- 您現在的位置：買賣IC網 > PDF目錄379665 > AMBE2000 (Electronic Theatre Controls, Inc.) VOCODER CHIP PDF資料下載
參數資料
| 型號： | AMBE2000 |
| 廠商： | Electronic Theatre Controls, Inc. |
| 英文描述： | VOCODER CHIP |
| 中文描述： | 聲碼器芯片 |
| 文件頁數： | 44/47頁 |
| 文件大小： | 324K |
| 代理商： | AMBE2000 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁當前第44頁第45頁第46頁第47頁
AMBE-2000 Vocoder Chip
User’s Manual Version 3.0
page 44
Visit us at
www.dvsinc.com
Confidential Proprietary, Subject to Change
0.25 > (1/N) > Average-Frame-Interval * Sample-Rate * (Frame-Drift + Sample-Drift)
For example with an Average-Frame-Interval = .02 (i.e. 20 ms) and a Sample-Rate = 8000, then with 100 parts per million
oscillator accuracy (i.e. Frame-Drift = Sample-Drift = .0001), then above constraint equates to 4 < N < 31.25, and N=30 would
be a reasonable selection. In this case the system would input the specified Slip Control Packet into the AMBE-20X0 vocoder
chip every 30’th frame enabling the vocoder chip to adjust for the actual clock drift.
***RECOMMENDED***
Method 3 - Extended Slip Control with as needed Slip Control Packets
The preferred method for using Slip Control Packets is to monitor the availability of data from the AMBE-2000 vocoder chip
and to only input Slip Control Packets into the data stream sent to the AMBE-2000 as needed. Note that for this method slip
control must be enabled (SLIP_EN is high) on the chip. This method provides compensation for the widest range of clock drift
(1.2% or 12000 ppm), with the greatest flexibility in frame-interval and sample-rate timing. In this method the same Slip
Control Packets shown in Table 7D are inserted into the data stream going to the AMBE-2000. However, unlike in the
Periodic method, the packets are not input at regular intervals but are instead only input to the chip when needed. The
recommended procedure for this Method of Slip Control is for the system to read a packet from the AMBE-2000 at regular
fixed frame intervals where the fixed interval must be within the range [19.875 – 20.125] ms for a sample rate = 8000 Hz. The
system application should check each word output by the AMBE-2000 and should continue requesting words from the chip
until the packet Header followed by 23 data words are received. If the words received before the Header word consist of only a
single termination word (0xfffe) then no further action is required. However if two or more termination words are received
prior to the Header then the system should input a Slip Control Packet to the AMBE-2000 on the next available transmission
into the chip (i.e. the next packet going into the AMBE-2000 decoder should be a Slip Control Packet). Once this Slip Control
Packet is input into the AMBE-2000 it will respond within 1-2 frames by advancing the time when packets are ready for
transmission by 125 microseconds. Note that this procedure also may require a small amount of buffering in the system to
account for the fact that the packet my not be ready for some small time (< 125 microseconds) after it is first requested.
相關PDF資料 |
PDF描述 |
|---|---|
| AMC0802A | CONTOUR DRAWING & BLOCK DIAGRAM |
| AMC317 | 1.5A / 3- TERMINAL ADJUSTABLE REGULATOR |
| AMC317T | 1.5A / 3- TERMINAL ADJUSTABLE REGULATOR |
| AMC317ST | 1.5A / 3- TERMINAL ADJUSTABLE REGULATOR |
| AMC5902 | 6CH Motor Driver for CD-ROM, DVD-ROM |
相關代理商/技術參數 |
參數描述 |
|---|---|
| AMB-EHS160 | 制造商:Schroff/Pentair Electronic Packaging 功能描述: |
| AMBF22 | 制造商:ABRACON 制造商全稱:Abracon Corporation 功能描述:MULTILAYER CHIP BALANCE-EMI FILTER |
| AMBI LIGHT SENSOR | 制造商:LIQUIDWARE 功能描述:Ambient Light Sensor |
| AMB-KIT1 | 功能描述:TEST LEAD SET FOR INSUL RESIST 制造商:amprobe 系列:AMB 包裝:袋 零件狀態:有效 套件類型:測試引線 內容:短頭鱷魚夾，測試引線，測試探針 標準包裝:1 |
| AMB-KIT2 | 制造商:Amprobe Test Tools 功能描述:10 KV SHIELDED LEAD WITH TIP FOR AMB-110 AMB-110 |
發布緊急采購，3分鐘左右您將得到回復。