- 您現在的位置：買賣IC網 > PDF目錄382381 > PCE84C886 (NXP SEMICONDUCTORS) Microcontroller for monitor OSD and auto-sync applications PDF資料下載
參數資料
| 型號： | PCE84C886 |
| 廠商： | NXP SEMICONDUCTORS |
| 元件分類： | 微控制器/微處理器 |
| 英文描述： | Microcontroller for monitor OSD and auto-sync applications |
| 中文描述： | 8-BIT, MROM, 10 MHz, MICROCONTROLLER, PDIP42 |
| 封裝： | 0.600 INCH, PLASTIC, SDIP-42 |
| 文件頁數： | 22/36頁 |
| 文件大小： | 168K |
| 代理商： | PCE84C886 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁當前第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁
1996 Feb 21
22
Philips Semiconductors
Objective specification
Microcontrollers for digital auto-sync and
VST TV controller applications
PCE84C486; PCE84C487
11 WATCHDOG TIMER (WDT)
The purpose of the Watchdog Timer is to reset the
microcontroller, within a reasonable period of time, if it
enters an erroneous processor state. Erroneous processor
states can be caused by noise or RFI.
The Watchdog Timer consists of a 23-bit counter which is
clocked at a frequency of f
osc
. During a Power-on-reset the
contents of the counter are cleared. The counter contents
are then incremented by ‘1’ every oscillator clock cycle.
If the maximum count is exceeded, the counter overflows
and the microcontroller is reset. In order to prevent a
counter overflow and its resulting reset operation, the user
program must clear the contents of the Watchdog Timer
before its maximum count is exceeded. During normal
processing, the contents of the Watchdog Timer are
cleared by writing a logic 1 to Derivative Register 45H (this
is a dummy register).
The maximum time period (t
p
) which the counter may run
and not cause a reset operation, is calculated as shown
below.
In the Idle mode the oscillator is still running and the
Watchdog Timer remains active. In the Stop mode
however, the oscillator is stopped and the operation of the
Watchdog Timer is halted but its contents are retained.
Therefore, it may be advisable for the user to clear the
contents of the Watchdog Timer before the Stop mode is
entered, in order to avoid an unexpected reset operation
after the device is woken-up.
The operational voltage range of the Watchdog Timer is
2 to 5.5 V.
t
p
f
osc
---1
2
22
×
=
Fig.20 The Watchdog Timer.
handbook, full pagewidth
Power-on-reset
WR45H
RESET
CLK
Q22
on-chip RESET
23-BIT COUNTER
fosc
MGC906
相關PDF資料 |
PDF描述 |
|---|---|
| PCF1000 | Analog IC |
| PCF600 | Analog IC |
| PCF1174C | 4-digit static LCD car clock |
| PCF1174CT | 4-digit static LCD car clock |
| PCF1174CU | 4-digit static LCD car clock |
相關代理商/技術參數 |
參數描述 |
|---|---|
| PCEA02 | 制造商:ADAM-TECH 制造商全稱:Adam Technologies, Inc. 功能描述:.100&.156 RECEPTACLE WITH BOARD HOOKS |
| PCE-A-05 | 制造商:ADAM-TECH 制造商全稱:Adam Technologies, Inc. 功能描述:.100 RECEPTACLE WITH BOARD HOOKS |
| PCEA10 | 制造商:ADAM-TECH 制造商全稱:Adam Technologies, Inc. 功能描述:.100&.156 RECEPTACLE WITH BOARD HOOKS |
| PCEA20 | 制造商:ADAM-TECH 制造商全稱:Adam Technologies, Inc. 功能描述:.100&.156 RECEPTACLE WITH BOARD HOOKS |
| PCEB02 | 制造商:ADAM-TECH 制造商全稱:Adam Technologies, Inc. 功能描述:.100&.156 RECEPTACLE WITH BOARD HOOKS |
發布緊急采購，3分鐘左右您將得到回復。