- 您現在的位置：買賣IC網 > PDF目錄361024 > LM2421 (National Semiconductor Corporation) Monolithic Triple Channel HDTV Driver PDF資料下載
參數資料
| 型號： | LM2421 |
| 廠商： | National Semiconductor Corporation |
| 英文描述： | Monolithic Triple Channel HDTV Driver |
| 中文描述： | 單片驅動三高清晰度電視頻道 |
| 文件頁數： | 8/13頁 |
| 文件大小： | 998K |
| 代理商： | LM2421 |
Application Hints
(Continued)
NSC DEMONSTRATION BOARD
Figure 13 shows the routing and component placement on
the NSC LM126X/2421 demonstration board. The schematic
of the board is shown in Figure 11 and Figure 12 This board
provides a good example of a layout that can be used as a
guide for future layouts. Note the location of the following
components:
C19—V
bypass capacitor, located very close to pin 6
and ground pins
C20—V
bypass capacitors, located close to pin 10
and ground
C46, C47, C48—V
bypass capacitors, near LM2421
and V
CC
clamp diodes. Very important for arc protection.
The routing of the LM2421 outputs to the CRT is very critical
to achieving optimum performance. Figure 14 shows the
routing and component placement from pin 1 of the LM2421
to the blue cathode. Note that the components are placed so
that they almost line up from the output pin of the LM2421 to
the blue cathode pin of the CRT connector. This is done to
minimize the length of the video path between these two
components. Note also that D8, D9, R24 and D6 are placed
to minimize the size of the video nodes that they are at-
tached to. This minimizes parasitic capacitance in the video
path and also enhances the effectiveness of the protection
diodes. The anode of protection diode D8 is connected
directly to a section of the the ground plane that has a short
and direct path to the LM2421 ground pins. The cathode of
D9 is connected to V
very close to decoupling capacitor
C48 (see Figure 14) which is connected to the same section
of the ground plane as D8. The diode placement and routing
is very important for minimizing the voltage stress on the
LM2421 during an arcover event. Lastly, notice that S3 is
placed very close to the blue cathode and is tied directly to
CRT ground.
L
www.national.com
8
相關PDF資料 |
PDF描述 |
|---|---|
| LM2476 | Monolithic Triple Channel 6.5 ns High Gain CRT Driver and Bias Clamp |
| LM2480 | RES 91 OHM 1/2W 5% CARBON FILM |
| LM2480NA | RES 9.1K OHM 1/2W 5% CARBON FILM |
| LM24 | Monolithic Triple 9.5 ns CRT Driver |
| LM2409 | Monolithic Triple 9.5 ns CRT Driver |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LM242-155.52M | 制造商:CONNOR-WINFIELD 制造商全稱:Connor-Winfield Corporation 功能描述:5.0x7.0mm Surface Mount LVDS Clock Oscillator Series |
| LM2421AT WAF | 制造商:Texas Instruments 功能描述: |
| LM2421TA | 制造商:NSC 制造商全稱:National Semiconductor 功能描述:Monolithic Triple Channel HDTV Driver |
| LM2422 | 制造商:NSC 制造商全稱:National Semiconductor 功能描述:220V Monolithic Triple Channel 30 MHz CRT DTV Driver |
| LM2422_0505 | 制造商:NSC 制造商全稱:National Semiconductor 功能描述:220V Monolithic Triple Channel 30 MHz CRT DTV Driver |
發布緊急采購，3分鐘左右您將得到回復。