- 您現在的位置：買賣IC網 > PDF目錄16767 > DP83848YB-EVK/NOPB (National Semiconductor)EVAL BOARD PHYTER EXTREME TEMP PDF資料下載
參數資料
| 型號： | DP83848YB-EVK/NOPB |
| 廠商： | National Semiconductor |
| 文件頁數： | 4/86頁 |
| 文件大小： | 0K |
| 描述： | EVAL BOARD PHYTER EXTREME TEMP |
| 標準包裝： | 1 |
| 主要目的： | 接口，以太網 |
| 已用 IC / 零件： | DP83848YB |
| 已供物品： | 板 |
第1頁第2頁第3頁當前第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁
11
www.national.com
DP
83
84
8
Y
B
1.3 Clock Interface
1.4 LED Interface
See Table 3 for LED Mode Selection.
Signal Name
Type
Pin #
Description
X1
I
34
CRYSTAL/OSCILLATOR INPUT: This pin is the primary clock
reference input for the DP83848YB and must be connected to a
25 MHz 0.005% (+50 ppm) clock source. The DP83848YB sup-
ports either an external crystal resonator connected across pins
X1 and X2, or an external CMOS-level oscillator source connect-
ed to pin X1 only.
RMII REFERENCE CLOCK: This pin is the primary clock refer-
ence input for the RMII mode and must be connected to a 50 MHz
0.005% (+50 ppm) CMOS-level oscillator source.
X2
O
33
CRYSTAL OUTPUT: This pin is the primary clock reference out-
put to connect to an external 25 MHz crystal resonator device.
This pin must be left unconnected if an external CMOS oscillator
clock source is used.
25MHz_OUT
O
25
25 MHz CLOCK OUTPUT:
In MII mode, this pin provides a 25 MHz clock output to the sys-
tem.
In RMII mode, this pin provides a 50 MHz clock output to the sys-
tem.
This allows other devices to use the reference clock from the
DP83848YB without requiring additional clock sources.
Signal Name
Type
Pin #
Description
LED_LINK
S, O, PU
28
LINK LED: In Mode 1, this pin indicates the status of the LINK.
The LED will be ON when Link is good.
LINK/ACT LED: In Mode 2 and Mode 3, this pin indicates transmit
and receive activity in addition to the status of the Link. The LED
will be ON when Link is good. It will blink when the transmitter or
receiver is active.
LED_SPEED
S, O, PU
27
SPEED LED: The LED is ON when device is in 100 Mb/s and OFF
when in 10 Mb/s. Functionality of this LED is independent of mode
selected.
LED_ACT/COL
S, O, PU
26
ACTIVITY LED: In Mode 1, this pin is the Activity LED which is
ON when activity is present on either Transmit or Receive.
COLLISION/DUPLEX LED: In Mode 2, this pin by default indi-
cates Collision detection. For Mode 3, this LED output may be
programmed to indicate Full-duplex status instead of Collision.
相關PDF資料 |
PDF描述 |
|---|---|
| 200LLE8R2MEFC8X9 | CAP ALUM 8.2UF 200V 20% RADIAL |
| 462A423-51-0 | BOOT MOLDED |
| M3DDA-1636J | IDC CABLE - MKR16A/MC16G/MKR16A |
| 0210200344 | CABLE FLAT FLEX 4" 0.50MM 32POS |
| UPJ1V390MED1TD | CAP ALUM 39UF 35V 20% RADIAL |
相關代理商/技術參數 |
參數描述 |
|---|---|
| DP83848YBX/NOPB | 功能描述:以太網 IC RoHS:否 制造商:Micrel 產品:Ethernet Switches 收發器數量:2 數據速率:10 Mb/s, 100 Mb/s 電源電壓-最大:1.25 V, 3.45 V 電源電壓-最小:1.15 V, 3.15 V 最大工作溫度:+ 85 C 封裝 / 箱體:QFN-64 封裝:Tray |
| DP83849C | 制造商:NSC 制造商全稱:National Semiconductor 功能描述:PHYTER? DUAL Commercial Temperature Dual Port 10/100 Mb/s Ethernet Physical Layer Transceiver |
| DP83849C_08 | 制造商:NSC 制造商全稱:National Semiconductor 功能描述:PHYTER? DUAL Commercial Temperature Dual Port 10/100 Mb/s Ethernet Physical Layer Transceiver |
| DP83849CVS | 功能描述:以太網 IC RoHS:否 制造商:Micrel 產品:Ethernet Switches 收發器數量:2 數據速率:10 Mb/s, 100 Mb/s 電源電壓-最大:1.25 V, 3.45 V 電源電壓-最小:1.15 V, 3.15 V 最大工作溫度:+ 85 C 封裝 / 箱體:QFN-64 封裝:Tray |
| DP83849CVS | 制造商:Texas Instruments 功能描述:TRANSCEIVER, ENET PHYTER, DUAL, 80TQFP 制造商:Texas Instruments 功能描述:TRANSCEIVER, ENET PHYTER, DUAL, 80TQFP; Data Rate:100Mbps; Ethernet Type:IEEE 802.3u; Supply Voltage Min:3V; Supply Voltage Max:3.6V; Digital IC Case Style:TQFP; No. of Pins:80; Interface Type:MII, RMII, Serial; Operating Temperature;RoHS Compliant: Yes |
發布緊急采購，3分鐘左右您將得到回復。