- 您現在的位置：買賣IC網 > PDF目錄360998 > ISP1109BS (NXP SEMICONDUCTORS) Universal Serial Bus transceiver with carkit support PDF資料下載
參數資料
| 型號： | ISP1109BS |
| 廠商： | NXP SEMICONDUCTORS |
| 元件分類： | 通用總線功能 |
| 英文描述： | Universal Serial Bus transceiver with carkit support |
| 中文描述： | LINE TRANSCEIVER, PQCC32 |
| 封裝： | LEAD FREE, 5 X 5 MM, 0.85 MM HEIGHT, PLASTIC, MO-220, SOT617-1, HVQFN-32 |
| 文件頁數： | 8/59頁 |
| 文件大小： | 295K |
| 代理商： | ISP1109BS |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁當前第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁
9397 750 13355
Koninklijke Philips Electronics N.V. 2005. All rights reserved.
Product data sheet
Rev. 01 — 14 July 2005
8 of 59
Philips Semiconductors
ISP1109
USB transceiver with carkit support
7.
Functional description
7.1 Serial controller
The serial controller includes the following functions:
Serial Controller interface (SPI or I
2
C-bus)
Device Identification registers
Control registers
Interrupt registers
Interrupt generator.
The serial controller acts as an SPI slave or I
2
C-bus slave.
All the registers are the same as that in SPI or I
2
C-bus mode. In I
2
C-bus mode, the
registers are accessed in 8-bit width (bits 0 to 7) for each address. In SPI mode, there are
25 bits for each address, only bits 0 to 7 are useful while bits 8 to 24 are don’t cares.
At hardware reset including power-on reset, the level on pin SPI_I2C_SEL will determine
whether the SPI or I
2
C-bus interface is active. If SPI_I2C_SEL = LOW, the SPI interface is
selected. If SPI_I2C_SEL = HIGH, the I
2
C-bus interface is selected.
7.2 V
BUS
detector
The V
BUS
detector provides voltage level detection on V
BUS
. If V
BUS
is above the V
BUS
session valid comparator threshold voltage (V
th(svc)
), logic 1 will be stored in
bit VBUS_DET of the Interrupt Source register. If V
BUS
is below V
th(svc)
, logic 0 will be
stored.
7.3 ID detector
In normal power mode, that is, when both V
CC
and V
CC(I/O)
are present, the ID detector
senses the condition of the ID line and can differentiate between the following three
conditions:
ID pin is floating (bit ID_FLOAT = 1)
ID pin is shorted to ground (bit ID_GND = 1)
ID pin is connected to ground through resistor R
DN(ID)
(bits ID_FLOAT and ID_GND
are logic 0).
The recommended procedure to detect the status of ID using software is:
1. When nothing is connected, ID is in the ID_FLOAT state. Enable the ID_FLOAT
interrupt (falling edge).
2. If an interrupt occurs, read the Interrupt Latch register. If ID changes, bit ID_FLOAT is
set.
3. The software waits for sometime, for example: 100 ms, to allow mechanical
debounce.
4. The software reads the Interrupt Source register, and checks bits ID_FLOAT and
ID_GND.
相關PDF資料 |
PDF描述 |
|---|---|
| ISP1122A | Universal Serial Bus stand-alone hub |
| ISP1122ABD | Universal Serial Bus stand-alone hub |
| ISP1122AD | Universal Serial Bus stand-alone hub |
| ISP1122ANB | Universal Serial Bus stand-alone hub |
| ISP1122 | Universal Serial Bus stand-alone hub |
相關代理商/技術參數 |
參數描述 |
|---|---|
| ISP1109BS,118 | 功能描述:射頻收發器 USB FS TRANSCVR RoHS:否 制造商:Atmel 頻率范圍:2322 MHz to 2527 MHz 最大數據速率:2000 Kbps 調制格式:OQPSK 輸出功率:4 dBm 類型: 工作電源電壓:1.8 V to 3.6 V 最大工作溫度:+ 85 C 接口類型:SPI 封裝 / 箱體:QFN-32 封裝:Tray |
| ISP1109BS,151 | 功能描述:射頻收發器 DO NOT USE ORDER -T PART RoHS:否 制造商:Atmel 頻率范圍:2322 MHz to 2527 MHz 最大數據速率:2000 Kbps 調制格式:OQPSK 輸出功率:4 dBm 類型: 工作電源電壓:1.8 V to 3.6 V 最大工作溫度:+ 85 C 接口類型:SPI 封裝 / 箱體:QFN-32 封裝:Tray |
| ISP1109BS,157 | 功能描述:射頻收發器 DO NOT USE ORDER -T PART RoHS:否 制造商:Atmel 頻率范圍:2322 MHz to 2527 MHz 最大數據速率:2000 Kbps 調制格式:OQPSK 輸出功率:4 dBm 類型: 工作電源電壓:1.8 V to 3.6 V 最大工作溫度:+ 85 C 接口類型:SPI 封裝 / 箱體:QFN-32 封裝:Tray |
| ISP1109BSFE | 功能描述:IC TXRX SERIAL BUS UNIV 32HVQFN RoHS:是 類別:集成電路 (IC) >> 接口 - 驅動器，接收器，收發器 系列:- 標準包裝:2,500 系列:- 類型:驅動器 驅動器/接收器數:4/0 規程:RS422 電源電壓:4.5 V ~ 5.5 V 安裝類型:表面貼裝 封裝/外殼:16-SOIC（0.154"，3.90mm 寬） 供應商設備封裝:16-SOIC N 包裝:帶卷 (TR) |
| ISP1109BS-S | 功能描述:IC TXRX SERIAL BUS UNIV 32HVQFN RoHS:是 類別:集成電路 (IC) >> 接口 - 驅動器，接收器，收發器 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:25 系列:- 類型:收發器 驅動器/接收器數:2/2 規程:RS232 電源電壓:4.5 V ~ 5.5 V 安裝類型:通孔 封裝/外殼:16-DIP（0.300"，7.62mm） 供應商設備封裝:16-PDIP 包裝:管件 |
發布緊急采購，3分鐘左右您將得到回復。