- 您現在的位置：買賣IC網 > PDF目錄16759 > MCZ33742EG (Freescale Semiconductor)IC SYSTEM BASIS CHIP CAN 28-SOIC PDF資料下載
參數資料
| 型號： | MCZ33742EG |
| 廠商： | Freescale Semiconductor |
| 文件頁數： | 21/71頁 |
| 文件大小： | 0K |
| 描述： | IC SYSTEM BASIS CHIP CAN 28-SOIC |
| 標準包裝： | 26 |
| 應用： | 自動 |
| 電流 - 電源： | 42mA |
| 電源電壓： | 5.5 V ~ 18 V |
| 工作溫度： | -40°C ~ 125°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 28-SOIC（0.295"，7.50mm 寬） |
| 供應商設備封裝： | 28-SOIC W |
| 包裝： | 管件 |
| 產品目錄頁面： | 808 (CN2011-ZH PDF) |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁當前第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁
Analog Integrated Circuit Device Data
28
Freescale Semiconductor
33742
FUNCTIONAL DEVICE OPERATION
OPERATIONAL MODES
NORMAL REQUEST ENTERED AND NO WATCHDOG CONFIGURATION OCCURS
If the Normal Request mode is entered after the SBC powers up or after a wake-up from Stop mode and no watchdog
configuration occurs before the 350 ms time period has expired, the device enters the Reset mode. If no watchdog configuration
is performed, the 33742 will cycle from the Normal Request mode to Reset mode to Normal Request mode.
If the Normal Request mode is entered after a wake-up from Sleep mode, and no watchdog configuration occurs while the
33742S is in Normal Request mode, the SBC returns to the Sleep mode.
APPLICATION WAKE-UP FROM THE 33742
When the application is in Stop mode, it can be awakened from the SBC side. When a wake-up condition is detected by the
SBC (for example, CAN, wake-up input), the 33742 enters the Normal Request mode and generates an interrupt pulse at the
INT pin.
Table 7. Table of Operations
Mode
Voltage Regulator
HS Switch
Wake-up
Capabilities
(if Enabled)
RST Pin
INT Pin
Watchdog
Software
CAN Cell
Normal
Request
VDD: ON,
V2: OFF,
HS: OFF
–
Low for tRSTDUR time,
then HIGH
–
Normal
VDD: ON,
V2: ON,
HS: Controllable
–
Normally HIGH.
Active LOW if WDOG
or VDD under-voltage
occurs
If enabled, signal
failure (VDD
Pre-warning
Temp, CAN, HS)
Running
TXD/RXD
Standby
VDD: ON,
V2: OFF,
HS: Controllable
–
Same as Normal
mode
Same as Normal
mode
Running
Low power
Stop
VDD: ON
(Limited Current
Capability),
V2: OFF,
HS:OFF or Cyclic Sense
CAN, SPI, L0:L3,
Cyclic Sense,
Forced Wake-up,
Normally HIGH.
Active LOW if
WDOG(41)
or VDD under-voltage
occurs
Signal 33742S
wake-up and
IDD > IDDS-WU
(not maskable)
Running if
enabled.
Not running if
disabled
Low power.
Wake-up capability
if enabled
Sleep
VDD: OFF,
V2: OFF,
HS: OFF or Cyclic
CAN, SPI,
L0:L3, Cyclic Sense
Forced Wake-up
LOW
Not Active
Not running
Low power.
Wake-up capability
if enabled
Normal
Debug(39)
Same as Normal
–
Normally HIGH.
Active LOW if VDD
under-voltage occurs
Same as Normal
Not running
Same as Normal
Standby
Debug(39)
Same as Standby
–
Normally HIGH.
Active LOW if VDD
under-voltage occurs
Same as Standby Not running
Same as Standby
Stop
Debug(39)
Same as Stop
Normally HIGH.
Active LOW if VDD
under-voltage occurs
Same as Stop
Not running
Same as Stop
Flash
Programming
Forced externally
–
Not operating
Notes
39.
Mode entered via special sequence described under the heading Debug Mode: Hardware and Software Debug with the 33742,
beginning on page 34.
40.
IDD over-current always enabled.
41.
WDOG if enabled.
相關PDF資料 |
PDF描述 |
|---|---|
| H2MXH-1618M | DIP CABLE - HDM16H/AE16M/X |
| PCK0G331MCO1GS | CAP ALUM 330UF 4V 20% SMD |
| SDR0805-681KL | INDUCTOR POWER 680UH 10% SMD |
| AD587JR-REEL | IC VREF SERIES PREC 10V 8-SOIC |
| B82422A3151K100 | INDUCTOR .15UH 390MA 1210 10% |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MCZ33742EGR2 | 功能描述:網絡控制器與處理器 IC SBC-E-HS-CAN RoHS:否 制造商:Micrel 產品:Controller Area Network (CAN) 收發器數量: 數據速率: 電源電流（最大值）:595 mA 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:PBGA-400 封裝:Tray |
| MCZ33742SEG | 功能描述:網絡控制器與處理器 IC SBC-E-HS-CAN RoHS:否 制造商:Micrel 產品:Controller Area Network (CAN) 收發器數量: 數據速率: 電源電流（最大值）:595 mA 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:PBGA-400 封裝:Tray |
| MCZ33742SEGR2 | 功能描述:網絡控制器與處理器 IC SBC-E-HS-CAN RoHS:否 制造商:Micrel 產品:Controller Area Network (CAN) 收發器數量: 數據速率: 電源電流（最大值）:595 mA 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:PBGA-400 封裝:Tray |
| MCZ33780EG | 功能描述:多路器開關 IC DBUS MASTER RoHS:否 制造商:Texas Instruments 通道數量:1 開關數量:4 開啟電阻（最大值）:7 Ohms 開啟時間（最大值）: 關閉時間（最大值）: 傳播延遲時間:0.25 ns 工作電源電壓:2.3 V to 3.6 V 工作電源電流: 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:UQFN-16 |
| MCZ33780EG | 制造商:Freescale Semiconductor 功能描述:DUAL DBUS MASTER INTERFACE 16SOIC |
發布緊急采購，3分鐘左右您將得到回復。