- 您現在的位置：買賣IC網 > PDF目錄33697 > 419UZ (Intersil Corporation) Single Digitally Controlled Potentiometer(XDCP) Low Noise, Low Power, SPI Bus, 128 Taps, Wiper Only PDF資料下載
參數資料
| 型號： | 419UZ |
| 廠商： | Intersil Corporation |
| 元件分類： | 數字電位計 |
| 英文描述： | Single Digitally Controlled Potentiometer(XDCP) Low Noise, Low Power, SPI Bus, 128 Taps, Wiper Only |
| 中文描述： | 單數控電位（數字電位器）低噪聲，低功耗，SPI總線，128抽頭，雨刷只 |
| 文件頁數： | 3/13頁 |
| 文件大小： | 359K |
| 代理商： | 419UZ |
11
FN6311.0
June 28, 2006
FIGURE 12. THREE BYTE WRITE SEQUENCE
FIGURE 13. THREE BYTE READ SEQUENCE
Applications Information
Communicating with ISL22419
Communication with ISL22419 proceeds using SPI interface
through the ACR (address 11b), IVR (address 00b) and WR
(address 00b) registers.
The wiper of the potentiometer is controlled by the WR
register. Writes and reads can be made directly to this
register to control and monitor the wiper position without any
non-volatile memory changes. This is done by setting MSB
bit (ACR[7]) at address 11b to 1.
The non-volatile IVR stores the power up value of the wiper.
IVR is accessible when MSB bit (ACR[7]) at address 11b is
set to 0. Writing a new value to the IVR register will set a
new power up position for the wiper. Also, writing to this
register will load the same value into the WR as the IVR.
Reading from the IVR will not change the WR, if its contents
are different.
The typical application diagram is shown in Figure 14. For
proper operation adding 0.1F decoupling ceramic capacitor
to VCC is recommended. The capacitor value may vary
based on expected noise frequency of the design.
0
1
0
1
0
I3
I2
I1 I0
0
R1 R0
SCK
SDI
0
D6 D5D4 D3 D2 D1D0
CS
00
0
101
00
I3
I2
I1 I0
0
R1 R0
SCK
SDI
CS
00
SDO
0
D6 D5D4 D3 D2 D1D0
Don’t Care
0
ISL22419
相關PDF資料 |
PDF描述 |
|---|---|
| 419WZ | Single Digitally Controlled Potentiometer(XDCP) Low Noise, Low Power, SPI Bus, 128 Taps, Wiper Only |
| 41C16257 | 256K x 16 (4-MBIT) DYNAMIC RAM WITH FAST PAGE MODE |
| 41HF10 | STANDARD RECOVERY DIODES |
| 41HF100 | STANDARD RECOVERY DIODES |
| 41HF100M | STANDARD RECOVERY DIODES |
相關代理商/技術參數 |
參數描述 |
|---|---|
| 419WZ | 制造商:INTERSIL 制造商全稱:Intersil Corporation 功能描述:Single Digitally Controlled Potentiometer(XDCP) Low Noise, Low Power, SPI Bus, 128 Taps, Wiper Only |
| 41A | 制造商:Cinch Connectors 功能描述:Connector Contact Finish:Nickel |
| 41A212388P50 | 制造商:Amphenol Corporation 功能描述:N R/A ADAPTOR UG-27 C/U |
| 41A216641P240 | 制造商:ITT 功能描述:ER 10C 10#16 PIN PLUG 制造商:ITT Interconnect Solutions 功能描述:ER 10C 10#16 PIN PLUG |
| 41A264668P1 | 制造商:n/a 功能描述:Power Semiconductor |
發布緊急采購，3分鐘左右您將得到回復。