- 您現在的位置：買賣IC網 > PDF目錄360999 > ISP1301 (NXP Semiconductors N.V.) Universal Serial Bus On-The-Go transceiver PDF資料下載
參數資料
| 型號： | ISP1301 |
| 廠商： | NXP Semiconductors N.V. |
| 英文描述： | Universal Serial Bus On-The-Go transceiver |
| 中文描述： | 通用串行總線在- The - Go的收發器 |
| 文件頁數： | 10/46頁 |
| 文件大小： | 245K |
| 代理商： | ISP1301 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁當前第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁
Philips Semiconductors
ISP1301
USB OTG transceiver
Product data
Rev. 01 — 14 April 2004
10 of 46
9397 750 11355
Koninklijke Philips Electronics N.V. 2004. All rights reserved.
8.9.5
OE_N/INT_N
Pin OE_N/INT_N is normally an input to the ISP1301.
When bit TRANSP_EN
=
0 and bit UART_EN = 0, the OE_N/INT_N pin controls the
direction of DAT/VP, SE0/VM, DP and DM as indicated in
Table 4
.
When suspended (either pin SUSPEND = HIGH or bit SUSPEND_REG = 1) and bit
OE_INT_EN = 1, pin OE_N/INT_N becomes a push-pull output (active LOW) to
indicate the interrupt condition.
8.9.6
SE0/VM, DAT/VP, RCV, VM and VP
The ISP1301 transmits USB data on the USB line under the following conditions:
Bit TRANSP_EN
=
0
Bit UART_EN = 0
Pin OE_N/INT_N
=
LOW.
Table 10
shows the operation of the SE0/VM and DAT/VP pins during the transmit
operation. The RCV pin is not used during transmit.
The ISP1301 receives USB data from the USB line under the following conditions:
Bit TRANSP_EN
=
0
Bit UART_EN = 0
Pin OE_N/INT_N
=
HIGH.
Table 12
shows the operation of the SE0/VM, DAT/VP and RCV pins during the
receive operation.
The VP and VM pins are single-ended receiver outputs of the DP and DM pins,
respectively.
8.9.7
DP and DM
The DP (data plus) and DM (data minus) pins implement the USB data signals. When
in the transparent general-purpose buffer mode, the ISP1301 operates as a level
shifter between the (DAT/VP, SE0/VM) and (DP, DM) pins.
8.9.8
ID
The ID (identification) pin is connected to the ID pin on the USB mini receptacle. An
internal pull-up resistor (to V
REG(3V3)
) is connected to this pin. When bit
ID_PULLDOWN is set, the ID pin will be shorted to ground.
8.9.9
V
BUS
This pin acts as an input to the V
BUS
comparator or an output from the charge pump.
When the VBUS_DRV bit of the OTG Control register is asserted, the ISP1301 tries
to drive V
BUS
to a voltage of 4.4 V to 5.25 V with an output current capability of at
least 8 mA.
相關PDF資料 |
PDF描述 |
|---|---|
| ISP1301BS | Universal Serial Bus On-The-Go transceiver |
| ISP1362 | Single-chip Universal Serial Bus On-The-Go controller |
| ISP1362BD | Single-chip Universal Serial Bus On-The-Go controller |
| ISP1362EE | Single-chip Universal Serial Bus On-The-Go controller |
| ISP1501 | Hi-Speed Universal Serial Bus peripheral transceiver |
相關代理商/技術參數 |
參數描述 |
|---|---|
| ISP1301BS | 功能描述:IC USB OTG TRANSCEIVER 24-HVQFN RoHS:是 類別:集成電路 (IC) >> 接口 - 驅動器，接收器，收發器 系列:- 標準包裝:1,000 系列:- 類型:收發器 驅動器/接收器數:2/2 規程:RS232 電源電壓:3 V ~ 5.5 V 安裝類型:表面貼裝 封裝/外殼:16-SOIC（0.295"，7.50mm 寬） 供應商設備封裝:16-SOIC 包裝:帶卷 (TR) |
| ISP1301BS,115 | 功能描述:射頻收發器 USB OTG TRANSCEIVER RoHS:否 制造商:Atmel 頻率范圍:2322 MHz to 2527 MHz 最大數據速率:2000 Kbps 調制格式:OQPSK 輸出功率:4 dBm 類型: 工作電源電壓:1.8 V to 3.6 V 最大工作溫度:+ 85 C 接口類型:SPI 封裝 / 箱體:QFN-32 封裝:Tray |
| ISP1301BS,118 | 功能描述:射頻收發器 DO NOT USE ORDER -G OR -S PART RoHS:否 制造商:Atmel 頻率范圍:2322 MHz to 2527 MHz 最大數據速率:2000 Kbps 調制格式:OQPSK 輸出功率:4 dBm 類型: 工作電源電壓:1.8 V to 3.6 V 最大工作溫度:+ 85 C 接口類型:SPI 封裝 / 箱體:QFN-32 封裝:Tray |
| ISP1301BS,151 | 功能描述:射頻收發器 USB OTG TRANSCEIVER RoHS:否 制造商:Atmel 頻率范圍:2322 MHz to 2527 MHz 最大數據速率:2000 Kbps 調制格式:OQPSK 輸出功率:4 dBm 類型: 工作電源電壓:1.8 V to 3.6 V 最大工作溫度:+ 85 C 接口類型:SPI 封裝 / 箱體:QFN-32 封裝:Tray |
| ISP1301BS,157 | 功能描述:射頻收發器 DO NOT USE ORDER -G OR -S PART RoHS:否 制造商:Atmel 頻率范圍:2322 MHz to 2527 MHz 最大數據速率:2000 Kbps 調制格式:OQPSK 輸出功率:4 dBm 類型: 工作電源電壓:1.8 V to 3.6 V 最大工作溫度:+ 85 C 接口類型:SPI 封裝 / 箱體:QFN-32 封裝:Tray |
發布緊急采購，3分鐘左右您將得到回復。