- 您現在的位置：買賣IC網 > Datasheet目錄41 > LTC3541EDD#TRPBF (Linear Technology)IC REG DL BCK/LINEAR SYNC 10-DFN Datasheet資料下載
參數資料
| 型號： | LTC3541EDD#TRPBF |
| 廠商： | Linear Technology |
| 文件頁數： | 13/20頁 |
| 文件大小： | 368K |
| 描述： | IC REG DL BCK/LINEAR SYNC 10-DFN |
| 產品培訓模塊： | More Information on LDOs |
| 標準包裝： | 2,500 |
| 拓撲： | 降壓（降壓）同步（1），線性（LDO）（1） |
| 功能： | 任何功能 |
| 輸出數： | 2 |
| 頻率 - 開關： | 2.25MHz |
| 電壓/電流 - 輸出 1： | 0.8 V ~ 5 V，500mA |
| 電壓/電流 - 輸出 2： | 0.4 V ~ 4.1 V，300mA |
| 帶 LED 驅動器： | 無 |
| 帶監控器： | 無 |
| 帶序列發生器： | 是 |
| 電源電壓： | 0.9 V ~ 5.5 V |
| 工作溫度： | -40°C ~ 85°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 10-WFDFN 裸露焊盤 |
| 供應商設備封裝： | 10-DFN（3x3） |
| 包裝： | 帶卷 (TR) |
LTC3541
3541fa
PPLICATIO S I FOR ATIO
U
U
resistance of C
OUT
. 擨
LOAD
also begins to charge or dis-
charge C
OUT
, which generates a feedback error signal. The
regulator loop then acts to return V
OUT
to its steady-state
value. During this recovery time V
OUT
can be monitored
for overshoot or ringing that would indicate a stability
problem. For a detailed explanation of switching control
loop theory see Application Note 76.
A second, more severe transient is caused by switching
in loads with large (>1礔) supply bypass capacitors. The
discharged bypass capacitors are effectively put in paral-
lel with C
OUT
, causing a rapid drop in V
OUT
. No regulator
can deliver enough current to prevent this problem if the
load switch resistance is low and it is driven quickly. The
only solution is to limit the rise time of the switch drive
so that the load rise time is limited to approximately
(25 " C
LOAD
). Thus, a 10礔 capacitor charging to 3.3V
would require a 250祍 rise time, limiting the charging
current to about 130mA.
VLDO/LINEAR REGULATOR
Adjustable Output Voltage
The LTC3541 LV
OUT
output voltage is set by the ratio of two
external resistors as shown in Figure 7. The device servos
LV
OUT
to maintain the LFB pin voltage at 0.4V (referenced
to ground). Thus, the current in R1 is equal to 0.4V/R1.
For good transient response, stability, and accuracy, the
current in R1 should be at least 2礎, thus the value of
R1 should be no greater than 200k. The current in R2 is
the current in R1 plus the LFB pin bias current. Since the
LFB pin bias current is typically <10nA, it can be ignored
in the output voltage calculation. The output voltage can
be calculated using the formula in Figure 8. Note that in
shutdown the output is turned off and the divider current
will be zero once C
OUT
is discharged.
The LTC3541 VLDO and linear regulator loops operate
at a relatively high gain of 3.5礦/mA and 3.4礦/mA
respectively, referred to the LFB input. Thus, a load cur-
rent change of 1mA to 300mA produces a 1.05mV drop
at the LFB input for the VLDO and a load current change
of 1mA to 30mA produces a 0.1mV drop at the LFB input
for the linear regulator. To calculate the change referred
to the output simply multiply by the gain of the feedback
network (i.e., 1 + R2/R1). For example, to program the
output for 1.2V choose R2/R1 = 2. In this example, an
output current change of 1mA to 300mA produces 1.05mV
" (1 + 2) = 3.15mV drop at the output.
Since the LFB pin is relatively high impedance (depending
on the resistor divider used), stray capacitance at this pin
should be minimized (<10pF) to prevent phase shift in the
error amplifier loop. Additionally, special attention should
be given to any stray capacitances that can couple external
signals onto the LFB pin producing undesirable output
ripple. For optimum performance connect the LFB pin to
R1 and R2 with a short PCB trace and minimize all other
stray capacitance to the LFB pin.
