- 您現在的位置：買賣IC網 > Datasheet目錄41 > LT3507HUHF#TRPBF (Linear Technology)IC REG QD BUCK/LINEAR 38-QFN Datasheet資料下載
參數資料
| 型號： | LT3507HUHF#TRPBF |
| 廠商： | Linear Technology |
| 文件頁數： | 7/28頁 |
| 文件大小： | 302K |
| 描述： | IC REG QD BUCK/LINEAR 38-QFN |
| 產品培訓模塊： | More Information on LDOs |
| 標準包裝： | 2,500 |
| 拓撲： | 降壓（降壓）（1），線性（LDO）（1） |
| 功能： | 任何功能 |
| 輸出數： | 4 |
| 頻率 - 開關： | 900kHz ~ 1.1MHz |
| 電壓/電流 - 輸出 1： | 0.8 V ~ 32.4 V，2.4A |
| 電壓/電流 - 輸出 2： | 0.8 V ~ 32.4 V，1.5A |
| 電壓/電流 - 輸出 3： | 0.8 V ~ 32.4 V，1.5A |
| 帶 LED 驅動器： | 無 |
| 帶監控器： | 無 |
| 帶序列發生器： | 是 |
| 電源電壓： | 4 V ~ 36 V |
| 工作溫度： | -40°C ~ 150°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 38-WFQFN 裸露焊盤 |
| 供應商設備封裝： | 38-QFN（5x7） |
| 包裝： | 帶卷 (TR) |
第1頁第2頁第3頁第4頁第5頁第6頁當前第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁
LT3507
7
3507fa
PIN FUNCTIONS
BOOST1, BOOST2, BOOST3 (Pins 1, 27, 32): The BOOST
pins are used to provide drive voltages, higher than the
input voltage, to the internal bipolar NPN power switches.
These pins must be tied through a diode from V
OUT
, V
IN
or another supply greater than 2.5V.
V
IN1
(Pins 2, 3): The V
IN1
pins supply power to the internal
switch of the 2.4A regulator and to the LT3507s internal
reference and start-up circuitry. These pins must be locally
bypassed (Note 6).
V
INSW
(Pin 4): The V
INSW
pin is a switched V
IN1
for the
user programmable undervoltage and overvoltage detec-
tion. It is connected to V
IN1
when any of the RUN pins
are pulled high, and high impedance when all RUN pins
are low or open.
OVLO (Pin 5): The LT3507 goes into overvoltage shutdown
when this pin goes above 1.2V. If unused, the OVLO pin
should be tied to GND.
UVLO (Pin 6): The LT3507 goes into undervoltage shutdown
when this pin drops below 1.2V. If unused, the UVLO pin
should be tied to V
INSW
.
V
C1
, V
C2
, V
C3
(Pins 7, 23, 19): The V
C
pins are the outputs
of the internal error amps. The voltages on these pins
control the peak switch currents. These pins are normally
used to compensate the control loops. Each switching
regulator can be shut down by pulling its respective V
C
pin to ground with an NMOS or NPN transistor.
TRK/SS1, TRK/SS2, TRK/SS3, TRK/SS4 (Pins 8, 21, 18,
26): The TRK/SS pins allow a regulator to track the output
of another regulator. When the TRK/SS pin is below 0.8V,
the FB pin regulates to the TRK/SS voltage. This pin can
also be used as a soft-start by connecting a capacitor from
TRK/SS to ground. The TRK/SS pins should be left open
if neither feature is used.
FB1, FB2, FB3 (Pins 9, 22, 20): The FB pins are the nega-
tive inputs of the error ampli ers. The LT3507 regulates
each feedback pin to the lesser of 0.8V or the TRK/SS
pin voltage. Connect the feedback resistor divider taps
to these pins.
Note 6: V
INX
pins that are connected together may share a bypass capacitor.
PGOOD1, PGOOD2, PGOOD3 (Pins 10, 11, 12): The
PGOOD pins are the open-collector outputs of an internal
comparator. PGOOD remains low until the FB pin is within
10% of the nal regulation voltage. As well as indicating
output regulation, the PGOOD pins can sequence the
switching regulators. These pins must be left unconnected
if unused. The PGOOD outputs are valid when V
IN
is greater
than 3.5V and any of the RUN pins are high. They are not
valid when all RUN pins are low.
