- 您現在的位置：買賣IC網 > PDF目錄374047 > ADV7183B (Analog Devices, Inc.) Multiformat SDTV Video Decoder PDF資料下載
參數資料
| 型號： | ADV7183B |
| 廠商： | Analog Devices, Inc. |
| 英文描述： | Multiformat SDTV Video Decoder |
| 中文描述： | 標清多格式視頻解碼器 |
| 文件頁數： | 26/100頁 |
| 文件大小： | 844K |
| 代理商： | ADV7183B |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁當前第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁
ADV7183B
The following sections describe the I
2
C signals that can be used
to influence the behavior of the clamps on the ADV7183B.
Rev. B | Page 26 of 100
Previous revisions of the ADV7183B had controls (FACL/FICL,
fast and fine clamp length) to allow configuration of the length
for which the coarse (fast) and fine current sources are switched
on. These controls were removed on the ADV7183B-FT and
replaced by an adaptive scheme.
CCLEN Current Clamp Enable, Address 0x14[4]
The current clamp enable bit allows the user to switch off the
current sources in the analog front end altogether. This can be
useful if the incoming analog video signal is clamped externally.
When CCLEN is 0, the current sources are switched off.
When CCLEN is 1 (default), the current sources are enabled.
DCT[1:0] Digital Clamp Timing, Address 0x15[6:5]
The clamp timing register determines the time constant of the
digital fine clamp circuitry. It is important to realize that the
digital fine clamp reacts very quickly because it is supposed to
immediately correct any residual dc level error for the active
line. The time constant of the digital fine clamp must be much
faster than the one from the analog blocks.
By default, the time constant of the digital fine clamp is adjusted
dynamically to suit the currently connected input signal.
Table 29. DCT Function
DCT[1:0]
Description
00
Slow (TC = 1 sec)
01
Medium (TC = 0.5 sec)
10 (default)
Fast (TC = 0.1 sec)
11
Determined by the ADV7183B, depending on
the I/P video parameters
DCFE Digital Clamp Freeze Enable, Address 0x15[4]
This register bit allows the user to freeze the digital clamp loop
at any time. It is intended for users who would like to do their
own clamping. Users should disable the current sources for
analog clamping via the appropriate register bits, wait until the
digital clamp loop settles, and then freeze it via the DCFE bit.
When DCFE is 0 (default), the digital clamp is operational.
When DCFE is 1, the digital clamp loop is frozen.
LUMA FILTER
Data from the digital fine clamp block is processed by three sets
of filters. The data format at this point is CVBS for CVBS input
or luma only for Y/C and YPrPb input formats.
Luma Antialias Filter (YAA). The ADV7183B receives
video at a rate of 27 MHz. (For 4× oversampled video, the
ADCs sample at 54 MHz, and the first decimation is
performed inside the DPP filters. Therefore, the data rate
into the SDP core is always 27 MHz.) The ITU-R BT.601
recommends a sampling frequency of 13.5 MHz. The luma
antialias filter decimates the oversampled video using a
high quality, linear phase, low-pass filter that preserves the
luma signal while at the same time attenuating out-of-band
components. The luma antialias filter has a fixed response.
Luma Shaping Filters (YSH). The shaping filter block is a
programmable low-pass filter with a wide variety of
responses. It can be used to selectively reduce the luma
video signal bandwidth (needed prior to scaling, for
example). For some video sources that contain high
frequency noise, reducing the bandwidth of the luma
signal improves visual picture quality. A follow-on video
compression stage can work more efficiently if the video is
low-pass filtered.
The ADV7183B has two responses for the shaping filter:
one that is used for good quality CVBS, component, and
S-VHS type sources, and a second for nonstandard CVBS
signals.
The YSH filter responses also include a set of notches for
PAL and NTSC. However, using the comb filters for Y/C
separation is recommended.
Digital Resampling Filter. This block is used to allow
dynamic resampling of the video signal to alter parameters
such as the time base of a line of video. Fundamentally, the
resampler is a set of low-pass filters. The actual response is
selected by the system, and user intervention is not
required.
174H
Figure 12 through
175H
Figure 15 show the overall response of all
filters together. Unless otherwise noted, the filters are set into a
typical wideband mode.
相關PDF資料 |
PDF描述 |
|---|---|
| ADV7183BBSTZ | Multiformat SDTV Video Decoder |
| ADV7183BKSTZ | Multiformat SDTV Video Decoder |
| ADV7183KST | Advanced Video Decoder with 10-Bit ADC and Component Input Support |
| AD7183 | Advanced Video Decoder with 10-Bit ADC and Component Input Support |
| ADV7185 | Professional NTSC/PAL Video Decoder with 10-Bit CCIR656 Output |
相關代理商/技術參數 |
參數描述 |
|---|---|
| ADV7183BBSTZ | 功能描述:IC VIDEO DECODER NTSC 80-LQFP RoHS:是 類別:集成電路 (IC) >> 接口 - 編碼器，解碼器，轉換器 系列:- 產品變化通告:Development Systems Discontinuation 26/Apr/2011 標準包裝:1 系列:- 類型:編碼器 應用:DVB-S.2 系統 電壓 - 電源，模擬:- 電壓 - 電源，數字:- 安裝類型:- 封裝/外殼:模塊 供應商設備封裝:模塊 包裝:散裝 其它名稱:Q4645799 |
| ADV7183BKST | 制造商:Analog Devices 功能描述:MULTIFORMAT SDTV VID DECODER 80LQFP - Bulk |
| ADV7183BKSTZ | 功能描述:IC VIDEO DECODER NTSC 80-LQFP RoHS:是 類別:集成電路 (IC) >> 接口 - 編碼器，解碼器，轉換器 系列:- 產品變化通告:Development Systems Discontinuation 26/Apr/2011 標準包裝:1 系列:- 類型:編碼器 應用:DVB-S.2 系統 電壓 - 電源，模擬:- 電壓 - 電源，數字:- 安裝類型:- 封裝/外殼:模塊 供應商設備封裝:模塊 包裝:散裝 其它名稱:Q4645799 |
| ADV7183KST | 制造商:Analog Devices 功能描述:Video Decoder 2ADC 10-Bit 80-Pin LQFP 制造商:Rochester Electronics LLC 功能描述:VIDEO DECODER I.C. - Bulk |
| ADV7184 | 制造商:AD 制造商全稱:Analog Devices 功能描述:Multiformat SDTV Video Decoder with Fast Switch Overlay Support |
發布緊急采購，3分鐘左右您將得到回復。