欧美成人免费电影,国产欧美一区二区三区精品酒店,精品国产a毛片,色网在线免费观看

參數資料
型號: ISP1109BS
廠商: NXP SEMICONDUCTORS
元件分類: 通用總線功能
英文描述: Universal Serial Bus transceiver with carkit support
中文描述: LINE TRANSCEIVER, PQCC32
封裝: LEAD FREE, 5 X 5 MM, 0.85 MM HEIGHT, PLASTIC, MO-220, SOT617-1, HVQFN-32
文件頁數: 15/59頁
文件大小: 295K
代理商: ISP1109BS
9397 750 13355
Koninklijke Philips Electronics N.V. 2005. All rights reserved.
Product data sheet
Rev. 01 — 14 July 2005
15 of 59
Philips Semiconductors
ISP1109
USB transceiver with carkit support
8.
Modes of operation
The ISP1109 supports four types of modes:
Power modes
Serial control modes
USB modes
Transparent modes.
8.1 Power modes
8.1.1
Normal mode
In this mode, both V
CC
and V
CC(I/O)
are connected and their voltage levels are within the
operation range (V
CC
3.0 V, V
CC(I/O)
1.65 V, V
CC(I/O)
V
CC
).
There are three levels of power saving schemes in the ISP1109:
Active power mode: Power is on; all circuits are active.
USB suspend mode: To reduce power consumption, the USB differential receiver is
powered off.
Power-down mode: Set by writing logic 1 to bit PWR_DN of the Mode Control 2
register. The clock generator and all biasing circuits are turned off to reduce power
consumption to the minimum possible; typically I
CC
is less than 20
μ
A. For details on
waking up the clock, see
Section 10
.
8.1.2
Disable mode
In disable mode, V
CC(I/O)
is cut-off and V
CC
is powered. In this mode, the ISP1109 is in
Power-down state, if V
BUS
is below SESS_VLD threshold (0.8 V to 2.0 V).
When V
CC
is below threshold V
th(ISET)
, pin ISET will remain at the LOW level.
When V
BUS
> V
th(svc)
and V
CC
rises above V
th(ISET)
, the ISP1109 will output HIGH on
pin ISET, if any of the following conditions is detected:
Voltage on pin ID is greater than V
th(ID_FM)
DP and DM are single-ended one (SE1).
If the preceding condition is detected, pin ISET will be asserted within 1.5 ms when V
CC
rises above V
th(ISET)
.
The USB differential driver will be set in three-state as long as V
CC(I/O)
is lost. The DP
pull-up resistor (R
UP(DP)
) will be disconnected from the DP line. The DP weak pull-up
resistor (R
weakUP(DP)
) will be connected if the V
BUS
voltage is above V
th(svc)
.
8.1.3
Isolate mode
In isolate mode, V
CC
is cut-off and V
CC(I/O)
is powered. In this mode, the ISP1109 will drive
stable level to all digital output pins, and all bidirectional digital pins will be set in
three-state.
Table 10
shows a summary of power modes.
相關PDF資料
PDF描述
ISP1122A Universal Serial Bus stand-alone hub
ISP1122ABD Universal Serial Bus stand-alone hub
ISP1122AD Universal Serial Bus stand-alone hub
ISP1122ANB Universal Serial Bus stand-alone hub
ISP1122 Universal Serial Bus stand-alone hub
相關代理商/技術參數
參數描述
ISP1109BS,118 功能描述:射頻收發器 USB FS TRANSCVR RoHS:否 制造商:Atmel 頻率范圍:2322 MHz to 2527 MHz 最大數據速率:2000 Kbps 調制格式:OQPSK 輸出功率:4 dBm 類型: 工作電源電壓:1.8 V to 3.6 V 最大工作溫度:+ 85 C 接口類型:SPI 封裝 / 箱體:QFN-32 封裝:Tray
ISP1109BS,151 功能描述:射頻收發器 DO NOT USE ORDER -T PART RoHS:否 制造商:Atmel 頻率范圍:2322 MHz to 2527 MHz 最大數據速率:2000 Kbps 調制格式:OQPSK 輸出功率:4 dBm 類型: 工作電源電壓:1.8 V to 3.6 V 最大工作溫度:+ 85 C 接口類型:SPI 封裝 / 箱體:QFN-32 封裝:Tray
ISP1109BS,157 功能描述:射頻收發器 DO NOT USE ORDER -T PART RoHS:否 制造商:Atmel 頻率范圍:2322 MHz to 2527 MHz 最大數據速率:2000 Kbps 調制格式:OQPSK 輸出功率:4 dBm 類型: 工作電源電壓:1.8 V to 3.6 V 最大工作溫度:+ 85 C 接口類型:SPI 封裝 / 箱體:QFN-32 封裝:Tray
ISP1109BSFE 功能描述:IC TXRX SERIAL BUS UNIV 32HVQFN RoHS:是 類別:集成電路 (IC) >> 接口 - 驅動器,接收器,收發器 系列:- 標準包裝:2,500 系列:- 類型:驅動器 驅動器/接收器數:4/0 規程:RS422 電源電壓:4.5 V ~ 5.5 V 安裝類型:表面貼裝 封裝/外殼:16-SOIC(0.154",3.90mm 寬) 供應商設備封裝:16-SOIC N 包裝:帶卷 (TR)
ISP1109BS-S 功能描述:IC TXRX SERIAL BUS UNIV 32HVQFN RoHS:是 類別:集成電路 (IC) >> 接口 - 驅動器,接收器,收發器 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:25 系列:- 類型:收發器 驅動器/接收器數:2/2 規程:RS232 電源電壓:4.5 V ~ 5.5 V 安裝類型:通孔 封裝/外殼:16-DIP(0.300",7.62mm) 供應商設備封裝:16-PDIP 包裝:管件
主站蜘蛛池模板: 济阳县| 盐源县| 大余县| 信丰县| 肥乡县| 龙井市| 芦溪县| 容城县| 河东区| 潮安县| 从化市| 潢川县| 静安区| 贡嘎县| 方城县| 鹿泉市| 洛宁县| 改则县| 辽源市| 新龙县| 西乌| 武穴市| 民勤县| 绥芬河市| 富源县| 前郭尔| 天镇县| 麻阳| 沾益县| 永寿县| 毕节市| 开远市| 城口县| 京山县| 洛宁县| 峨山| 舟曲县| 电白县| 天长市| 靖远县| 阳朔县|