扇： | 無 |
| 電源電壓： | 3 V ~ 3.6 V |
| 工作溫度： | -40°C ~ 125°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 8-WFDFN 裸露焊盤 |
| 供應商設備封裝： | 8-TDFN（2x3） |
| 包裝： | 標準包裝 |
| 其它名稱： | CAT6095VP2-GT4OSDKR |
CAT6095
http://onsemi.com
8
Temperature Sensor Operation
The CAT6095 temperature sensor (TS) combines a
Proportional to Absolute Temperature (PTAT) sensor with
a SD modulator, yielding a 12 bit plus sign digital
temperature representation.
The TS runs on an internal clock, and starts a new
conversion cycle at least every 100 ms. The result of the
most recent conversion is stored in the Temperature Data
Register (TDR), and remains there following a TS
ShutDown. Reading from the TDR does not interfere with
the conversion cycle.
The value stored in the TDR is compared against limits
stored in the High Limit Register (HLR), the Low Limit
Register (LLR) and/or Critical Temperature Register
(CTR). If the measured value is outside the alarm limits or
above the critical limit, then the EVENT
pin may be
asserted. The EVENT
output function is programmable, via
the Configuration Register for interrupt mode, comparator
mode and polarity.
The temperature limit registers can be Read or Written by
the host, via the serial interface. At poweron, all the
(writable) internal registers default to 0x0000, and should
therefore be initialized by the host to the desired values. The
EVENT
output starts out disabled (corresponding to
polarity active low); thus preventing irrelevant event bus
activity before the limit registers are initialized. While the
TS is enabled (not shutdown), event conditions are
normally generated by a change in measured temperature as
recorded in the TDR, but limit changes can also trigger
events as soon as the new limit creates an event condition,
i.e. asynchronously with the temperature sampling activity.
In order to minimize the thermal resistance between
sensor and PCB, it is recommended that the exposed
backside die attach pad (DAP) be soldered to the PCB
ground plane.
Registers
The CAT6095 contains eight 16bit wide registers
allocated to TS functions, as shown in Table 6. Upon
powerup, the internal address counter points to the
capability register.
Capability Register (User Read Only)
This register lists the capabilities of the TS, as detailed in
the corresponding bit map.
Configuration Register (Read/Write)
This register controls the various operating modes of the
TS, as detailed in the corresponding bit map.
Temperature Trip Point Registers (Read/Write)
The CAT6095 features 3 temperature limit registers, the
HLR, LLR and CLR mentioned earlier. The temperature
value recorded in the TDR is compared to the various limit
values, and the result is used to activate the EVENT
pin. To
avoid undesirable EVENT
pin activity, this pin is
automatically disabled at powerup to allow the host to
initialize the limit registers and the converter to complete the
first conversion cycle under nominal supply conditions.
Data format is twos complement with the LSB representing
0.25癈, as detailed in the corresponding bit maps.
Temperature Data Register (User Read Only)
This register stores the measured temperature, as well as
trip status information. B15, B14 and B13 are the trip status
bits, representing the relationship between measured
temperature and the 3 limit values; these bits are not affected
by EVENT status or by Configuration register settings.
Measured temperature is represented by bits B12 to B0. Data
format is twos complement, where B12 represents the sign,
B11 represents 128癈, etc. and B0 represents 0.0625癈.
Manufacturer ID Register (Read Only)
The manufacturer ID assigned by the PCISIG trade
organization to the CAT6095 device is 0x1B09.
Device ID and Revision Register (Read Only)
This register contains manufacturer specific device ID
and device revision information.
相關PDF資料 |
PDF描述 |
|---|---|
| DS1621S+ | IC THERMOMETER/STAT DIG 8-SOIC |
| DS1624S+T&R | IC THERM/EEPROM DIG 256BYT 8SOIC |
| DS1626S+ | IC THERMOMETER/STAT DIG 8-SOIC |
| DS1629S+T&R | IC THERM/RTC/CALENDAR DIG 8-SOIC |
| DS1631S+T&R | IC THERMOMETER DIG HI-PREC 8SOIC |
相關代理商/技術參數 |
參數描述 |
|---|---|
| CAT6095VP2I-GT4 | 功能描述:板上安裝溫度傳感器 Dig Output Temp Sensor RoHS:否 制造商:Omron Electronics 輸出類型:Digital 配置: 準確性:+/- 1.5 C, +/- 3 C 溫度閾值: 數字輸出 - 總線接口:2-Wire, I2C, SMBus 電源電壓-最大:5.5 V 電源電壓-最小:4.5 V 最大工作溫度:+ 50 C 最小工作溫度:0 C 關閉: 安裝風格: 封裝 / 箱體: 設備功能:Temperature and Humidity Sensor |
| CAT6201 | 制造商:ONSEMI 制造商全稱:ON Semiconductor 功能描述:300 mA / 13 V Adjustable CMOS LDO Regulator |
| CAT6201VP2.GT3 | 制造商:ONSEMI 制造商全稱:ON Semiconductor 功能描述:300 mA / 13 V Adjustable CMOS LDO Regulator |
| CAT6201VP2GT3 | 制造商:ONSEMI 制造商全稱:ON Semiconductor 功能描述:300 mA / 13 V Adjustable CMOS LDO Regulator |
| CAT6201VP2-GT3 | 功能描述:低壓差控制器 - LDO LDO 300 MA ADJUSTABLE RoHS:否 制造商:Micrel 最大輸入電壓:5.5 V 輸出電壓:Adjustable 輸出電流:10 mA 負載調節: 輸出類型:Adjustable, Fixed 輸出端數量:1 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:SOT-23-6 |
發布緊急采購，3分鐘左右您將得到回復。