- 您現在的位置：買賣IC網 > PDF目錄98281 > TPS40075RHLR (TEXAS INSTRUMENTS INC) 2 A SWITCHING CONTROLLER, 1000 kHz SWITCHING FREQ-MAX, PQCC20 PDF資料下載
參數資料
| 型號： | TPS40075RHLR |
| 廠商： | TEXAS INSTRUMENTS INC |
| 元件分類： | 穩壓器 |
| 英文描述： | 2 A SWITCHING CONTROLLER, 1000 kHz SWITCHING FREQ-MAX, PQCC20 |
| 封裝： | PLASTIC, QFN-20 |
| 文件頁數： | 18/44頁 |
| 文件大小： | 806K |
| 代理商： | TPS40075RHLR |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁當前第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁
www.ti.com
3. COMPONENT SELECTION
L +
V
O
V
IN(max)
V
IN(max) * VO
f
SW
DI
(17)
I
LOAD_RMS +
I
LOAD
2
) D
I2
12
+ 15.03 A
(18)
I
PK + ILOAD )
DI2
2
+ 16.65 A
(19)
C
O u
L
I
STEP
2
V
UNDER
D
MAX
V
IN * VO
(20)
C
O u
L
I
STEP
2
V
OVER
V
O
(21)
ESR t
V
RIPPLE
DI
(22)
SLUS676A – MAY 2006 – REVISED SEPTEMBER 2007
3. 1 Power Train Components
Designers familiar with the buck converter can skip to section 3.2 Component Selection for TPS40075.
3.1.1 Output Inductor, LO
The output inductor is one of the most important components to select. It stores the energy necessary to keep
the output regulated when the switch MOSFET is turned off. The value of the output inductor dictates the peak
and RMS currents in the converter. These currents are important when selecting other components. Equation 17
can be used to calculate a value for L.
Δ I is the allowable ripple in the inductor. Selecting ΔI also sets the output current when the converter goes into
discontinuous mode (DCM) operation. Since this converter utilizes MOSFETs for the rectifier, DCM is not a major
concern. Select
ΔI to be between 20% and 30% of maximum ILOAD. For this design, ΔI of 3 A was selected. The
calculated L is 1.1
μH. A standard inductor with value of 1.0 μH was chosen. This increases ΔI by about 10% to
3.3 A.
With this
ΔI value, calculate the RMS and peak current flowing in LO. Note this peak current is also seen by the
switching MOSFET and synchronous rectifier.
3.1.2 Output Capacitor, CO, ELCO and MLCC
Several parameters must be considered when selecting the output capacitor. The capacitance value should be
selected based on the output overshoot, VOVER, and undershoot, VUNDER, during a transient load, ISTEP, on the
converter. The equivalent series resistance (ESR) is chosen to allow the converter meet the output ripple
specification, VRIPPLE. The voltage rating must be greater than the maximum output voltage. Other parameters to
consider are: equivalent series inductance which is important in fast transient load situations. Also size and
technology can be factors when choosing the output capacitor. In this design a large capacitance electrolytic type
capacitor, CO ELCO, is used to meet the overshoot and under shoot specifications. Its ESR is chosen to meet
the output ripple specification. While a smaller multiple layer ceramic capacitor, CO MLCC, is used to filter high
frequency noise.
The minimum required capacitance and maximum ESR can be calculated using the equations below.
Using Equation 20 through Equation 22, the capacitance for CO should be greater than 495 μF and its ESR
should be less than 9.1m
. The 1000 μF/25 V capacitor from Rubycon's MBZ or Panasonic's series EEU-FL was
chosen. Its ESR is 19 m
, so two in parallel are used. The slightly higher ESR is offset by the four times
increase in capacitance. A 2.2
μF/16 V MLCC is also added in parallel to reduce high frequency noise.
Copyright 2006–2007, Texas Instruments Incorporated
25
Product Folder Link(s) :TPS40075
相關PDF資料 |
PDF描述 |
|---|---|
| TPS40075RHLTG4 | 2 A SWITCHING CONTROLLER, 1000 kHz SWITCHING FREQ-MAX, PQCC20 |
| TPS40077PWPR | 2 A SWITCHING CONTROLLER, 1000 kHz SWITCHING FREQ-MAX, PDSO16 |
| TPS40077PWPRG4 | 2 A SWITCHING CONTROLLER, 1000 kHz SWITCHING FREQ-MAX, PDSO16 |
| TPS40077PWPG4 | 2 A SWITCHING CONTROLLER, 1000 kHz SWITCHING FREQ-MAX, PDSO16 |
| TPS40090QPWRQ1 | SWITCHING CONTROLLER, 1200 kHz SWITCHING FREQ-MAX, PDSO24 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| TPS40075RHLRG4 | 功能描述:DC/DC 開關控制器 Wide Input Synch Buck Controller RoHS:否 制造商:Texas Instruments 輸入電壓:6 V to 100 V 開關頻率: 輸出電壓:1.215 V to 80 V 輸出電流:3.5 A 輸出端數量:1 最大工作溫度:+ 125 C 安裝風格: 封裝 / 箱體:CPAK |
| TPS40075RHLT | 功能描述:DC/DC 開關控制器 Wide Input Synch Buck Controller RoHS:否 制造商:Texas Instruments 輸入電壓:6 V to 100 V 開關頻率: 輸出電壓:1.215 V to 80 V 輸出電流:3.5 A 輸出端數量:1 最大工作溫度:+ 125 C 安裝風格: 封裝 / 箱體:CPAK |
| TPS40075RHLTG4 | 功能描述:DC/DC 開關控制器 Wide Input Synch Buck Controller RoHS:否 制造商:Texas Instruments 輸入電壓:6 V to 100 V 開關頻率: 輸出電壓:1.215 V to 80 V 輸出電流:3.5 A 輸出端數量:1 最大工作溫度:+ 125 C 安裝風格: 封裝 / 箱體:CPAK |
| TPS40077 | 制造商:TI 制造商全稱:Texas Instruments 功能描述:HIGH-EFFICIENCY, MIDRANGE-INPUT, SYNCHRONOUS BUCK CONTROLLER WITH VOLTAGE FEED-FORWARD |
| TPS40077_07 | 制造商:TI 制造商全稱:Texas Instruments 功能描述:HIGH-EFFICIENCY, MIDRANGE-INPUT, SYNCHRONOUS BUCK CONTROLLER WITH VOLTAGE FEED-FORWARD |
發布緊急采購，3分鐘左右您將得到回復。