- 您現在的位置：買賣IC網 > PDF目錄375853 > FM8P51EP (Electronic Theatre Controls, Inc.) EPROM/ROM-Based 8-Bit Microcontroller PDF資料下載
參數資料
| 型號： | FM8P51EP |
| 廠商： | Electronic Theatre Controls, Inc. |
| 英文描述： | EPROM/ROM-Based 8-Bit Microcontroller |
| 中文描述： | 存儲器/基于ROM的8位微控制器 |
| 文件頁數： | 23/60頁 |
| 文件大小： | 369K |
| 代理商： | FM8P51EP |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁當前第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁
FM8P51
Rev1.2 Mar 15, 2005
P.23/FM8P51
FEELING
TECHNOLOGY
prescaler with a division ratio of up to 1:128 can be assigned to the WDT controlled by the OPTION register. Thus,
the longest time-out period is approxmately 2.3 seconds if reset delay time is set to 18ms.
The CLRWDT instruction clears the WDT and the prescaler, if assigned to the WDT, and prevents it from timing out
and generating a device reset.
The SLEEP instruction resets the WDT and the prescaler, if assigned to the WDT. This gives the maximum SLEEP
time before a WDT Wake-up Reset.
2.3.3 Prescaler
An 8-bit counter (down counter) is available as a prescaler for the Timer0, or as a postscaler for the Watchdog Timer
(WDT). Note that the prescaler may be used by either the Timer0 module or the WDT, but not both. Thus, a
prescaler assignment for the Timer0 means that there is no prescaler for the WDT, and vice-versa.
The PSA bit (OPTION<3>) determines prescaler assignment. The PS<2:0> bits (OPTION<2:0>) determine
prescaler ratio.
When the prescaler is assigned to the Timer0 module, all instructions writing to the TMR0 register will clear the
prescaler. When it is assigned to WDT, a CLRWDT instruction will clear the prescaler along with the WDT.
The prescaler is neither readable nor writable. On a RESET, the prescaler contains all ‘1’s.
To avoid an unintended device reset, CLRWDT or CLRR TMR0 instructions must be executed when changing the
prescaler assignment from Timer0 to the WDT, and vice-versa.
FIGURE 2.4: Block Diagram of The Timer0/WDT Prescaler
2.4 Timer1
The Timer1 is a 8-bit clock counter with a programmable prescaler and a 8-bit period register (PR1). It also can be
as a baud rate clock generator for the SPI module. The clock source of Timer1 comes from the internal clock
(Fosc/4). The option of Timer1 prescaler (1:1, 1:4, 1:8, 1:16) is defined by T1P1:T1P0 (T1CON<1:0>) bits.
The
prescaler is cleared when a value is written to TMR1 or T1CON register, and during any kind of reset as
well.
The timer increments from 00h until it equals the period register (PR1). It then resets to 00h at the next increment
cycle. The timer interrupt flag (T1IF) is set when the timer rollover to 00h.
The timer also has a corresponding interrupt enable bit (T1IE). The timer interrupt can be enabled/disabled by
setting/clearing this bit.
The timer s can be turned on and off under software control. When the timer on control bit (T1ON, T1CON<2>) is set,
the timer increments from the clock source. When T1ON is cleared, the timer is turned off and cannot cause the
MUX
0
1
Watchdog
Timer
PSA
8-Bit
Prescaler
PS2:PS0
WDT Time-out
MUX
1
0
PSA
MUX
1
0
PSA
Sync
2 Cycles
Instruction Cycle
(Fosc/4 or Fosc/2)
TMR0
Register
Data Bus
8
Set T0IF flag
on overflow
相關PDF資料 |
PDF描述 |
|---|---|
| FM8P51F | EPROM/ROM-Based 8-Bit Microcontroller |
| FM8P51P | EPROM/ROM-Based 8-Bit Microcontroller |
| FM8P51E | EPROM/ROM-Based 8-Bit Microcontroller |
| FM8P54 | EPROM/ROM-Based 8-Bit Microcontroller Series |
| FM8P54E | EPROM/ROM-Based 8-Bit Microcontroller Series |
相關代理商/技術參數 |
參數描述 |
|---|---|
| FM8P51F | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:EPROM/ROM-Based 8-Bit Microcontroller |
| FM8P51P | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:EPROM/ROM-Based 8-Bit Microcontroller |
| FM8P54 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:EPROM/ROM-Based 8-Bit Microcontroller Series |
| FM8P54E | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:EPROM/ROM-Based 8-Bit Microcontroller Series |
| FM8P56 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:EPROM/ROM-Based 8-Bit Microcontroller Series |
發布緊急采購，3分鐘左右您將得到回復。