- 您現在的位置：買賣IC網 > PDF目錄98271 > TPA3000D1PWP (TEXAS INSTRUMENTS INC) 17 W, 1 CHANNEL, AUDIO AMPLIFIER, PDSO24 PDF資料下載
參數資料
| 型號： | TPA3000D1PWP |
| 廠商： | TEXAS INSTRUMENTS INC |
| 元件分類： | 音頻／視頻放大 |
| 英文描述： | 17 W, 1 CHANNEL, AUDIO AMPLIFIER, PDSO24 |
| 封裝： | PLASTIC, TSSOP-24 |
| 文件頁數： | 4/19頁 |
| 文件大?。?/td> | 261K |
| 代理商： | TPA3000D1PWP |
TPA3000D1
SLOS379A – SEPTEMBER 2001 – REVISED JANUARY 2002
12
www.ti.com
APPLICATION INFORMATION
TPA3000D1 modulation scheme (continued)
0 V
–12 V
+12 V
Current
OUTP
OUTN
Differential
Voltage
Across
Load
0 V
–12 V
+12 V
Current
OUTP
OUTN
Differential
Voltage
Across
Load
Output = 0 V
Output > 0 V
Figure 24. The TPA3000D1 Output Voltage and Current Waveforms Into an Inductive Load
efficiency: filter required with the traditional class-D modulation scheme
The main reason that the traditional class-D amplifier needs an output filter is that the switching waveform
results in maximum current flow. This causes more loss in the load, which causes lower efficiency. The ripple
current is large for the traditional modulation scheme, because the ripple current is proportional to voltage
multiplied by the time at that voltage. The differential voltage swing is 2
× VCC, and the time at each voltage is
half the period for the traditional modulation scheme. An ideal LC filter is needed to store the ripple current from
each half cycle for the next half cycle, while any resistance causes power dissipation. The speaker is both
resistive and reactive, whereas an LC filter is almost purely reactive.
The TPA3000D1 modulation scheme has very little loss in the load without a filter because the pulses are very
short and the change in voltage is VCC instead of 2 × VCC. As the output power increases, the pulses widen,
making the ripple current larger. Ripple current could be filtered with an LC filter for increased efficiency, but for
most applications the filter is not needed.
An LC filter with a cutoff frequency less than the class-D switching frequency allows the switching current to flow
through the filter instead of the load. The filter has less resistance than the speaker, which results in less power
dissipation, therefore increasing efficiency.
相關PDF資料 |
PDF描述 |
|---|---|
| TPA3001D1PWPR | 20 W, 1 CHANNEL, AUDIO AMPLIFIER, PDSO24 |
| TPA3001D1PWP | 20 W, 1 CHANNEL, AUDIO AMPLIFIER, PDSO24 |
| TPA3001D1PWPRG4 | 20 W, 1 CHANNEL, AUDIO AMPLIFIER, PDSO24 |
| TPA3001D1PWPG4 | 20 W, 1 CHANNEL, AUDIO AMPLIFIER, PDSO24 |
| TPA3002D2PHPR | 2 CHANNEL(S), VOLUME CONTROL CIRCUIT, PQFP48 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| TPA3000D1PWPR | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:AUDIO AMPLIFIER|SINGLE|CMOS|TSSOP|20PIN|PLASTIC |
| TPA3001D1 | 制造商:TI 制造商全稱:Texas Instruments 功能描述:20 W MONO CLASS D AUDIO POWER AMPLIFIER |
| TPA3001D1_07 | 制造商:TI 制造商全稱:Texas Instruments 功能描述:20-W MONO CLASS-D AUDIO POWER AMPLIFIER |
| TPA3001D1EVM | 功能描述:音頻 IC 開發工具 TPA3001D1 Eval Mod RoHS:否 制造商:Texas Instruments 產品:Evaluation Kits 類型:Audio Amplifiers 工具用于評估:TAS5614L 工作電源電壓:12 V to 38 V |
| TPA3001D1PWP | 功能描述:音頻放大器 Mono High Power Filter-Free Class-D RoHS:否 制造商:STMicroelectronics 產品:General Purpose Audio Amplifiers 輸出類型:Digital 輸出功率: THD + 噪聲: 工作電源電壓:3.3 V 電源電流: 最大功率耗散: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:TQFP-64 封裝:Reel |
發布緊急采購，3分鐘左右您將得到回復。