- 您現在的位置：買賣IC網 > PDF目錄374047 > ADV7183B (Analog Devices, Inc.) Multiformat SDTV Video Decoder PDF資料下載
參數資料
| 型號： | ADV7183B |
| 廠商： | Analog Devices, Inc. |
| 英文描述： | Multiformat SDTV Video Decoder |
| 中文描述： | 標清多格式視頻解碼器 |
| 文件頁數： | 33/100頁 |
| 文件大小： | 844K |
| 代理商： | ADV7183B |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁當前第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁
ADV7183B
CG[11:0] Chroma Gain, Address 0x2D[3:0]; Address
0x2E[7:0] CMG[11:0] Chroma Manual Gain, Address
0x2D[3:0]; Address 0x2E[7:0]
Chroma Gain[11:0] is a dual-function
register. If written to, a
desired manual chroma gain can be programmed. This gain
becomes active if the CAGC[1:0] mode is switched to manual
fixed gain. Refer to Equation 2 for calculating a desired gain. If
read back, this register returns the current gain value. Depending
on the setting in the CAGC[1:0] bits, one of these gain values is
returned
Rev. B | Page 33 of 100
Chroma manual gain value (CAGC[1:0] set to chroma
manual gain mode)
Chroma automatic gain value (CAGC[1:0] set to any of the
automatic modes)
Table 41. CG/CMG Function
CG[11:0]/CMG[11:0]
Read/Write
CMG[11:0]
Write
Description
Manual gain for chroma
path
Currently active gain
CG[11:0]
Read
(
)
4
...
0
1024
4095
0
_
=
≤
<
=
CG
Gain
Chroma
(2)
For example, freezing the automatic gain loop and reading back
the CG[11:0] register results in a value of 0x47A.
1.
Convert the readback value to decimal:
0x47A = 1146d
2.
Apply Equation 2 to convert the readback value:
1146/1024 = 1.12
CKE Color Kill Enable, Address 0x2B[6]
The color kill enable bit allows the optional color kill function
to be switched on or off.
For QAM-based video standards (PAL and NTSC) and FM-
based systems (SECAM), the threshold for the color kill
decision is selectable via the CKILLTHR[2:0] bits.
If color kill is enabled, and if the color carrier of the incoming
video signal is less than the threshold for 128 consecutive video
lines, color processing is switched off (black and white output).
To switch the color processing back on, another 128 consecutive
lines with a color burst greater than the threshold are required.
The color kill option works only for input signals with a modu-
lated chroma part. For component input (YPrPb), there is no
color kill.
Setting CKE to 0 disables color kill.
Setting CKE to 1 (default) enables color kill.
CKILLTHR[2:0] Color Kill Threshold,
Address 0x3D[6:4]
The CKILLTHR[2:0] bits allow the user to select a threshold for
the color kill function. The threshold applies only to QAM
based (NTSC and PAL) or FM-modulated (SECAM) video
standards.
To enable the color kill function, the CKE bit must be set. For
settings 000, 001, 010, and 011, chroma demodulation inside
the ADV7183B may not work satisfactorily for poor input video
signals.
Table 42. CKILLTHR Function
CKILLTHR[2:0]
SECAM
000
No color kill
001
Kill at < 5%
010
Kill at < 7%
011
Kill at < 8%
100 (default)
Kill at < 9.5%
101
Kill at < 15%
110
Kill at < 32%
111
Reserved for ADI internal use only; do not
select
CHROMA TRANSIENT IMPROVEMENT (CTI)
The signal bandwidth allocated for chroma is typically much
smaller than that of luminance. In the past, this was a valid way
to fit a color video signal into a given overall bandwidth because
the human eye is less sensitive to chrominance than to
luminance.
Description
NTSC, PAL
Kill at < 0.5%
Kill at < 1.5%
Kill at < 2.5%
Kill at < 4.0%
Kill at < 8.5%
Kill at < 16.0%
Kill at < 32.0%
The uneven bandwidth, however, can lead to visual artifacts in
sharp color transitions. At the border of two bars of color, both
components (luma and chroma) change at the same time (see
197H
Figure 18). Due to the higher bandwidth, the signal transition
of the luma component is usually much sharper than that of the
chroma component. The color edge is not sharp but blurred, in
the worst case, over several pixels.
LUMA
SIGNAL
DEMODULATED
CHROMA
SIGNAL
LUMA SIGNAL WITH A
TRANSITION, ACCOMPANIED
BY A CHROMA TRANSITION
ORIGINAL, SLOW CHROMA
TRANSITION PRIOR TO CTI
SHARPENED CHROMA
TRANSITION AT THE
OUTPUT OF CTI
0
Figure 18. CTI Luma/Chroma Transition
相關PDF資料 |
PDF描述 |
|---|---|
| ADV7183BBSTZ | Multiformat SDTV Video Decoder |
| ADV7183BKSTZ | Multiformat SDTV Video Decoder |
| ADV7183KST | Advanced Video Decoder with 10-Bit ADC and Component Input Support |
| AD7183 | Advanced Video Decoder with 10-Bit ADC and Component Input Support |
| ADV7185 | Professional NTSC/PAL Video Decoder with 10-Bit CCIR656 Output |
相關代理商/技術參數 |
參數描述 |
|---|---|
| ADV7183BBSTZ | 功能描述:IC VIDEO DECODER NTSC 80-LQFP RoHS:是 類別:集成電路 (IC) >> 接口 - 編碼器，解碼器，轉換器 系列:- 產品變化通告:Development Systems Discontinuation 26/Apr/2011 標準包裝:1 系列:- 類型:編碼器 應用:DVB-S.2 系統 電壓 - 電源，模擬:- 電壓 - 電源，數字:- 安裝類型:- 封裝/外殼:模塊 供應商設備封裝:模塊 包裝:散裝 其它名稱:Q4645799 |
| ADV7183BKST | 制造商:Analog Devices 功能描述:MULTIFORMAT SDTV VID DECODER 80LQFP - Bulk |
| ADV7183BKSTZ | 功能描述:IC VIDEO DECODER NTSC 80-LQFP RoHS:是 類別:集成電路 (IC) >> 接口 - 編碼器，解碼器，轉換器 系列:- 產品變化通告:Development Systems Discontinuation 26/Apr/2011 標準包裝:1 系列:- 類型:編碼器 應用:DVB-S.2 系統 電壓 - 電源，模擬:- 電壓 - 電源，數字:- 安裝類型:- 封裝/外殼:模塊 供應商設備封裝:模塊 包裝:散裝 其它名稱:Q4645799 |
| ADV7183KST | 制造商:Analog Devices 功能描述:Video Decoder 2ADC 10-Bit 80-Pin LQFP 制造商:Rochester Electronics LLC 功能描述:VIDEO DECODER I.C. - Bulk |
| ADV7184 | 制造商:AD 制造商全稱:Analog Devices 功能描述:Multiformat SDTV Video Decoder with Fast Switch Overlay Support |
發布緊急采購，3分鐘左右您將得到回復。