- 您現在的位置：買賣IC網 > Datasheet目錄46 > SG6932SZ (Fairchild Semiconductor)IC PFC CONTROLLER CCM 16SOP Datasheet資料下載
參數資料
| 型號： | SG6932SZ |
| 廠商： | Fairchild Semiconductor |
| 文件頁數： | 5/20頁 |
| 文件大?。?/td> | 919K |
| 描述： | IC PFC CONTROLLER CCM 16SOP |
| 標準包裝： | 2,500 |
| 模式： | 連續導電（CCM） |
| 頻率 - 開關： | 65kHz |
| 電流 - 啟動： | 10µA |
| 電源電壓： | 14 V ~ 20 V |
| 工作溫度： | -40°C ~ 85°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 16-SOIC（0.154"，3.90mm 寬） |
| 供應商設備封裝： | 16-SOIC |
| 包裝： | 帶卷 (TR) |
?2007 Fairchild Semiconductor Corporation
www.fairchildsemi.com
SG6932 " Rev. 1.1.3
5
Pin Definitions
Pin # Name Description
1
VRMS
Line-Voltage Detection. The pin is used for PFC multiplier and brownout protection.
2
RI
Oscillator Setting. One resistor connected between RI and ground determines the switching
frequency. A resistor with resistance between 12 ~ 47k& is recommended. The switching
frequency is equal to [1560 / R
I
]kHz, where R
I
is in k? For example, if R
I
is 24k? the
switching frequency is 65kHz.
3
IEA
Output of PFC Current Amplifier. The signal from this pin is compared with an internal
sawtooth to determine the pulsewidth for PFC gate drive.
4
IPFC
Inverting Input of PFC Current Amplifier. Proper external compensation circuits result in
excellent input power factor via average-current-mode control.
5
IMP
Non-inverting Input of PFC Current Amplifier and Output of Multiplier. Proper external
compensation circuits result in excellent input power factor via average-current-mode control.
6
ISENSE Peak Current Limit Setting for PFC.
7
FBPWM
PWM Feedback Input. The control input for voltage-loop feedback of PWM stage. It is
internally pulled HIGH through a 6.5k?resistor. An external opto-coupler from the secondary
feedback circuit is usually connected to this pin.
8
IPWM
PWM Current Sense. The current sense input for the PWM stage. Via a current sense
resistor, this pin provides the control input for peak-current-mode control and cycle-by-cycle
current limiting.
9
OPWM
PWM Gate Drive. The totem-pole output drive for PWM MOSFET. This pin is internally
clamped under 18V to protect the MOSFET.
10
GND
Ground. The power ground.
11
OPFC
PFC Gate Drive. The totem-pole output drive for the PFC MOSFET. This pin is internally
clamped under 18V to protect the MOSFET.
12
VDD
Supply. The power supply pin. The threshold voltages for start-up and turn-off are 14V and
10V, respectively. The operating current is lower than 10mA.
13
SS
PWM Soft-Start. During startup, the SS pin charges an external capacitor with a 50?/SPAN>A
constant current source. The voltage on FBPWM is clamped by SS during startup. In the event
of a protection condition occurring and/or PWM being disabled, the SS pin is quickly
discharged. The voltage of SS pin can be used to select 50% or 65% maximum duty cycle.
14
FBPFC
Voltage Feedback Input for PFC. The feedback input for PFC voltage loop. The inverting
input of PFC error amplifier. This pin is connected to the PFC output through a divider network.
15
VEA
Error Amplifier Output for PFC Voltage Feedback Loop. A compensation network (usually a
capacitor) is connected between this pin and ground. A large capacitor value results in a
narrow bandwidth and improves the power factor.
16
IAC
Input AC Current. For normal operation, this input is used to provide current reference for the
multiplier. The suggested maximum IAC is 360礎.
相關PDF資料 |
PDF描述 |
|---|---|
| SG6961SY | IC PFC CTRLR AVERAGE CURR 8SOIC |
| SI3500-A-GM | IC POE SWITCH PWR OVER LAN 20QFN |
| SI786LSG-E3 | IC REG QD BUCK/LINEAR 28SSOP |
| SIC417CD-T1-E3 | IC REG DL BCK/LINEAR SYNC 32MLPQ |
| SP619EK-L/TR | IC HIGH CURRENT SW SOT23-6 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| SG6961 | 制造商:FAIRCHILD 制造商全稱:Fairchild Semiconductor 功能描述:Power Factor Controller |
| SG6961BSTA_DBB14 WAF | 制造商:Fairchild Semiconductor Corporation 功能描述: |
| SG6961DZ | 功能描述:功率因數校正 IC Grn Mode PFC/Forward PWM Controller RoHS:否 制造商:Fairchild Semiconductor 開關頻率:300 KHz 最大功率耗散: 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:SOIC-8 封裝:Reel |
| SG6961SY | 功能描述:功率因數校正 IC Power Factor Controller RoHS:否 制造商:Fairchild Semiconductor 開關頻率:300 KHz 最大功率耗散: 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:SOIC-8 封裝:Reel |
| SG6961SZ | 功能描述:功率因數校正 IC Power Factor Controller RoHS:否 制造商:Fairchild Semiconductor 開關頻率:300 KHz 最大功率耗散: 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:SOIC-8 封裝:Reel |
發布緊急采購，3分鐘左右您將得到回復。