- 您現在的位置：買賣IC網 > PDF目錄369244 > 7005 (Aeroflex Inc.) ACT7005/7006 Single Package Solution Dual Transceiver, Protocol, Subsystem PDF資料下載
參數資料
| 型號： | 7005 |
| 廠商： | Aeroflex Inc. |
| 英文描述： | ACT7005/7006 Single Package Solution Dual Transceiver, Protocol, Subsystem |
| 中文描述： | ACT7005/7006單一封裝解決方案雙收發器，協議，子系統 |
| 文件頁數： | 13/29頁 |
| 文件大小： | 452K |
| 代理商： | 7005 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁當前第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁
Aeroflex Circuit Technology
SCD7005 REV B 8/2/01
Plainview NY (516) 694-6700
13
Name
Use
INT #1
GOOD BLOCK (RT)
Indicates reception of a valid block of data. The RECEIVE COMMAND WORD
is loaded in RCV CMD WD Register. This interrupt is issued after the new
block of data is moved into the Internal RAM.
VALID (BC)
Indicates that the Bus Controller has initiated and observed a valid message
transfer on the 1553 data bus.
INT #2
VALID TRANS (RT)
Indicates reception of a valid TRANSMIT COMMAND WORD. The
TRANSMIT COMMAND WORD is loaded in CMD WD Register. Note: This
interrupt does not necessarily indicate that the transmitted data was received
by the bus controller.
INVALID (BC)
Indicates that the Bus Controller has initiated a message transfer on the data
bus, but the message traffic has been deemed invalid.
SYNC NO DATA
Indicates reception of a valid mode command SYNCHRONIZE WITHOUT
DATA
SYNC W/DATA
Indicates reception of a valid mode command SYNCHRONIZE WITH DATA.
The synchronize data word is loaded into the SYNC/STAT WD #2/RMD
REGISTER. This interrupt will not be issued if a word count high or low error
occurs.
DONE
This interrupt is issued in response to an I/0 command from the subsystem. In
response to an I/0 load OUTPUT buffer command, it indicates that the
complete 32 word message block (SUBADDRESS) has been loaded into the
OUTPUT FIFO buffer. In response to an I/0 load internal RAM from INPUT
FIFO buffer command, it indicates the full message (1 to 32 WORDS) has
been loaded.
TIMING
a. In response to an I/0 load OUTPUT buffer: 16.5 to 33 μsec.*
b. In response to an I/0 load RAM from INPUT buffer: 16.5 to 33 μsec for 32
WORDS*, for SHORTER LOAD OPERATIONS SUBTRACT 0.5 μsec per
(16 bit) word, i.e., 17 μsec to 0.5 μsec for single word.
*NOTE:
In the unusual case where a superceding transmit command on the redundant
bus occurs at the returned status time for a valid 32 word receive,
simultaneously with an I/0 transfer request, the DONE interrupt may be
delayed for an additional 16.5 usec.
BUFF EF
This flag may be used to speed up read data operation in response to an I/0
load OUTPUT FIFO buffer command. The BUFF EF flag will go high when the
first word is loaded into the OUTPUT FIFO buffer. The word may be read at
that time. Please see Figure 6.
MODERESET
Indicates reception of a valid RESET mode command.
Table 6 – Discrete Interrupts Summary
相關PDF資料 |
PDF描述 |
|---|---|
| 7006 | ACT7005/7006 Single Package Solution Dual Transceiver, Protocol, Subsystem |
| 700B | Power Module: Custom Dc-Dc Converter, 24 V to 97 V Adjustable Output(DC-DC轉換器,24V-97V可調輸出) |
| 700SCFM | 20SCFM |
| 701011xxx | AXIAL LEAD PRECISION WIREWOUND RESISTORS |
| 70405xxx | AXIAL LEAD PRECISION WIREWOUND RESISTORS |
相關代理商/技術參數 |
參數描述 |
|---|---|
| 700-5 | 制造商:MICROSEMI 制造商全稱:Microsemi Corporation 功能描述:RECTIFIERS ASSEMBLIES THREE PHASE BRIDGES, 2.5 AMP, STANDARD AND FAST RECOVERY |
| 70050 | 制造商:Acme Electric Corporation XXX 功能描述:TOROIDAL TRANSFORMER, Power Rating:15VA, Secondary Voltages:2 x 7V, Secondary Cu |
| 700-500 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:PCB SHEARS 30CM |
| 700-500 | 制造商:Mega Electronics Inc 功能描述:SHEAR PCB 30CM 制造商:Mega Electronics Inc 功能描述:SHEAR, PCB, 30CM 制造商:MEGA 功能描述:SHEAR, PCB, 30CM, Cutting Capacity Max:305mm, Aluminium Cutting Capacity:1.5mm, 制造商:MEGA 功能描述:SHEAR, PCB, 305MM, Cutting Capacity Max:305mm, Aluminum Cutting Capacity:1.5mm, External Depth:440mm, External Width:245mm, Cut Width Max:305mm , RoHS Compliant: NA |
| 70050-002 | 制造商:FCI 功能描述:SET SCREW - Bulk |
發布緊急采購，3分鐘左右您將得到回復。