欧美成人免费电影,国产欧美一区二区三区精品酒店,精品国产a毛片,色网在线免费观看

參數資料
型號: XIB-E
廠商: Digi International/Maxstream
文件頁數: 38/64頁
文件大小: 1858K
描述: BOARD INTERFACE ETHERNET
標準包裝: 1
附件類型: 接口板
適用于相關產品: XStream 和 Xcite 收音機
XStream"燨EM燫F燤odule?燩roduct燤anual爒5.x00燵2006.02.24]?/DIV>
4.2.2. Repeater Mode
Characteristics:   Self-organizing - No route configuration is necessary 
 
Self-healing / Fault-tolerant
Low power consumption and Minimized interference
Network throughput is determined by number of hops, not by number of
repeaters. Multiple repeaters within range of source node count as one hop.
Supports transparent multi-drop mode or addressed data filtering mode.
Duplicate RF packets are automatically filtered out.
All packets propagate to every node in the network (filtering rules apply).
Broadcast communications - each packet comes out every node exactly once.
Addressed communications - all radios see every packet. Only the module
with a matching address will forward it to the DO buffer (UART IN).
Data entering the network on any module is transmitted and forwarded
through every repeater module until it reaches the ends of the network.
 
Each repeater will repeat a packet only once.
Constraints: 
Requires that each module have a unique MY (Source Address) parameter.
System must introduce just one packet at a time to the network for
transmission (256 bytes max).
Each hop (H) decreases network throughput by a factor of 1/(H+1).
Additional repeaters add network redundancy without decreasing throughput.
Required Parameter Values (TX Module): MD = 3 or 4, MY = unique value (can be 
accomplished by issuing the AM (Auto-set MY) and WR (Write) commands to all modules in the
network)
Related Commands: Networking (MD, DT, MY, AM), Serial Interfacing (RN, PK, RO, RB) 
Recommended Use: Use in networks where intermediary nodes are needed to relay data to 
modules that are beyond the transmission range of the base module.
Theory of Operation
OEMs and integrators can extend the effective range and reliability of a data radio system by
forwarding traffic through one or more repeaters.
Instead of using routing tables and path discovery to establish dynamic paths through a network,
the repeater system uses a sophisticated algorithm to propagate each RF packet through the
entire network.
The network supports RF packets up to 256 bytes. The repeater network can operate using
broadcast or addressed communications for multi-drop networks and works well in many systems
with no special configuration.
When in Repeater Mode, the network repeats each message among all available nodes exactly
one time. This mechanism eliminates the need for configuring specific routes. The network is self-
organizing and self-healing so that the system is able to receive transmissions in the event of a
module going down.
Figure?05. Sample燫epeater燦etwork燭opology?/DIV>
 
 
 
 
 
 
牋牘?006燤axStream,營nc.燙onfidential燼nd燩roprietary?/DIV>
38?/DIV>
相關PDF資料
PDF描述
XIB-R BOARD INTERFACE RS232/485
ZMN2400HPDB BOARD ROUTER DEV ZIGBEE 100MW
ZMN24HPDK-B KIT DEV W/ZIGBEE ZMN2400HP
ZNI1000TC IC TEMP SENSOR NI1000 SOT23-3
02110102-000 SNSR TILT RATIO 60DEG 500MA FLNG
相關代理商/技術參數
參數描述
XIB-R 功能描述:界面模塊 RS-232/485 interface 24XStream 9XCite RoHS:否 制造商:4D Systems 產品:Serial Converters 通道/端口數量: 數據速率: 接口類型:USB, UART 工作電源電壓:3.3 V, 5 V 最大工作溫度:
XIB-U 功能描述:界面模塊 USB interface board 24XStream 9XCite RoHS:否 制造商:4D Systems 產品:Serial Converters 通道/端口數量: 數據速率: 接口類型:USB, UART 工作電源電壓:3.3 V, 5 V 最大工作溫度:
XIC25040 制造商:XIC 功能描述:25040 24HR '6
XILINXPWR-079 功能描述:電源管理IC開發工具 Pow Mgt Eval Mod for Xilinx FPGAs RoHS:否 制造商:Maxim Integrated 產品:Evaluation Kits 類型:Battery Management 工具用于評估:MAX17710GB 輸入電壓: 輸出電壓:1.8 V
XILINXPWR-080 功能描述:電源管理IC開發工具 Pow Mgt Eval Mod for Xilinx FPGAs RoHS:否 制造商:Maxim Integrated 產品:Evaluation Kits 類型:Battery Management 工具用于評估:MAX17710GB 輸入電壓: 輸出電壓:1.8 V
主站蜘蛛池模板: 报价| 钟祥市| 铜山县| 上饶县| 沾化县| 衡阳市| 芜湖县| 马龙县| 安阳市| 漠河县| 张北县| 永胜县| 进贤县| 皋兰县| 炎陵县| 阳高县| 云霄县| 萨迦县| 晋州市| 乾安县| 英山县| 盐津县| 阿勒泰市| 紫阳县| 星子县| 仁化县| 新郑市| 民权县| 上蔡县| 长岛县| 福鼎市| 龙井市| 忻州市| 正定县| 城口县| 乐平市| 安康市| 铁岭县| 青川县| 保德县| 大余县|