- 您現在的位置：買賣IC網 > PDF目錄373984 > ADF7020BCP (ANALOG DEVICES INC) High Performance ISM Band FSK/ASK Transceiver IC PDF資料下載
參數資料
| 型號： | ADF7020BCP |
| 廠商： | ANALOG DEVICES INC |
| 元件分類： | 無繩電話/電話 |
| 英文描述： | High Performance ISM Band FSK/ASK Transceiver IC |
| 中文描述： | TELECOM, CELLULAR, RF AND BASEBAND CIRCUIT, QCC48 |
| 封裝： | 7 X 7 MM, LFCSP-48 |
| 文件頁數： | 10/40頁 |
| 文件大小： | 797K |
| 代理商： | ADF7020BCP |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁當前第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁
ADF7020
Preliminary Technical Data
Pin No.
29
30
Rev. PrH | Page 10 of 40
Mnemonic
GND2
ADCIN
Function
Ground for Digital Section.
Analog-to-Digital Converter Input. The internal 7-bit ADC can be accessed through this pin. Full scale is 0 to
1.9 V. Readback is made using the SREAD pin.
Regulator Voltage for Digital Block. A 100 nF capacitor should be placed between this pin and ground for
regulator stability and noise rejection.
Voltage Supply for Digital Block. A decoupling capacitor (X7R or Tantalum) of 0.01 μF should be placed as
close as possible to this pin.
Bidirectional Pin. In output mode (INTerrupt mode), the ADF7020 asserts the INT/ LOCK pin when it has found
a match for the preamble sequence.
In input mode (lock mode), the microcontroller can be used to lock the demodulator threshold when a valid
preamble has been detected. Once the threshold is locked, NRZ data can be reliably received. In this mode, a
demod lock can be asserted with minimum delay.
Transmit Data Input/Received Data Output. This is a digital pin and normal CMOS levels apply.
In receive mode, the pin outputs the synchronized data clock. The positive clock edge is matched to the
center of the received data.
In GFSK transmit mode, the pin outputs an accurate clock to latch the data from the microcontroller into the
transmit section at the exact required data rate. See the Gaussian Frequency Shift Keying (GFSK) section.
A Divided-Down Version of the Crystal Reference with Output Driver. The digital clock output can be used to
drive several other CMOS inputs such as a microcontroller clock. The output has a 50:50 mark-space ratio.
This pin provides the Lock_Detect signal, which is used to determine if the PLL is locked to the correct
frequency. Other signals include Regulator_Ready, which is an indicator of the status of the serial interface
regulator.
The reference crystal should be connected between this pin and OSC1. A TCXO reference can be used by
driving this pin with CMOS levels and disabling the crystal oscillator.
The reference crystal should be connected between this pin and OSC2.
Voltage Supply for the Charge Pump and PLL Dividers. This pin should be decoupled to ground with a
0.01 μF capacitor.
Regulator Voltage for Charge Pump and PLL Dividers. A 100 nF capacitor should be placed between this pin
and ground for regulator stability and noise rejection.
Charge Pump Output. This output generates current pulses that are integrated in the loop filter. The
integrated current changes the control voltage on the input to the VCO.
Voltage Supply for VCO Tank Circuit. This pin should be decoupled to ground with a 0.01 μF capacitor.
Grounds for VCO Block.
A 22 nF capacitor should be placed between this pin and VREG1 to reduce VCO noise.
31
VREG2
32
VDD2
33
INT/LOCK
34
35
DATA I/O
DATA CLK
36
CLKOUT
37
MUXOUT
38
OSC2
39
40
OSC1
VDD3
41
VREG3
42
CPOUT
43
44–47
48
VDD
GND
CVCO
相關PDF資料 |
PDF描述 |
|---|---|
| ADG1204 | 2 pF Off Capacitance, 1 pC Charge Injection, +-15 V/12 V 4:1 iCMOS Multiplexer |
| ADG1204YCP | 2 pF Off Capacitance, 1 pC Charge Injection, +-15 V/12 V 4:1 iCMOS Multiplexer |
| ADG1204YRU | 2 pF Off Capacitance, 1 pC Charge Injection, +-15 V/12 V 4:1 iCMOS Multiplexer |
| ADG202A | Quad SPST Switches(LC2MOS四單刀單擲開關) |
| ADG201A | Quad SPST Switches(LC2MOS四單刀單擲開關) |
相關代理商/技術參數 |
參數描述 |
|---|---|
| ADF7020BCP-REEL | 制造商:Analog Devices 功能描述:RF TRNSCVR ASK/FSK 2.5V/3.3V 48LFCSP EP - Tape and Reel |
| ADF7020BCP-REEL7 | 制造商:Analog Devices 功能描述:RF TRNSCVR ASK/FSK 2.5V/3.3V 48LFCSP EP - Tape and Reel |
| ADF7020BCP-U1 | 制造商:Analog Devices 功能描述:HIGH PERFORMANCE ISM BAND FSK/ASK TRANSCEIVER IC - Trays |
| ADF7020BCPZ | 功能描述:IC TX FSK/ASK ISM BAND 48LFCSP RoHS:是 類別:RF/IF 和 RFID >> RF 收發器 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:30 系列:- 頻率:4.9GHz ~ 5.9GHz 數據傳輸率 - 最大:54Mbps 調制或協議:* 應用:* 功率 - 輸出:-3dBm 靈敏度:- 電源電壓:2.7 V ~ 3.6 V 電流 - 接收:* 電流 - 傳輸:* 數據接口:PCB，表面貼裝 存儲容量:- 天線連接器:PCB，表面貼裝 工作溫度:-25°C ~ 85°C 封裝/外殼:68-TQFN 裸露焊盤 包裝:管件 |
| ADF7020BCPZ-RL | 功能描述:IC TX FSK/ASK ISM BAND 48LFCSP RoHS:是 類別:RF/IF 和 RFID >> RF 收發器 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:30 系列:- 頻率:4.9GHz ~ 5.9GHz 數據傳輸率 - 最大:54Mbps 調制或協議:* 應用:* 功率 - 輸出:-3dBm 靈敏度:- 電源電壓:2.7 V ~ 3.6 V 電流 - 接收:* 電流 - 傳輸:* 數據接口:PCB，表面貼裝 存儲容量:- 天線連接器:PCB，表面貼裝 工作溫度:-25°C ~ 85°C 封裝/外殼:68-TQFN 裸露焊盤 包裝:管件 |
發布緊急采購，3分鐘左右您將得到回復。