- 您現在的位置：買賣IC網 > PDF目錄374020 > ADP3180JRU-REEL7 (ANALOG DEVICES INC) 6-Bit Programmable 2-, 3-, 4-Phase Synchronous Buck Controller PDF資料下載
參數資料
| 型號： | ADP3180JRU-REEL7 |
| 廠商： | ANALOG DEVICES INC |
| 元件分類： | 穩壓器 |
| 英文描述： | 6-Bit Programmable 2-, 3-, 4-Phase Synchronous Buck Controller |
| 中文描述： | SWITCHING CONTROLLER, 4000 kHz SWITCHING FREQ-MAX, PDSO28 |
| 封裝： | MO-153-AE, TSSOP-28 |
| 文件頁數： | 9/20頁 |
| 文件大小： | 529K |
| 代理商： | ADP3180JRU-REEL7 |
ADP3180
–9–
EN is a logic low, the DELAY pin is held at ground. After the
UVLO threshold is reached and EN is a logic high, the DELAY
capacitor is charged up with an internal 20 μA current source.
The output voltage follows the ramping voltage on the DELAY
pin, limiting the inrush current. The soft-start time depends on
the values of VID DAC and C
DLY
, with a secondary effect from
R
DLY
. Refer to the Application Information section for detailed
information on setting C
DLY
.
When the PWRGD threshold is reached, the soft-start cycle is
stopped and the DELAY pin is pulled up to 3 V. This ensures
that the output voltage is at the VID voltage when the PWRGD
signals to the system that the output voltage is good. If EN is
taken low or VCC drops below UVLO, the DELAY capacitor is
reset to ground to be ready for another soft-start cycle. Figure 1
shows a typical start-up sequence for the ADP3180.
Figure 1. Start-Up Waveforms, Circuit of Figure 5.
Channel 1–PWRGD, Channel 2–V
OUT
,
Channel 3–High Side MOSFET V
GS
,
Channel 4–Low Side MOSFET V
GS
Current Limit, Short Circuit, and Latch-Off Protection
The ADP3180 compares a programmable current limit set point
to the voltage from the output of the current sense amplifier. The
level of current limit is set with the resistor from the ILIMIT pin
to ground. During normal operation, the voltage on ILIMIT is
3 V. The current through the external resistor is internally scaled
to give a current limit threshold of 10.4 mV/μA. If the differ-
ence in voltage between CSREF and CSCOMP rises above the
current limit threshold, the internal current limit amplifier will
control the internal COMP voltage to maintain the average out-
put current at the limit.
After the limit is reached, the 3 V pull-up on the DELAY pin is
disconnected, and the external delay capacitor is discharged
through the external resistor. A comparator monitors the DELAY
voltage and shuts off the controller when the voltage drops below
1.8 V. The current limit latch-off delay time is therefore set by the
RC time constant discharging from 3 V to 1.8 V. The Application
Information section discusses the selection of C
DLY
and R
DLY
.
Because the controller continues to cycle the phases dur-
ing the latch-off delay time, if the short is removed before the
1.8 V threshold is reached, the controller will return to normal
operation. The recovery characteristic depends on the state of
PWRGD. If the output voltage is within the PWRGD window,
the controller resumes normal operation. However, if a short
circuit has caused the output voltage to drop below the PWRGD
threshold, a soft-start cycle is initiated.
The latch-off function can be reset either by removing and reap-
plying VCC to the ADP3180 or by pulling the EN pin low for
a short time. To disable the short circuit latch-off function, the
external resistor to ground should be left open, and a high value
(>1 M
W
) resistor should be connected from DELAY to VCC.
This prevents the DELAY capacitor from discharging, so the
1.8 V threshold is never reached. The resistor will have an impact
on the soft-start time because the current through it will add to
the internal 20 μA current source.
Figure 2. Overcurrent Latch-Off Waveforms,
Circuit of Figure 4.
Channel 1–PWRGD, Channel 2–V
OUT
,
Channel 3–CSCOMP Pin of ADP3180,
Channel 4–High Side MOSFET VGS
During startup when the output voltage is below 200 mV, a
secondary current limit is active. This is necessary because the
voltage swing of CSCOMP cannot go below ground. This sec-
ondary current limit controls the internal COMP voltage to the
PWM comparators to 2 V. This will limit the voltage drop across
the low side MOSFETs through the current balance circuitry.
There is also an inherent per phase current limit that will protect
individual phases in the case where one or more phases may stop
functioning because of a faulty component. This limit is based on
the maximum normal mode COMP voltage.
Dynamic VID
The ADP3180 incorporates the ability to dynamically change the
VID input while the controller is running. This allows the output
voltage to change while the supply is running and supplying cur-
rent to the load. This is commonly referred to as VID on-the-fly
(OTF). A VID OTF can occur under either light load or heavy
load conditions. The processor signals the controller by changing
the VID inputs in multiple steps from the start code to the finish
code. This change can be either positive or negative.
When a VID input changes state, the ADP3180 detects the
change and ignores the DAC inputs for a minimum of 400 ns.
This time is to prevent a false code due to logic skew while the
REV. 0
相關PDF資料 |
PDF描述 |
|---|---|
| ADP3203JRU-085-RL | Aluminum Electrolytic Radial Leaded Bi-Polar Capacitor; Capacitance: 1000uF; Voltage: 35V; Case Size: 16x31.5 mm; Packaging: Bulk |
| ADP3203JRU-10-RL | 2-Phase IMVP-II & IMVP-III Core Controller for Mobile CPUs |
| ADP3203JRU-10-RL7 | 2-Phase IMVP-II & IMVP-III Core Controller for Mobile CPUs |
| ADP3203 | 2-Phase IMVP-II & IMVP-III Core Controller for Mobile CPUs |
| ADP3204 | 3-Phase IMVP-II and IMVP-III Core Controller for Mobile CPUs |
相關代理商/技術參數 |
參數描述 |
|---|---|
| ADP3181 | 制造商:AD 制造商全稱:Analog Devices 功能描述:5-Bit or 6-Bit Programmable 2-,3-,4-Phase Synchronous Buck Controller |
| ADP3181JRQZ-RL | 功能描述:IC CTRLR BUCK 5/6BIT 28QSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - 專用型 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:2,000 系列:- 應用:電源，ICERA E400，E450 輸入電壓:4.1 V ~ 5.5 V 輸出數:10 輸出電壓:可編程 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:42-WFBGA，WLCSP 供應商設備封裝:42-WLP 包裝:帶卷 (TR) |
| ADP3181JRUZ-REEL | 功能描述:IC REG BUCK 6BIT 2-4PHS 28-TSSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - 專用型 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:2,000 系列:- 應用:電源，ICERA E400，E450 輸入電壓:4.1 V ~ 5.5 V 輸出數:10 輸出電壓:可編程 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:42-WFBGA，WLCSP 供應商設備封裝:42-WLP 包裝:帶卷 (TR) |
| ADP3182 | 制造商:AD 制造商全稱:Analog Devices 功能描述:Adjustable Output 1-/2-/3-Phase Synchronous Buck Controller |
| ADP3182JRQZ-REEL | 功能描述:IC REG CTRLR BUCK PWM 20-QSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:- 標準包裝:4,000 系列:- PWM 型:電壓模式 輸出數:1 頻率 - 最大:1.5MHz 占空比:66.7% 電源電壓:4.75 V ~ 5.25 V 降壓:是 升壓:無 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-40°C ~ 85°C 封裝/外殼:40-VFQFN 裸露焊盤 包裝:帶卷 (TR) |
發布緊急采購，3分鐘左右您將得到回復。