- 您現在的位置：買賣IC網 > PDF目錄360994 > ISD5216SERIES Single-Chip Voice Record/Playback Device PDF資料下載
參數資料
| 型號： | ISD5216SERIES |
| 英文描述： | Single-Chip Voice Record/Playback Device |
| 中文描述： | 單芯片語音記錄/播放設備 |
| 文件頁數： | 17/83頁 |
| 文件大小： | 758K |
| 代理商： | ISD5216SERIES |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁當前第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁
I5216 SERIES
Advanced Information
PRELIMINARY
Publication Release Date: November 30, 2001
-17
Revision A1
MEMORY ORGANIZATION
The I5216 memory array is arranged as 1888 rows (or pages) of 2048 bits, for a total memory of
3,866,624 bits. The primary addressing for the 2048 pages is handled by 11 bits of address data in the
analog mode. At the 8 kHz sample rate, each page contains 256 milliseconds of audio. Thus, at 8 kHz
there is actually room for 8 minutes and 3 seconds of audio.
A memory page is 2048 bits organized as thirty-two 64-bit "blocks" when used for digital storage. The
contents of a page are either analog or digital. This is determined by instruction (op code) at the time
the data is written. A record of what is analog and what is digital, and where, is stored by the system
microcontroller in the message address table (MAT). The MAT is a table kept in the microcontroller
memory that defines the status of each message “block.” It can be stored back into the I5216 if the
power fails or the system is turned off. Use of this table allows for efficient message management.
Segments of messages can be stored wherever there is available space in the memory array. [This
is explained in detail for the Winbond I5008 in Applications Note #No.9 and will similarly be in a later
Note for the I5216.]
When a page is used for analog storage, the same 32 blocks are present, but there are 8 EOM (End-
of-Message) markers. This means that for each 4 blocks there is an EOM marker at the end. Thus,
when recording, the analog recording will stop at any one of eight positions. At 8 kHz, this results in a
resolution of 32 msec when ENDING an analog recording. Beginning an analog recording is limited to
the 256 msec resolution provided by the 11-bit address. A recording does not immediately stop when
the Stop command is issued, but continues until the 32-millisecond block is filled. Then a bit is placed
into the EOM memory to develop the interrupt that signals a message is finished playing in the
Playback mode.
Digital data is sent and received, serially, over the I
2
C interface. The data is serial-to-parallel converted
and stored in one of two alternating (commutating) 64-bit shift registers. When an input register is full,
it becomes the register that is parallel written into the array. The prior write register becomes the new
serial input register. A mechanism is built in to ensure there is always a register available for storing
new data.
Storing data in the memory is accomplished by accepting data, one byte at a time, and issuing an
acknowledgement. If data is coming in faster than it can be written, then the chip will not issue an
acknowledgement to the host microcontroller until it is ready.
The read mode is the opposite of the write mode. Data is read into one of two 64-bit registers from the
array and serially sent to the I
2
C port. (See
Digital Mode
on page 41 for details).
OPERATION MODES DESCRIPTION
I
2
C PORT
Important note:
The content contained herein of the rest of this datasheet assumes that the
reader is familiar with the I
2
C serial interface. Additional information on I
2
C may be found in
the I
2
C section of this document. If you are not familiar with this serial protocol, please read
the I2C section to familiarize yourself with it. A significant amount of additional information on
I
2
C can also be found on the Philips web page at
http://www.philips.com/
.
相關PDF資料 |
PDF描述 |
|---|---|
| ISDMICROTAD-16M | |
| ISDNRNYNG | Optoelectronic |
| ISG4042-T | 5V CATV MODEM RF TUNER AND TRANSMITTER |
| ISG4042EU-T | 5V CATV MODEM RF TUNER AND TRANSMITTER |
| ISG52124-L | 5 TO 210 MHz SILICON CATV 24 dB LOW POWER HYBRID AMPLIFIER |
相關代理商/技術參數 |
參數描述 |
|---|---|
| ISD5216SI | 制造商:WINBOND 制造商全稱:Winbond 功能描述:8 to 16 minutes voice record/playback device with integrated codec |
| ISD5216SY | 功能描述:IC VOICE REC/PLAY 8-16MIN 28SOIC RoHS:是 類別:集成電路 (IC) >> 接口 - 語音錄制和重放 系列:ISL5216 標準包裝:14 系列:- 接口:串行 濾波器通頻帶:1.7kHz 持續時間:8 ~ 32 秒 安裝類型:通孔 封裝/外殼:28-DIP（0.300"，7.62mm） 供應商設備封裝:28-PDIP 其它名稱:90-21300+000 |
| ISD5216SYI | 功能描述:IC VOICE REC/PLAY 8-16MIN 28SOIC RoHS:是 類別:集成電路 (IC) >> 接口 - 語音錄制和重放 系列:ISL5216 標準包裝:14 系列:- 接口:串行 濾波器通頻帶:1.7kHz 持續時間:8 ~ 32 秒 安裝類型:通孔 封裝/外殼:28-DIP（0.300"，7.62mm） 供應商設備封裝:28-PDIP 其它名稱:90-21300+000 |
| ISD5X | 制造商:Isocom Components 功能描述:OPTOCOUPLER DIP-8 DUAL TR. O/P 制造商:Isocom Components 功能描述:Dual opto coupler,ISD5X DIP8 5300Vac |
| ISD5XSM | 制造商:Isocom Components 功能描述:OPTOCOUPLER SMDIP-8 DUAL TR O/P 制造商:Isocom Components 功能描述:OPTOCOUPLER, SMDIP-8, DUAL TR O/P |
發布緊急采購，3分鐘左右您將得到回復。