欧美成人免费电影,国产欧美一区二区三区精品酒店,精品国产a毛片,色网在线免费观看

參數資料
型號: AD7851AN
廠商: ANALOG DEVICES INC
元件分類: ADC
英文描述: 14-Bit 333 kSPS Serial A/D Converter
中文描述: 1-CH 14-BIT SUCCESSIVE APPROXIMATION ADC, SERIAL ACCESS, PDIP24
封裝: 0.300 INCH, PLASTIC, MO-095AG, DIP-24
文件頁數: 27/36頁
文件大小: 435K
代理商: AD7851AN
–27–
REV. A
AD7851
extra bit on the DOUT pin.
If the user has control of the
CONVST
pin but does not want to
exercise it for every conversion, the control register may be used
to start a conversion. Setting the CONVST bit in the control
register to 1 starts a conversion. If the user does not have con-
trol of the
CONVST
pin, a conversion should not initiated by
writing to the control register. T he reason for this is that the
user may get “locked out” and not be able to perform any fur-
ther write/read operations. When a conversion is started by writ-
ing to the control register, the
SYNC
goes low and read/write
operations take place while the conversion is in progress. How-
ever, once the conversion is complete, there is no way of writing
to the part unless the
CONVST
pin is exercised. T he
CONVST
signal triggers the
SYNC
signal low which allows read/write op-
erations to take place.
SYNC
must be low to perform read/write
operations. T he
SYNC
is triggered low by the
CONVST
signal
rising edge or setting the CONVST bit in the control register to
1. T herefore if there is not full control of the
CONVST
pin the
user may end up getting “locked out.”
SERIAL
INTERFACE
MODE
POWER-ON, APPLY CLKIN SIGNAL,
WAIT 150ms FOR AUTOMATIC CALIBRATION
DIN CONNECTED TO DGND
NO
YES
START
WAIT FOR BUSY SIGNAL
TO GO LOW
PULSE
CONVST
PIN
READ
DATA
DURING
CONVERSION
WAIT APPROXIMATELY 200ns
AFTER
CONVST
RISING EDGE
APPLY
SYNC
(IF REQUIRED), SCLK AND READ
CONVERSION RESULT ON DOUT PIN
PULSE
CONVST
PIN
SYNC
AUTOMATICALLY GOES LOW
AFTER
CONVST
RISING EDGE
SCLK AUTOMATICALLY ACTIVE, READ
CONVERSION RESULT ON DOUT PIN
4, 5
2, 3
Figure 40. Flowchart for Setting Up and Reading from the AD7851
CONFIGURING T HE AD7851
AD7851 as a Read-Only ADC
T he AD7851 contains fourteen on-chip registers which can be
accessed via the serial interface. In the majority of applications it
will not be necessary to access all of these registers. Figure 40
outlines a flowchart of the sequence which is used to configure
the AD7851 as a Read-Only ADC. In this case there is no writ-
ing to the on-chip registers and only the conversion result data is
read from the part. Interface Mode 1 cannot be used in this case
as it is necessary to write to the control register to set Interface
Mode 1. Here the CLK IN signal is applied directly after power-
on, the CLK IN signal must be present to allow the part to per-
form a calibration. T his automatic calibration will be completed
approximately 150 ms after power-on.
相關PDF資料
PDF描述
AD7851AR 14-Bit 333 kSPS Serial A/D Converter
AD7851ARS 14-Bit 333 kSPS Serial A/D Converter
AD7851KN 14-Bit 333 kSPS Serial A/D Converter
AD7851KR 14-Bit 333 kSPS Serial A/D Converter
AD7853LARS 3 V to 5 V Single Supply, 200 kSPS 12-Bit Sampling ADCs
相關代理商/技術參數
參數描述
AD7851ANZ 功能描述:IC ADC 14BIT SRL 333KSPS 24-DIP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:2,500 系列:- 位數:12 采樣率(每秒):3M 數據接口:- 轉換器數目:- 功率耗散(最大):- 電壓電源:- 工作溫度:- 安裝類型:表面貼裝 封裝/外殼:SOT-23-6 供應商設備封裝:SOT-23-6 包裝:帶卷 (TR) 輸入數目和類型:-
AD7851AR 制造商:Analog Devices 功能描述:ADC Single SAR 333ksps 14-bit Serial 24-Pin SOIC W 制造商:Rochester Electronics LLC 功能描述:14 BIT SELF CALIBRATION ADC I.C. - Bulk
AD7851AR-REEL 制造商:Analog Devices 功能描述:ADC Single SAR 333ksps 14-bit Serial 24-Pin SOIC W T/R
AD7851ARS 制造商:Analog Devices 功能描述:ADC Single SAR 333ksps 14-bit Serial 24-Pin SSOP 制造商:Analog Devices 功能描述:IC 14-BIT ADC
AD7851ARS-REEL 制造商:Analog Devices 功能描述:ADC Single SAR 333ksps 14-bit Serial 24-Pin SSOP T/R
主站蜘蛛池模板: 达尔| 措美县| 富平县| 高唐县| 道真| 沁源县| 吐鲁番市| 安义县| 西丰县| 皋兰县| 即墨市| 井冈山市| 东乡族自治县| 新巴尔虎左旗| 卢龙县| 内乡县| 弥勒县| 肇源县| 灵川县| 竹溪县| 于田县| 安新县| 汉川市| 博罗县| 南宁市| 宜丰县| 东莞市| 台前县| 宣汉县| 武汉市| 遂昌县| 赤峰市| 吉木萨尔县| 岳普湖县| 保山市| 莱西市| 静乐县| 平顶山市| 永嘉县| 大埔县| 阿瓦提县|