Output Capacitance and Transient Response
The LTC3541 is designed to be stable with a wide range of
ceramic output capacitors. The ESR of the output capaci-
tor affects stability, most notably with small capacitors.
A minimum output capacitor of 2.2礔 with an ESR of
0.05?or less is recommended to ensure stability. The
LTC3541 VLDO is a micropower device and output tran-
sient response will be a function of output capacitance.
Larger values of output capacitance decrease the peak
deviations and provide improved transient response for
larger load current changes. Note that bypass capacitors
used to decouple individual components powered by the
LTC3541 will increase the effective output capacitor value.
High ESR tantalum and electrolytic capacitors may be used,
but a low ESR ceramic capacitor must be in parallel at the
output. There is no minimum ESR or maximum capacitor
size requirement.
Figure 7. Programming the LTC3541
( )
LV
OUT
R1
R2
LTc3541
c
OUT
R2
R1
V
OUT
= 0.4V 1 +
LFB
GND
相關PDF資料 |
PDF描述 |
|---|---|
| LTC3670EDDB#TRPBF | IC REG TRPL BCK/LINEAR 12DFN |
| LTC3672BEDC-1#TRPBF | IC REG TRPL BCK/LINEAR 8-DFN |
| LTC3700EMS#TRPBF | IC REG DL BUCK/LINEAR 10MSOP |
| LTC4151HMS#TRPBF | IC PWR MONITOR MS 80V SD 10MSOP |
| LTC4210-2CS6#TRM | IC CONTROLLER HOT SWAP TSOT23-6 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LTC3542 | 制造商:LINER 制造商全稱:Linear Technology 功能描述:500mA, 2.25MHz Synchronous Step-Down DC/DC Converter |
| LTC3542-1 | 制造商:LINER 制造商全稱:Linear Technology 功能描述:500mA, 2.25MHz 2.8V Output Synchronous Step-Down DC/DC Converter |
| LTC3542EDC#PBF | 制造商:Linear Technology 功能描述:DC-DC CONVERTER BUCK 2.25MHZ 制造商:Linear Technology 功能描述:DC-DC CONVERTER, BUCK, 2.25MHZ, 500mA, DFN-6; Primary Input Voltage:5.5V; No. of Outputs:1; Output Current:500mA; No. of Pins:6; Operating Temperature Min:-40C; Operating Temperature Max:85C; Package / Case:6-DFN ;RoHS Compliant: Yes |
| LTC3542EDC#TRMPBF | 功能描述:IC REG BUCK SYNC ADJ 0.5A 6DFN RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 開關穩壓器 系列:- 產品培訓模塊:High Efficiency Current Mode Switching Regulators CMOS LDO Regulators 特色產品:BD91x Series Step-Down Regulators 標準包裝:2,500 系列:- 類型:降壓（降壓） 輸出類型:兩者兼有 輸出數:2 輸出電壓:3.3V，0.8 V ~ 2.5 V 輸入電壓:4.5 V ~ 5.5 V PWM 型:電流模式 頻率 - 開關:1MHz 電流 - 輸出:1.5A 同步整流器:是 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:20-VFQFN 裸露焊盤 包裝:帶卷 (TR) 供應商設備封裝:VQFN020V4040 產品目錄頁面:1373 (CN2011-ZH PDF) 其它名稱:BD9152MUV-E2TR |
| LTC3542EDC#TRPBF | 功能描述:IC REG BUCK SYNC ADJ 0.5A 6DFN RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 開關穩壓器 系列:- 標準包裝:500 系列:- 類型:切換式電容器（充電泵），反相 輸出類型:固定 輸出數:1 輸出電壓:-3V 輸入電壓:2.3 V ~ 5.5 V PWM 型:Burst Mode? 頻率 - 開關:900kHz 電流 - 輸出:100mA 同步整流器:無 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:SOT-23-6 細型，TSOT-23-6 包裝:帶卷 (TR) 供應商設備封裝:TSOT-23-6 其它名稱:LTC1983ES6-3#TRMTR |
發布緊急采購，3分鐘左右您將得到回復。