R
T
/SYNC (Pin 13): The R
T
/SYNC pin requires a resistor
to ground or a clock signal to set the operating frequency
of the LT3507.
RUN1, RUN2, RUN3 (Pins 14, 15, 16): The RUN pins are
used to shut down the individual switching regulators.
When all three RUN pins are low, the LT3507 shuts down
and draws less than 1糀 from V
IN1
.
BIAS (Pin 17): The BIAS pin supplies the current to the
LT3507s internal regulator. This pin should be tied to the
lowest available voltage source above 3V (either V
IN
, V
OUT
or any other available supply). The LDO pass transistors
base current is supplied from the BIAS pin if it is at least
0.8V above the LDO DRIVE output.
DRIVE (Pin 24): The DRIVE pin provides the base drive for
an external NPN transistor used for the LDO regulator.
FB4 (Pin 25): The FB4 pin is the negative input to the LDO
error ampli er. It is regulated to 0.8V through the LDO
feedback resistor divider.
V
IN2
(Pins 30, 31)/V
IN3
(Pins 35, 36 ): The V
IN2
and V
IN3
pins supply power to the internal switches of the 1.5A con-
verters. These pins must be locally bypassed (Note 6).
SW1 (Pins 37, 38)/SW2 (Pins 28, 29)/SW3 (Pins 33,
34): The SW pins are the outputs of the internal power
switches. Connect these pins to the inductors and switch-
ing diodes.
Exposed Pad (Pin 39): Ground. The underside Exposed
Pad metal of the package provides both electrical contact
to ground and good thermal contact to the printed circuit
board. The Exposed Pad must be soldered to a grounded
pad on the circuit board for proper operation.
相關PDF資料 |
PDF描述 |
|---|---|
| LT3570IFE#TRPBF | IC REG BUCK/BST/LINEAR 20TSSOP |
| LT3645HMSE#TRPBF | IC REG DL BUCK/LINEAR 12-MSOP |
| LT3694IFE-1#TRPBF | IC REG TRPL BUCK/LINEAR 20TSSOP |
| LT4220IGN#TR | IC CTLR HOTSWAP DUAL 16-SSOP |
| LT4250LCN8 | IC CONTRLR HOT SWAP NEG 48V 8DIP |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LT3507IUHF#PBF | 功能描述:IC REG QD BUCK/LINEAR 38-QFN RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - 線性 + 切換式 系列:- 標準包裝:2,500 系列:- 拓撲:降壓（降壓）同步（3），線性（LDO）（2） 功能:任何功能 輸出數:5 頻率 - 開關:300kHz 電壓/電流 - 輸出 1:控制器 電壓/電流 - 輸出 2:控制器 電壓/電流 - 輸出 3:控制器 帶 LED 驅動器:無 帶監控器:無 帶序列發生器:是 電源電壓:5.6 V ~ 24 V 工作溫度:-40°C ~ 85°C 安裝類型:* 封裝/外殼:* 供應商設備封裝:* 包裝:* |
| LT3507IUHF#TRPBF | 功能描述:IC REG QD BUCK/LINEAR 38-QFN RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - 線性 + 切換式 系列:- 標準包裝:2,500 系列:- 拓撲:降壓（降壓）同步（3），線性（LDO）（2） 功能:任何功能 輸出數:5 頻率 - 開關:300kHz 電壓/電流 - 輸出 1:控制器 電壓/電流 - 輸出 2:控制器 電壓/電流 - 輸出 3:控制器 帶 LED 驅動器:無 帶監控器:無 帶序列發生器:是 電源電壓:5.6 V ~ 24 V 工作溫度:-40°C ~ 85°C 安裝類型:* 封裝/外殼:* 供應商設備封裝:* 包裝:* |
| LT3507IUHFPBF | 制造商:Linear Technology 功能描述:Triple Voltage Regulator QFN38EP |
| LT3507IUHF-PBF | 制造商:LINER 制造商全稱:Linear Technology 功能描述:Triple Monolithic Step-Down Regulator with LDO |
| LT3507IUHF-TRPBF | 制造商:LINER 制造商全稱:Linear Technology 功能描述:Triple Monolithic Step-Down Regulator with LDO |
發布緊急采購，3分鐘左右您將得到回復。