- 您現在的位置：買賣IC網 > Datasheet目錄46 > SC402BMLTRT (Semtech)IC REG DL BCK/LINEAR SYNC 32MLPQ Datasheet資料下載
參數資料
| 型號： | SC402BMLTRT |
| 廠商： | Semtech |
| 文件頁數： | 20/32頁 |
| 文件大小： | 1425K |
| 描述： | IC REG DL BCK/LINEAR SYNC 32MLPQ |
| 標準包裝： | 1 |
| 系列： | EcoSpeed®, SmartDrive™ |
| 拓撲： | 降壓（降壓）同步（1），線性（LDO）（1） |
| 功能： | 任何功能 |
| 輸出數： | 2 |
| 頻率 - 開關： | 1MHz |
| 電壓/電流 - 輸出 1： | 可調至 0.6V，10A |
| 電壓/電流 - 輸出 2： | 可調至 0.75V，200mA |
| 帶 LED 驅動器： | 無 |
| 帶監控器： | 無 |
| 帶序列發生器： | 是 |
| 電源電壓： | 3 V ~ 28 V |
| 工作溫度： | -40°C ~ 85°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 32-VFQFN 裸露焊盤 |
| 供應商設備封裝： | 32-MLPQ（5x5） |
| 包裝： | 標準包裝 |
| 其它名稱： | SC402BMLDKR |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁當前第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁
SC402B
20
through the SS pin to charge the capacitor. During the
start up process (Figure 8), 50% of the voltage at the SS
pin is used as the reference for the FB comparator. The
PWM comparator issues an on-time pulse when the
voltage at the FB pin is less than 40% of the SS pin. As a
result, the output voltage follows the SS voltage. The
output voltage reaches and maintains regulation when
the soft start voltage is > 1.5V. The time between the first
LX pulse and V
OUT
reaching regulation is the soft-start time
(t
SS
). The calculation for the soft-start time is shown by the
following equation.
A
3
V
5
.
1
C
t
SS
SS
The voltage at the SS pin continues to ramp up and eventu-
ally equals 64% of V
DD
. After the soft start completes, the FB
pin voltage is compared to an internal reference of 0.6V. The
delay time between the V
OUT
regulation point and PGOOD
going high is shown by the following equation.
A
3
)
V
5
.
1
V
64
.
0
(
C
t
DD
SS
DELAY
-
PGOOD
Figure 8 Soft-start Timing Diagram
Pre-Bias Startup
The SC402B can start up normally even when there is an
existing output voltage present. The soft start time is still
the same as normal start up (when the output voltage
starts from zero). The output voltage starts to ramp up
when 40% of the voltage at SS pin meets the existing FB
voltage level. Pre-bias startup is achieved by turning off
the lower gate when the inductor current falls below zero.
This method prevents the output voltage from
discharging.
Power Good Output
The PGOOD (power good) output is an open-drain output
which requires a pull-up resistor. When the voltage at the
FB pin is 10% below the nominal voltage, PGOOD is pulled
low. It is held low until the output voltage returns above
-8% of nominal.
PGOOD will transition low if the V
FB
pin exceeds +20% of
nominal, which is also the over-voltage shutdown thresh-
old. PGOOD also pulls low if the EN/PSV pin is low when
VDD is present.
Output Over-Voltage Protection
Over-voltage protection becomes active as soon as the
device is enabled. The threshold is set at 600mV + 20%
(720mV). When V
FB
exceeds the OVP threshold, DL latches
high and the low-side MOSFET is turned on. DL remains
high and the controller remains off, until the EN/PSV input
is toggled or VDD is cycled. There is a 5約 delay built into
the OVP detector to prevent false transitions. PGOOD is
also low after an OVP event.
Output Under-Voltage Protection
When V
FB
falls 25% below its nominal voltage (falls to
450mV) for eight consecutive clock cycles, the switcher is
shut off and the DH and DL drives are pulled low to tri-
state the MOSFETs. The controller stays off until EN/PSV is
toggled or VDD is cycled.
VDD UVLO, and POR
UVLO (Under-Voltage Lock-Out) circuitry inhibits switching
and tri-states the DH/DL drivers until VDD rises above 3.0V.
An internal POR (Power-On Reset) occurs when VDD
exceeds 3.0V, which resets the fault latch and a soft-start
counter cycle begins which prepares for soft-start. The
SC402B then begins a soft-start cycle. The PWM will shut
off if VDD falls below 2.4V.
Applications Information (continued)
相關PDF資料 |
PDF描述 |
|---|---|
| SC403MLTRT | IC REG DL BCK/LINEAR SYNC 32MLPQ |
| SC418ULTRT | IC REG DL BUCK/LINEAR 20MLPQ |
| SC424MLTRT | IC REG DL BUCK/LINEAR 28MLPQ |
| SC4250LISTRT | IC HOT SWAP CTRLR 8-SOIC |
| SC427MLTRT | IC REG DL BUCK/LINEAR 32MLPQ |
相關代理商/技術參數 |
參數描述 |
|---|---|
| SC402S | 功能描述:數據轉換模塊 SC400 4W SERIAL OEM RoHS:否 制造商:Lyrtech 產品:ADC and DAC FMC Modules 轉換速率:250 MSPS, 1 GSPS 信噪比: ADC 輸入端數量:2 DAC 輸出端數量:2 分辨率:14 bit, 16 bit 接口類型:SPI 工作電源電壓:3.3 V, 12 V 工作電源電流: 最大工作溫度: 尺寸:84 mm x 69 mm x 10 mm |
| SC403 | 制造商:SEMTECH 制造商全稱:Semtech Corporation 功能描述:6A EcoSpeedTM Integrated FET Regulator with Programmable LDO |
| SC403B | 制造商:SEMTECH 制造商全稱:Semtech Corporation 功能描述:6A EcoSpeed?? Integrated FET Regulator with Programmable LDO |
| SC403BEVB | 制造商:SEMTECH 功能描述:Evaluation Board for 10 A EcoSpeed?Integrated FET Regulator w/ Programmable LDO |
| SC403BMLTRT | 制造商:Semtech Corporation 功能描述:Integrated FET Regulator with Programmable LDO 32-Pin MLPQ T/R 制造商:Semtech Corporation 功能描述:6A EcoSpeed Integrated FET Regulator with Programmable LDO. PKG: MLPQ-32 制造商:Semtech 功能描述:Integrated FET Regulator with Programmable LDO 32-Pin MLPQ T/R 制造商:SEMTECH 功能描述:6A EcoSpeed step down regultor |
發布緊急采購，3分鐘左右您將得到回復。