欧美成人免费电影,国产欧美一区二区三区精品酒店,精品国产a毛片,色网在线免费观看

參數資料
型號: TS(X)8387MF_
元件分類: ADC
英文描述: 1-CH 8-BIT PROPRIETARY METHOD ADC, PARALLEL ACCESS, CQFP68
封裝: CERAMIC, QFP-68
文件頁數: 21/38頁
文件大小: 617K
代理商: TS(X)8387MF_
TS8387
28/38
7.3.3.SINGLE ENDED CLOCK INPUT (Ground Common Mode)
An even more convenient clock input configuration is proposed below :
The TS8387 clock buffer can also manage a single-ended sinewave clock signal centered around 0 Volt.
(out of phase clock signal grounded through the 50 Ohm termination resistor).
The typical inphase clock input amplitude is 1 Volt peak to peak, centered on 0 Volt (ground) common mode.
This corresponds to a typical clock input power level of 4 dBm into the 50 ohms termination resistor.
Do not exceed 10 dBm to avoid saturation of the preamplifier input transistors.
The inverted phase clock input is grounded through the 50 ohms termination resistor.
Single ended Clock input (Ground common mode)
VCLK common mode = 0 Volt
VCLKB=0 Volt
4 dBm typical clock input power level
(into 50 ohms termination resistor)
[V]
t
VCLK
VCLKB = ( 0 V )
–0.5V
+0.5V
Note 1 : Do not exceed 10 dBm into the 50 ohms termination resistor for single clock input power level.
7.4.
CLOCK SIGNAL DUTY CYCLE ADJUST
In single ended configuration, when using a sinewave clock generator,the clock signal duty cycle can be easily adjusted
by simply offseting the inphase clock signal using a biasing tee, (as the out of phase clock input is at ground level ).
Single ended Clock input (Inphase clock input common mode shifted)
VCLK common mode = –180mV
VCLKB = 0 Volt
[V]
t
VCLK – 180 mV
VCLKB = ( 0 V )
–0.5V
40 %
60 %
+0.5V
Note 1 : Do not exceed 10 dBm into the 50 ohms termination resistor for single clock input power level.
Note 2 :For an input CLK signal of 4 dBm into 50 ohms, the typical offset value to achieve a 40 / 60 clock duty cycle is –180 mV on
CLK.
7.5.
NOISE IMMUNITY INFORMATIONS
Circuit noise immunity performance begins at design level.
Efforts have been made on the design in order to make the device as insensitive as possible to chip environment per-
turbations resulting from the circuit itself or induced by external circuitry.
(Cascode stages isolation, internal damping resistors, clamps, internal (onchip) decoupling capacitors.)
Furthermore, the fully differential operation from analog input up to the digital outputs provides enhanced noise immu-
nity by common mode noise rejection.
Common mode noise voltage induced on the differential analog and clock inputs will be canceled out by these balanced
differential amplifiers.
相關PDF資料
PDF描述
TS(X)8387MFB/C 1-CH 8-BIT PROPRIETARY METHOD ADC, PARALLEL ACCESS, CQFP68
TS(X)8387CF_ 1-CH 8-BIT PROPRIETARY METHOD ADC, PARALLEL ACCESS, CQFP68
TS(X)8387MF 1-CH 8-BIT PROPRIETARY METHOD ADC, PARALLEL ACCESS, CQFP68
TS(X)8387MFDSSC/SMD 1-CH 8-BIT PROPRIETARY METHOD ADC, PARALLEL ACCESS, CQFP68
TS8387MFDSSC/SMD 1-CH 8-BIT PROPRIETARY METHOD ADC, PARALLEL ACCESS, CQFP68
相關代理商/技術參數
參數描述
TSX-8A16MHZ 制造商:Epson Electronics America Inc 功能描述:CODE BCAI
TSX920ILT 功能描述:General Purpose Amplifier 1 Circuit Rail-to-Rail SOT-23-6 制造商:stmicroelectronics 系列:- 包裝:剪切帶(CT) 零件狀態:有效 放大器類型:通用 電路數:1 輸出類型:滿擺幅 壓擺率:17 V/μs 增益帶寬積:10MHz -3db 帶寬:- 電流 - 輸入偏置:10pA 電壓 - 輸入失調:4mV 電流 - 電源:2.9mA 電流 - 輸出/通道:74mA 電壓 - 電源,單/雙(±):4 V ~ 16 V 工作溫度:-40°C ~ 125°C 安裝類型:表面貼裝 封裝/外殼:SOT-23-6 供應商器件封裝:SOT-23-6 標準包裝:1
TSX921ILT 制造商:STMicroelectronics 功能描述:ANALOG AND AUDIO SYSTEMS - Tape and Reel 制造商:STMicroelectronics 功能描述:ANALOG and AUDIO SYSTEMS
TSX921IYLT 制造商:STMicroelectronics 功能描述:IC OPAMP R-R 10MHZ SOT23-5
TSX922IDT 功能描述:General Purpose Amplifier 2 Circuit Rail-to-Rail 8-SO 制造商:stmicroelectronics 系列:- 包裝:剪切帶(CT) 零件狀態:有效 放大器類型:通用 電路數:2 輸出類型:滿擺幅 壓擺率:17 V/μs 增益帶寬積:10MHz -3db 帶寬:- 電流 - 輸入偏置:10pA 電壓 - 輸入失調:4mV 電流 - 電源:2.8mA 電流 - 輸出/通道:74mA 電壓 - 電源,單/雙(±):4 V ~ 16 V 工作溫度:-40°C ~ 125°C 安裝類型:表面貼裝 封裝/外殼:8-SOIC(0.154",3.90mm 寬) 供應商器件封裝:8-SO 標準包裝:1
主站蜘蛛池模板: 荣昌县| 江川县| 永泰县| 大渡口区| 拉萨市| 屯门区| 三江| 乌恰县| 宜良县| 于都县| 永济市| 施甸县| 太仓市| 汶川县| 宁国市| 普兰店市| 迭部县| 忻州市| 陆河县| 黄大仙区| 兴安盟| 芜湖市| 黔江区| 平果县| 肇东市| 郎溪县| 荆州市| 澄迈县| 斗六市| 湟中县| 贵州省| 襄城县| 衡阳市| 江都市| 朝阳区| 綦江县| 长宁区| 东兴市| 阜南县| 古浪县| 当阳市|