欧美成人免费电影,国产欧美一区二区三区精品酒店,精品国产a毛片,色网在线免费观看

參數資料
型號: UBA2051A
廠商: NXP Semiconductors N.V.
英文描述: One-chip telephone ICs with speech, dialler and ringer functions
中文描述: 一個有語言,撥號及振鈴電話集成電路芯片的功能
文件頁數: 30/52頁
文件大小: 292K
代理商: UBA2051A
2000 May 19
30
Philips Semiconductors
Product specification
One-chip telephone ICs with speech,
dialler and ringer functions
UBA2050(A); UBA2051(A;C)
Memory recall state (only UBA2051x)
Repertory numbers can be dialled out after or before
entering manual dialling, last number redial and by
entering the memory locations in successive order.
Repertory recall is not possible as long as a dial out is
pending. The three direct memory locations are numbered
[M1] to [M3] and the ten indirect memory locations
[MEM] [1] to [MEM] [0].
The stored numbers can be dialled by using one of the
following procedures:
Press one of the direct memory keys [M1] to [M3]
or
Press [MEM], followed by one of the numeric keys
[1] to [0], corresponding to the memory locations 1 to 10.
In case [R] is included in one memory location, when the
LNR capacity is exceeded by using it, the LNR function is
inhibited.
Program state (only UBA2051x)
The program state can be entered from the conversation
mode (on-line) when no dial out is pending. Pressing the
[STORE] key in this state puts the UBA2051x in the
program state and also clears the LNR memory. Pressing
the [STORE] key again in the program state will restart the
program sequence.
Leaving the program state
The program state can be left in one of the following
ways:
– By going on-hook; the entered digits are stored in the
LNR memory
– By ending the store procedures properly (see below),
resulting in a proper store of the programmed item.
Programming repertory numbers
A maximum number of 32 digits can be stored in the
memoryofrepertorynumbers(includingaccesspauses,
tone switch and flash) and can be achieved by using the
following procedure:
– Press [STORE]; the LNR memory is cleared
– Press the sequence of digits that must be stored; the
keys [0] to [9], [#], [LNR/P], [
/T], [P
T] or [R] may
be used
– Store the number in the memory.
Memory overflow
If more than 21 digits are entered the old memory
contents is kept and the LNR memory is cleared. All the
following digits are ignored, except the [STORE] key.
The memory overflow state can be left:
– By going on-hook
– By pressing the [STORE] key again to restart the
program sequence.
Clear repertory numbers
Clearing a memory location is possible by using the
same procedure as for storing a number, except that no
telephone number is entered:
– Press [STORE]; the LNR memory will be cleared
– Press one of the memory keys.
Notepad function
In the conversation state it is possible to store a 21 digit
number into the LNR memory, which may be dialled
after an on-hook/off-hook action. The procedure is as
follows:
– Press [STORE], the LNR memory will be cleared
– Press the sequence of digits that must be stored; the
keys [0] to [9], [#], [LNR/P], [
/T], [P
T] or [R] may
be used
– Go on-hook/off-hook.
相關PDF資料
PDF描述
UBA2051AT One-chip telephone ICs with speech, dialler and ringer functions
UBA2051C One-chip telephone ICs with speech, dialler and ringer functions
UBA2051CT One-chip telephone ICs with speech, dialler and ringer functions
UBA2051T One-chip telephone ICs with speech, dialler and ringer functions
UBA2070 8-bit MCU for automotive with 16 to 60 Kbyte Flash, ADC, CSS, 5 timers, SPI, SCI, I2C interface
相關代理商/技術參數
參數描述
UBA2051AT 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:One-chip telephone ICs with speech, dialler and ringer functions
UBA2051C 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:One-chip telephone ICs with speech, dialler and ringer functions
UBA2051CT 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:One-chip telephone ICs with speech, dialler and ringer functions
UBA2051T 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:One-chip telephone ICs with speech, dialler and ringer functions
UBA2070 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:600 V CCFL ballast driver IC
主站蜘蛛池模板: 大化| 巨野县| 腾冲县| 怀来县| 原阳县| 兴业县| 天全县| 米易县| 双峰县| 淄博市| 宁都县| 方山县| 江油市| 丰县| 泸西县| 尚志市| 财经| 吉水县| 吴旗县| 海门市| 高安市| 吉安县| 上杭县| 江口县| 武功县| 额尔古纳市| 曲阳县| 札达县| 临洮县| 张家口市| 郯城县| 西峡县| 孝昌县| 吉安县| 嘉兴市| 香港 | 湘乡市| 秦安县| 黄陵县| 蓝山县| 永吉县|