欧美成人免费电影,国产欧美一区二区三区精品酒店,精品国产a毛片,色网在线免费观看

參數資料
型號: MC68HC11A8BVP2
廠商: MOTOROLA INC
元件分類: 微控制器/微處理器
英文描述: HCMOS Single-Chip Microcontroller
中文描述: 8-BIT, MROM, 2 MHz, MICROCONTROLLER, PDIP48
封裝: DIP-48
文件頁數: 84/158頁
文件大小: 776K
代理商: MC68HC11A8BVP2
MOTOROLA
9-4
RESETS, INTERRUPTS, AND LOW POWER MODES
MC68HC11A8
TECHNICAL DATA
9
9.1.2.5 Real-Time Interrupt
The real time interrupt flag is cleared and automatic hardware interrupts are masked.
The rate control bits are cleared after reset and may be initialized by software before
the real time interrupt system is used.
9.1.2.6 Pulse Accumulator
The pulse accumulator system is disabled at reset so that the PAI input pin defaults to
being a general purpose input pin.
9.1.2.7 COP
The COP watchdog system is enabled if the NOCOP control bit in the system config-
uration control register (EEPROM cell) is clear, and disabled if NOCOP is set. The
COP rate is set for the shortest duration timeout.
9.1.2.8 SCI Serial l/O
The reset condition of the SCI system is independent of the operating mode. At reset,
the SCI baud rate is indeterminate and must be established by a software write to the
BAUD register. All transmit and receive interrupts are masked and both the transmitter
and receiver are disabled so the port pins default to being general purpose l/O lines.
The SCI frame format is initialized to an 8-bit character size. The send break and re-
ceiver wake up functions are disabled. The TDRE and TC status bits in the SCI status
register are both set, indicating that there is no transmit data in either the transmit data
register or the transmit serial shift register. The RDRF, IDLE, OR, NF, and FE receive-
related status bits are all cleared.
Note that upon reset in special bootstrap mode execution begins in the 192 byte boot
ROM. This firmware sets port D to wire-OR mode, establishes a baud rate, and en-
ables the SCI receiver and transmitter.
9.1.2.9 SPI Serial l/O
The SPI system is disabled by reset. The port pins associated with this function default
to being general purpose l/O lines.
9.1.2.10 A/D Converter
The A/D converter system configuration is indeterminate after reset. The conversion
complete flag is cleared by reset. The ADPU bit is cleared by reset thus disabling the
A/D system.
9.1.2.11 System
The EEPROM programming controls are all disabled so the memory system is config-
ured for normal read operation. The highest priority I interrupt defaults to being the ex-
ternal IRQ pin by PSEL[3:0] equal to 0:1:0:1. The IRQ interrupt pin is configured for
level sensitive operation (for wire-OR systems). The RBOOT, SMOD, and MDA bits in
the HPRIO register reflect the status of the MODB and MODA inputs at the rising edge
相關PDF資料
PDF描述
MC68HC11A1CFN2 HCMOS Single-Chip Microcontroller
MC68HCP11A1CFN2 HCMOS Single-Chip Microcontroller
MC68HCP11A1CFN3 HCMOS Single-Chip Microcontroller
MC68HCP11A1CP2 HCMOS Single-Chip Microcontroller
MC68HCP11A1CP3 HCMOS Single-Chip Microcontroller
相關代理商/技術參數
參數描述
MC68HC11A8FN 制造商:FREESCALE 制造商全稱:Freescale Semiconductor, Inc 功能描述:8-Bit Microcontrollers
MC68HC11A8FN1 制造商:Motorola Inc 功能描述:
MC68HC11A8MCFN2 制造商:MOTOROLA 制造商全稱:Motorola, Inc 功能描述:HCMOS Single-Chip Microcontroller
MC68HC11A8P1 制造商:Rochester Electronics LLC 功能描述:- Bulk
MC68HC11A8TS 制造商:MOTOROLA 制造商全稱:Motorola, Inc 功能描述:8-Bit Microcontrollers
主站蜘蛛池模板: 承德市| 临清市| 郑州市| 深水埗区| 仪征市| 桂平市| 清镇市| 三江| 沧源| 东乡族自治县| 吉木乃县| 辽宁省| 财经| 乌鲁木齐县| 屏南县| 维西| 荆门市| 涟水县| 荣成市| 浦江县| 安塞县| 孟州市| 无极县| 云浮市| 平谷区| 蓝山县| 拉孜县| 丹东市| 黄骅市| 龙游县| 桦南县| 张家港市| 沙河市| 阿图什市| 河间市| 大方县| 莆田市| 庄河市| 弥渡县| 沙坪坝区| 新乐市|