- 您現在的位置：買賣IC網 > PDF目錄382716 > UBA2051C (NXP Semiconductors N.V.) One-chip telephone ICs with speech, dialler and ringer functions PDF資料下載
參數資料
| 型號： | UBA2051C |
| 廠商： | NXP Semiconductors N.V. |
| 英文描述： | One-chip telephone ICs with speech, dialler and ringer functions |
| 中文描述： | 一個有語言，撥號及振鈴電話集成電路芯片的功能 |
| 文件頁數： | 26/52頁 |
| 文件大小： | 292K |
| 代理商： | UBA2051C |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁當前第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁
2000 May 19
26
Philips Semiconductors
Product specification
One-chip telephone ICs with speech,
dialler and ringer functions
UBA2050(A); UBA2051(A;C)
K
EY TONE
(
PIN
KT)
A keytone with a frequency f
kt
= 597 Hz and a duration t
kt
= 30 ms (see Fig.27) is generated each time a valid key is
pressed resulting in the expected action, digit keys in tone dialling mode excepted.
Pin KT is a push-pull output and is set LOW when V
DD
< V
POR
.
handbook, full pagewidth
keytone
MGM344
tkt
fkt
tkt
fkt
Fig.27 Keytones via KT output.
t
kt
= keytone time.
f
kt
= keytone frequency.
Key sequences
The behaviour of the UBA205xx can be represented as
a State Transition Diagram (STD).
The STD contains the states (rectangles in Fig.28) and
state transitions (arrows) of the set. The upper arrow in the
figure pointing to the standby state means that the set is
initially in the standby state. When, for instance, an
incoming call is detected, the set enters the ringer state,
waiting for end of a ringer signal or off-hook. If the set goes
off-hook, the UBA205xx enters the on-line state.
The UBA205xx has 3 basic states:
Standby state
Ringer state
On-line state.
Each state with its own functional requirements is
described in the following sections.
S
TANDBY STATE
In the standby state the UBA205xx is inactive. The current
drawn is for memory retention; the loads on the
inputs/outputs of the dialler have influence on the retention
current.
The UBA205xx leaves the standby state if:
The set goes off-hook (lift handset)
A ringer signal is available on the line.
The UBA205xx returns to the standby state if:
The set goes on-hook (handset on-hook)
A line-break occurs with a duration greater than t
RD
The ringer signal becomes invalid.
R
INGER STATE
Ifthesetisinstandbystate,aringersignalcanbereceived
from the line. After evaluating the incoming ringer signal
(and the ringer signal is valid), the UBA205xx starts a
melody via the MDY/TONE output and ringer hardware;
this melody is stopped when the ringer signal is no longer
valid. After going off-hook, the ringer signal stops and the
set is in the conversation (on-line) state.
While ringing, the melody can be changed according to
Table 8 and the volume according to Table 9.
As long as memory retention conditions are fulfilled,
melody and volume are stored.
相關PDF資料 |
PDF描述 |
|---|---|
| UBA2051CT | One-chip telephone ICs with speech, dialler and ringer functions |
| UBA2051T | One-chip telephone ICs with speech, dialler and ringer functions |
| UBA2070 | 8-bit MCU for automotive with 16 to 60 Kbyte Flash, ADC, CSS, 5 timers, SPI, SCI, I2C interface |
| UBB1000 | 8-bit MCU for automotive with 16 to 60 Kbyte Flash, ADC, CSS, 5 timers, SPI, SCI, I2C interface |
| UBC41 | DUODIODE TRIODE |
相關代理商/技術參數 |
參數描述 |
|---|---|
| UBA2051CT | 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:One-chip telephone ICs with speech, dialler and ringer functions |
| UBA2051T | 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:One-chip telephone ICs with speech, dialler and ringer functions |
| UBA2070 | 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:600 V CCFL ballast driver IC |
| UBA2070P | 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:600 V CCFL ballast driver IC |
| UBA2070P/N1,112 | 功能描述:顯示驅動器和控制器 CCFL RoHS:否 制造商:Panasonic Electronic Components 工作電源電壓:2.7 V to 5.5 V 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:QFN-44 封裝:Reel |
發布緊急采購，3分鐘左右您將得到回復。