- 您現在的位置：買賣IC網 > PDF目錄375853 > FM8P51EP (Electronic Theatre Controls, Inc.) EPROM/ROM-Based 8-Bit Microcontroller PDF資料下載
參數資料
| 型號： | FM8P51EP |
| 廠商： | Electronic Theatre Controls, Inc. |
| 英文描述： | EPROM/ROM-Based 8-Bit Microcontroller |
| 中文描述： | 存儲器/基于ROM的8位微控制器 |
| 文件頁數： | 36/60頁 |
| 文件大?。?/td> | 369K |
| 代理商： | FM8P51EP |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁當前第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁
FM8P51
Rev1.2 Mar 15, 2005
P.36/FM8P51
FEELING
TECHNOLOGY
3. Enable the RFC module by set the RFCON bit.
4. Select one of RFCx pins by RFCS4:RFCS0 bits to enable the output pin for RC networks respectively. The
selected RFCx will output low at this time. Other RFCx pins will become of a tri-state type.
5. Set START bit to enable the RC oscillation network and 15-bit counter. The RC oscillation network will not
operate if this bit has not been set. After conversion is finished, the START bit will be cleared by hardware and
the RFCIF flag will be set (if enable).
2.9.2 Enable/Disable the Counter by CX Signal
In this module, CX pin is the signal to control the counter period and the clock source of the counter comes from the
internal system clock (Fosc).
The counter will start to count after the first rising edge signal applied on the CX pin after the RFCON bit
(RFCCON<7>) is set. Once the second rising edge is applied to the CX pin after the counter is enabled, the counter
will stop counting. And after the second falling edge is applied to the CX pin, the RFC block will clear the RFCON bit
and set the RFC interrupt flag RFCIF bit (INTFLAG<6>) if RFCIE bit is set.
User also can polling the RFCON or RFCIF bit to check if the conversion is finished.
FIGURE 2.14: The Sample of the RFC Counter Controlled by the CX Pin
START
CX signal on pin
CX signal
Counter active
RFC Counter
Fosc
RFCIF (if enabled)
By S/W
Counter starts
to count
Counting stops, caused by
the 2nd falling edge of CX
N
N-1
N-2
0
1
2
3
By H/W
相關PDF資料 |
PDF描述 |
|---|---|
| FM8P51F | EPROM/ROM-Based 8-Bit Microcontroller |
| FM8P51P | EPROM/ROM-Based 8-Bit Microcontroller |
| FM8P51E | EPROM/ROM-Based 8-Bit Microcontroller |
| FM8P54 | EPROM/ROM-Based 8-Bit Microcontroller Series |
| FM8P54E | EPROM/ROM-Based 8-Bit Microcontroller Series |
相關代理商/技術參數 |
參數描述 |
|---|---|
| FM8P51F | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:EPROM/ROM-Based 8-Bit Microcontroller |
| FM8P51P | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:EPROM/ROM-Based 8-Bit Microcontroller |
| FM8P54 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:EPROM/ROM-Based 8-Bit Microcontroller Series |
| FM8P54E | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:EPROM/ROM-Based 8-Bit Microcontroller Series |
| FM8P56 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:EPROM/ROM-Based 8-Bit Microcontroller Series |
發布緊急采購，3分鐘左右您將得到回復。