- 您現在的位置：買賣IC網 > PDF目錄98284 > TPS6223-1.5DRYT (TEXAS INSTRUMENTS INC) 1.22 A SWITCHING REGULATOR, 3800 kHz SWITCHING FREQ-MAX, PDSO6 PDF資料下載
參數資料
| 型號： | TPS6223-1.5DRYT |
| 廠商： | TEXAS INSTRUMENTS INC |
| 元件分類： | 穩壓器 |
| 英文描述： | 1.22 A SWITCHING REGULATOR, 3800 kHz SWITCHING FREQ-MAX, PDSO6 |
| 封裝： | 1 X 1.50 MM, 0.60 MM HEIGHT, PLASTIC, MO-287UFAD, SON-6 |
| 文件頁數： | 14/28頁 |
| 文件大小： | 1276K |
| 代理商： | TPS6223-1.5DRYT |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁當前第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁
www.ti.com....................................................................................................................................................... SLVS941A – APRIL 2009 – REVISED AUGUST 2009
In high-frequency converter applications, the efficiency is essentially affected by the inductor AC resistance (i.e.,
quality factor) and to a smaller extent by the inductor DCR value. To achieve high efficiency operation, care
should be taken in selecting inductors featuring a quality factor above 25 at the switching frequency. Increasing
the inductor value produces lower RMS currents, but degrades transient response. For a given physical inductor
size, increased inductance usually results in an inductor with lower saturation current.
The total losses of the coil consist of both the losses in the DC resistance, R(DC), and the following
frequency-dependent components:
The losses in the core material (magnetic hysteresis loss, especially at high switching frequencies)
Additional losses in the conductor from the skin effect (current displacement at high frequencies)
Magnetic field losses of the neighboring windings (proximity effect)
Radiation losses
The following inductor series from different suppliers have been used with the TPS6223X converters.
Table 1. List of inductors
INDUCTANCE
DIMENSIONS
INDUCTOR TYPE
SUPPLIER
[
μH]
[mm3]
1.0/2.2
2.5 × 2.0 × 1.2
LQM2HPN1R0MJ0
Murata
2.2
2.0 × 1.2 × 0.55
LQM21PN2R2
Murata
1.0/2.2
2.0 × 1.2 × 1.0
MIPSZ2012
FDK
1.0/2.2
2.0 × 2.5 × 1.2
MIPSA2520
FDK
1.0/2.2
2.0 × 1.2 × 1.0
KSLI2012 series
Hitachi Metal
OUTPUT CAPACITOR SELECTION
The unique hysteric PWM control scheme of the TPS62230 allows the use of tiny ceramic capacitors. Ceramic
capacitors with low ESR values have the lowest output voltage ripple and are recommended. The output
capacitor requires either an X7R or X5R dielectric. Y5V and Z5U dielectric capacitors, aside from their wide
variation in capacitance over temperature, become resistive at high frequencies.
At light load currents the converter operate in Power Save Mode and the output voltage ripple is dependent on
the output capacitor value and the PFM peak inductor current. Higher output capacitor values minimize the
voltage ripple in PFM Mode and tighten DC output accuracy in PFM Mode.
INPUT CAPACITOR SELECTION
Because of the nature of the buck converter having a pulsating input current, a low ESR input capacitor is
required for best input voltage filtering and minimizing the interference with other circuits caused by high input
voltage spikes. For most applications a 2.2
μF to 4.7μF ceramic capacitor is recommended. The input capacitor
can be increased without any limit for better input voltage filtering. Because ceramic capacitor loses up to 80% of
its initial capacitance at 5V, it is recommended to use 4.7
μF input capacitors for input voltages > 4.5V.
Take care when using only small ceramic input capacitors. When a ceramic capacitor is used at the input and the
power is being supplied through long wires, such as from a wall adapter, a load step at the output or VIN step on
the input can induce ringing at the VIN pin. This ringing can couple to the output and be mistaken as loop
instability or could even damage the part by exceeding the maximum ratings.
Table 2 shows a list of tested input/output capacitors.
Table 2. List of Capacitor
CAPACITANCE [
μF]
SIZE
CAPACITOR TYPE
SUPPLIER
2.2
0402
GRM155R60J225
Murata
4.7
0402
AMK105BJ475MV
Taiyo Yuden
4.7
0402
GRM155R60J475
Murata
4.7
0402
CL05A475MQ5NRNC
Samsung
4.7
0603
GRM188R60J475
Murata
Copyright 2009, Texas Instruments Incorporated
21
相關PDF資料 |
PDF描述 |
|---|---|
| TPS62230DRYR | 1.22 A SWITCHING REGULATOR, 3800 kHz SWITCHING FREQ-MAX, PDSO6 |
| TPS62250DRVR | SWITCHING REGULATOR, 2500 kHz SWITCHING FREQ-MAX, PDSO6 |
| TPS62260IDRVRQ1 | SWITCHING REGULATOR, PDSO6 |
| TPS62260QDRVRQ1 | SWITCHING REGULATOR, PDSO6 |
| TPS62261DRV | 1.2 A SWITCHING REGULATOR, 2500 kHz SWITCHING FREQ-MAX, PDSO6 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| TPS622315EVM-574 | 功能描述:電源管理IC開發工具 TPS622315 Eval Mod RoHS:否 制造商:Maxim Integrated 產品:Evaluation Kits 類型:Battery Management 工具用于評估:MAX17710GB 輸入電壓: 輸出電壓:1.8 V |
| TPS622316DRYR | 功能描述:直流/直流開關轉換器 3MHz Ultra Small Step Down Converter RoHS:否 制造商:STMicroelectronics 最大輸入電壓:4.5 V 開關頻率:1.5 MHz 輸出電壓:4.6 V 輸出電流:250 mA 輸出端數量:2 最大工作溫度:+ 85 C 安裝風格:SMD/SMT |
| TPS622316DRYT | 功能描述:直流/直流開關調節器 3MHz Ultra Small Step Down Converter RoHS:否 制造商:International Rectifier 最大輸入電壓:21 V 開關頻率:1.5 MHz 輸出電壓:0.5 V to 0.86 V 輸出電流:4 A 輸出端數量: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:PQFN 4 x 5 |
| TPS622317DRYR | 功能描述:直流/直流開關調節器 3MHz Ultra Small Step Down Converter RoHS:否 制造商:International Rectifier 最大輸入電壓:21 V 開關頻率:1.5 MHz 輸出電壓:0.5 V to 0.86 V 輸出電流:4 A 輸出端數量: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:PQFN 4 x 5 |
| TPS622317DRYT | 功能描述:直流/直流開關調節器 3MHz Ultra Small Step Down Converter RoHS:否 制造商:International Rectifier 最大輸入電壓:21 V 開關頻率:1.5 MHz 輸出電壓:0.5 V to 0.86 V 輸出電流:4 A 輸出端數量: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:PQFN 4 x 5 |
發布緊急采購，3分鐘左右您將得到回復。