欧美成人免费电影,国产欧美一区二区三区精品酒店,精品国产a毛片,色网在线免费观看

參數資料
型號: ISP1760
廠商: NXP Semiconductors N.V.
英文描述: Hi-Speed Universal Serial Bus host controller for embedded applications
中文描述: 高速嵌入式應用的通用串行總線主控制器
文件頁數: 59/105頁
文件大小: 449K
代理商: ISP1760
9397 750 13257
Koninklijke Philips Electronics N.V. 2004. All rights reserved.
Product data sheet
Rev. 01 — 8 November 2004
59 of 105
Philips Semiconductors
ISP1760
Embedded Hi-Speed USB host controller
Table 65:
Bit
DW7
63 to 32
DW6
31 to 0
DW5
63 to 32
DW4
31 to 6
5
High-speed bulk IN and OUT, QHA: bit description
Symbol
Access
Description
reserved
-
-
reserved
-
-
reserved
-
-
reserved
J
-
SW —
writes
0; not applicable for QHA.
Jump
:
0 —
To increment the PTD pointer
1 —
To enable the next PTD branching.
Next PTD Counter
: Next PTD branching assigned by the PTD pointer.
4 to 0
NextPTDPointer
[4:0]
SW —
writes
DW3
63
A
SW —
sets
HW —
resets
HW —
writes
HW —
writes
Active
: Write the same value as that in V.
62
61
H
B
Halt
: This bit correspond to the Halt bit of the Status field of QH.
Babble
: This bit correspond to the Babble Detected bit in the Status
field of the iTD, SiTD or QH.
1 —
When babbling is detected, A and V are set to 0.
Error
: This bit corresponds to the Transaction Error bit in the Status
field of iTD, SiTD or QH (Exec_Trans, the signal name is xacterr).
0 —
No PID error.
1 —
If there are PID errors, this bit is set active. The A and V bits are
also set to inactive. This transaction is retried three times.
-
Ping
: For high-speed transactions, this bit corresponds to the Ping
state bit in the Status field of a QH.
0 —
Ping is not set.
1 —
Ping is set.
Software sets this bit to 0.
Data Toggle
: This bit is filled by software to start a PTD. If
NrBytesToTransfer[14:0] is not complete, software needs to read this
value and then write back the same value to continue.
Error Counter
. This field corresponds to the Cerr[1:0] field in QH. The
default value of this field is zero for isochronous transactions.
00 —
The transaction will not retry.
11 —
The transaction will retry three times. Hardware will decrement
these values. When the transaction has tried three times, X error will
be updated.
NAK Counter
. This field corresponds to the NAKCnt field in QH.
Software writes for the initial PTD launch. The V bit is reset if NakCnt
decrements to zero and RL is a non-zero value. It reloads from RL if
transaction is ACKed.
-
60
X
HW —
writes
59
58
reserved
P
-
HW —
writes
57
DT
HW —
updates
SW —
writes
56 to 55
Cerr[1:0]
HW —
writes
SW —
writes
54 to 51
NakCnt[3:0]
HW —
writes
SW —
writes
50 to 47
reserved
-
相關PDF資料
PDF描述
ISP1761 Hi-Speed Universal Serial Bus On-The-Go controller
ISP1761BE Hi-Speed Universal Serial Bus On-The-Go controller
ISP1761ET Hi-Speed Universal Serial Bus On-The-Go controller
ISP2100A Telecommunication IC
ISP2100BN4 Microprocessor
相關代理商/技術參數
參數描述
ISP1760BE 制造商:NXP Semiconductors 功能描述:CONTROLLER USB HOST SMD LQFP128 制造商:ST-Ericsson 功能描述:IC CONTROLLER USB HOST 128LQFP
ISP1760BE,518 功能描述:輸入/輸出控制器接口集成電路 USB HOST CONTROLLER RoHS:否 制造商:Silicon Labs 產品: 輸入/輸出端數量: 工作電源電壓: 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 安裝風格:SMD/SMT 封裝 / 箱體:QFN-64 封裝:Tray
ISP1760BE,551 功能描述:輸入/輸出控制器接口集成電路 USB HS HOST CONTRLLR RoHS:否 制造商:Silicon Labs 產品: 輸入/輸出端數量: 工作電源電壓: 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 安裝風格:SMD/SMT 封裝 / 箱體:QFN-64 封裝:Tray
ISP1760BE,557 功能描述:USB 接口集成電路 DO NOT USE ORDER -S OR -T PART RoHS:否 制造商:Cypress Semiconductor 產品:USB 2.0 數據速率: 接口類型:SPI 工作電源電壓:3.15 V to 3.45 V 工作電源電流: 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:WLCSP-20
ISP1760BE518 制造商:ST-Ericsson 功能描述:IC CONTROLLER USB HOST 128LQFP
主站蜘蛛池模板: 合肥市| 湘西| 都兰县| 瓮安县| 来安县| 共和县| 哈巴河县| 湖州市| 富阳市| 宁强县| 荃湾区| 五峰| 清水河县| 太和县| 平远县| 竹山县| 花莲市| 洱源县| 大余县| 新巴尔虎右旗| 金湖县| 自治县| 望都县| 万源市| 胶州市| 盐池县| 丰顺县| 高安市| 江陵县| 高台县| 寿阳县| 鄯善县| 土默特左旗| 潢川县| 岳阳市| 景德镇市| 都匀市| 丹棱县| 和龙市| 酉阳| 西充县|