欧美成人免费电影,国产欧美一区二区三区精品酒店,精品国产a毛片,色网在线免费观看

參數資料
型號: DJIXF972MTAA4
廠商: Intel Corp.
英文描述: Single-Port 10/100 Mbps PHY Transceiver
中文描述: 單端口10/100 Mbps的物理層收發器
文件頁數: 51/92頁
文件大小: 666K
代理商: DJIXF972MTAA4
Intel
LXT972M Single-Port 10/100 Mbps PHY Transceiver
Datasheet
Document Number: 302875-005
Revision Date: 27-Oct-2005
51
5.8.4
10BASE-T Link Integrity Test
In 10BASE-T mode, the LXT972M Transceiver always transmits link pulses.
If the Link Integrity Test function is enabled (the normal configuration), the LXT972M
Transceiver monitors the connection for link pulses. Once link pulses are detected, data
transmission is enabled and remains enabled as long as either the link pulses or data
transmission continue. If the link pulses stop, the data transmission is disabled.
If the Link Integrity Test function is disabled (which can be done by setting Configuration
Register bit 16.14 to ‘1’), the LXT972M Transceiver transmits to the connection regardless of
detected link pulses.
5.8.5
Link Failure
Link failure occurs if the Link Integrity Test is enabled and link pulses or packets stop being
received. If this condition occurs, the LXT972M Transceiver returns to the auto-negotiation phase
if auto-negotiation is enabled. If the Link Integrity Test function is disabled by setting
Configuration Register bit 16.14 to ‘1’, the LXT972M Transceiver transmits packets, regardless of
link status.
5.8.6
10BASE-T SQE (Heartbeat)
By default, the Signal Quality Error (SQE) or heartbeat function is disabled on the LXT972M
Transceiver. To enable this function, set Register bit 16.9 = 1. When this function is enabled, the
LXT972M Transceiver asserts its COL output for 5 to 15 bit times (BT) after each packet.
5.8.7
10BASE-T Jabber
If a transmission exceeds the jabber timer, the LXT972M Transceiver disables the transmit and
loopback functions. For jabber timing parameters, see
Figure 26, “Intel LXT972M Transceiver
10BASE-T Jabber and Unjabber Timing” on page 69
.
The LXT972M Transceiver automatically exits jabber mode after the unjabber time has expired.
This function can be disabled by setting Register bit 16.10 = 1.
5.8.8
10BASE-T Polarity Correction
The LXT972M Transceiver automatically detects and corrects for the condition in which the
receive signal (TPIP/N) is inverted. Reversed polarity is detected if eight inverted link pulses - or
four inverted end-of-frame (EOF) markers - are received consecutively. If link pulses or data are
not received by the maximum receive time-out period (96 to 128 ms), the polarity state is reset to a
non-inverted state. When polarity reversal is detected in 10BASE-T operation, register 17.5 is set
to 1. (For details, see bit 17.5 in
Table 52, “Status Register #2 - Address 17, Hex 11” on page 85
.)
相關PDF資料
PDF描述
DJIXF972MTCA4 Single-Port 10/100 Mbps PHY Transceiver
DJIXF972MTEA4 Single-Port 10/100 Mbps PHY Transceiver
DJIXP972MBAA4 Single-Port 10/100 Mbps PHY Transceiver
DJIXP972MBCA4 Single-Port 10/100 Mbps PHY Transceiver
DJIXP972MBEA4 Single-Port 10/100 Mbps PHY Transceiver
相關代理商/技術參數
參數描述
DJIXF972MTCA4 制造商:INTEL 制造商全稱:Intel Corporation 功能描述:Single-Port 10/100 Mbps PHY Transceiver
DJIXF972MTEA4 制造商:INTEL 制造商全稱:Intel Corporation 功能描述:Single-Port 10/100 Mbps PHY Transceiver
DJIXFEAD0QE000 制造商:INTEL 制造商全稱:Intel Corporation 功能描述:Advanced 8-Port 10/100 Mbps PHY Transceivers
DJIXFEAD0QE001 制造商:INTEL 制造商全稱:Intel Corporation 功能描述:Advanced 8-Port 10/100 Mbps PHY Transceivers
DJIXFEAD0SE000 制造商:INTEL 制造商全稱:Intel Corporation 功能描述:Advanced 8-Port 10/100 Mbps PHY Transceivers
主站蜘蛛池模板: 饶河县| 冀州市| 乐平市| 涿鹿县| 廉江市| 丰城市| 象州县| 全州县| 封开县| 璧山县| 清水县| 巧家县| 雅江县| 林甸县| 安康市| 扶沟县| 淮南市| 乌鲁木齐县| 河西区| 琼结县| 南安市| 合水县| 团风县| 石泉县| 邮箱| 克什克腾旗| 永昌县| 包头市| 连城县| 鹤山市| 雅江县| 郁南县| 呈贡县| 图木舒克市| 建昌县| 肇东市| 郎溪县| 修武县| 浦城县| 临城县| 蒲江县|