- 您現在的位置：買賣IC網 > PDF目錄98274 > TPA6013A4PWPG4 (TEXAS INSTRUMENTS INC) 2 CHANNEL(S), TONE CONTROL CIRCUIT, PDSO24 PDF資料下載
參數資料
| 型號： | TPA6013A4PWPG4 |
| 廠商： | TEXAS INSTRUMENTS INC |
| 元件分類： | 音頻控制 |
| 英文描述： | 2 CHANNEL(S), TONE CONTROL CIRCUIT, PDSO24 |
| 封裝： | GREEN, PLASTIC, HTSSOP-24 |
| 文件頁數： | 8/30頁 |
| 文件大小： | 743K |
| 代理商： | TPA6013A4PWPG4 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁當前第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁
ROUT+
Device Shutdown
ROUT+
Device Shutdown
SLOS635 – NOVEMBER 2009
www.ti.com
Figure 25. Shutdown Sequence in the Fade-on
Figure 26. Shutdown Sequence in the Fade-off
Mode
VOLUME, SEDIFF, AND SEMAX OPERATION
Three pins labeled VOLUME, SEDIFF, and SEMAX control the BTL volume when driving speakers and the SE
volume when driving headphones. All of these pins are controlled with a dc voltage, which should not exceed
VDD.
When driving speakers in BTL mode, the VOLUME pin is the only pin that controls the gain. Table 1 shows the
gain for the BTL mode. The voltages listed in the table are for VDD = 5 V. For a different VDD, the values in the
table scale linearly. If VDD = 4 V, multiply all the voltages in the table by 4 V/5 V, or 0.8.
The TPA6013A4 allows the user to specify a difference between BTL gain and SE gain. This is desirable to avoid
any listening discomfort when plugging in headphones. When switching to SE mode, the SEDIFF and SEMAX
pins control the singe-ended gain proportional to the gain set by the voltage on the VOLUME pin. When SEDIFF
= 0 V, the difference between the BTL gain and the SE gain is 6 dB. Refer to the section labeled bridge-tied load
versus single-ended load for an explanation on why the gain in BTL mode is 2x that of single-ended mode, or
6dB greater. As the voltage on the SEDIFF terminal is increased, the gain in SE mode decreases. The voltage
on the SEDIFF terminal is subtracted from the voltage on the VOLUME terminal and this value is used to
determine the SE gain.
Some audio systems require that the gain be limited in the single-ended mode to a level that is comfortable for
headphone listening. Most volume control devices only have one terminal for setting the gain. For example, if the
speaker gain is 18 dB, the gain in the headphone channel is fixed at 12 dB. This level of gain could cause
discomfort to listeners and the SEMAX pin allows the designer to limit this discomfort when plugging in
headphones. The SEMAX terminal controls the maximum gain for single-ended mode.
The functionality of the SEDIFF and SEMAX pin are combined to set the SE gain. A block diagram of the
combined functionality is shown in Figure 27. The value obtained from the block diagram for SE_VOLUME is a
dc voltage that can be used in conjunction with Table 2 to determine the SE gain. Again, the voltages listed in
the table are for VDD = 5 V. The values must be scaled for other values of VDD.
Table 1 and Table 2 show a range of voltages for each gain step. There is a gap in the voltage between each
gain step. This gap represents the hysteresis about each trip point in the internal comparator. The hysteresis
ensures that the gain control is monotonic and does not oscillate from one gain step to another. If a
potentiometer is used to adjust the voltage on the control terminals, the gain increases as the potentiometer is
turned in one direction and decreases as it is turned back the other direction. The trip point, where the gain
16
Copyright 2009, Texas Instruments Incorporated
Product Folder Link(s) :TPA6013A4
相關PDF資料 |
PDF描述 |
|---|---|
| TPA6013A4PWPRG4 | 2 CHANNEL(S), TONE CONTROL CIRCUIT, PDSO24 |
| TPA6017A2PWPR | 1.9 W, 2 CHANNEL, AUDIO AMPLIFIER, PDSO20 |
| TPA6017A2PWP | 1.9 W, 2 CHANNEL, AUDIO AMPLIFIER, PDSO20 |
| TPA6017A2PWPG4 | 1.9 W, 2 CHANNEL, AUDIO AMPLIFIER, PDSO20 |
| TPA6017A2PWPRG4 | 1.9 W, 2 CHANNEL, AUDIO AMPLIFIER, PDSO20 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| TPA6013A4PWPR | 功能描述:音頻放大器 3W Stereo Audio Pwr Amp RoHS:否 制造商:STMicroelectronics 產品:General Purpose Audio Amplifiers 輸出類型:Digital 輸出功率: THD + 噪聲: 工作電源電壓:3.3 V 電源電流: 最大功率耗散: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:TQFP-64 封裝:Reel |
| TPA6013A4PWPRG4 | 制造商:TI 制造商全稱:Texas Instruments 功能描述:3-W STEREO AUDIO POWER AMPLIFIER WITH ADVANCED DC VOLUME CONTROL |
| TPA6017A2 | 制造商:TI 制造商全稱:Texas Instruments 功能描述:2 W STEREO AUDIO POWER AMPLIFIER WITH FOUR SELECTABLE GAIN SETTINGS |
| TPA6017A2_07 | 制造商:TI 制造商全稱:Texas Instruments 功能描述:2-W STEREO AUDIO POWER AMPLIFIER WITH FOUR SELECTABLE GAIN SETTINGS |
| TPA6017A2_13 | 制造商:TI 制造商全稱:Texas Instruments 功能描述:Introduction and Table of Contents |
發布緊急采購，3分鐘左右您將得到回復。