- 您現在的位置：買賣IC網 > PDF目錄379665 > AMBE2000 (Electronic Theatre Controls, Inc.) VOCODER CHIP PDF資料下載
參數資料
| 型號： | AMBE2000 |
| 廠商： | Electronic Theatre Controls, Inc. |
| 英文描述： | VOCODER CHIP |
| 中文描述： | 聲碼器芯片 |
| 文件頁數： | 9/47頁 |
| 文件大小： | 324K |
| 代理商： | AMBE2000 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁當前第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁
AMBE-2000 Vocoder Chip
User’s Manual Version 3.0
page 9
Visit us at
www.dvsinc.com
Confidential Proprietary, Subject to Change
2.2.2
Channel Interface Overview
The channel interface is meant to be flexible to allow for easy integration with the system under design. The basic hardware
unit of the interface is a serial port. The serial mode can run in
passive
or
active
modes. Simply stated, the control signal for
serial mode can be derived by the AMBE-2000 chip or they can be derived externally.
Under normal operation, every 20msec the encoder outputs a frame of coded bits, and the decoder needs to be delivered a
frame of coded bits. There is some formatting of the data for both the encoder and the decoder. The primary purpose of the
formatting is to provide alignment information for the encoded bit stream. The data has two formats,
Formatted
and
Unformatted
. Serial mode can run in either
Formatted
or
Unformatted
mode.
The
Formatted
and
Unformatted
modes are explained in full detail in Section 4, but essentially the two formats are trying to
achieve the same function, to provide positional information regarding the outgoing and incoming coded data streams. In
Formatted
mode each 20msecs of output data from the encoder is preceded by a known structure. This structure also embeds
some status type flags, meant for local control purposes, within it. The only data from the
Formatted
format that is typically
sent across the transmission channel under design are the actual encoded bits at the desired rate.
In
Formatted
mode, it is the responsibility of the designed system to pass enough information along with the encoded bits such
that the
Formatted
format needed by the decoder can be reconstructed on the other side. This extra information, or overhead,
is going to be very specific to the system under design, but at a minimum needs to pass enough information to reliably
reconstruct the 20msec frame structure at the other end for the decoder.
In
Unformatted
mode the data coming out of the encoder can be thought of as a continuous stream of voice data with the
framing information embedded within the encoded bits. One advantage of this type of set-up is that the system does not have
to add any bandwidth for overhead to the channel. The disadvantage is that the decoder needs 10-12 incoming frames in order
to gain synchronization with the data stream before it can properly synthesize the speech waveform. Also, the
Unformatted
mode only commits a single bit per frame to maintaining data alignment. In higher error rate channels the performance will be
improved by adding more bits per frame to the alignment information (which is more easily performed when using
Formatted
mode)
Additional flexibility is given to the channel interface to the encoder and decoder by allowing the AMBE-2000 Vocoder
Chip to run in
Passive
or
Active
modes. In Passive mode, data strobes are provided by an external source, while in Active
mode, data strobes are provided by the AMBE-2000 Vocoder Chip. The serial interfaces can be run in Passive or Active
modes. See Section 4 for full details and timing for both
Formatted
and
Unformatted
data.
2.2.3
Speech and FEC Rate Selection Overview
The total coded bit rate is the sum of two components, the Speech Data and the Forward Error Correction (FEC) Data. The
addition of FEC data to the speech data allows the decoder to be able to correct a limited amount of errors within each frame
should they arrive corrupted. If the channel is expected to have more errors then more bits should be dedicated to FEC. At the
same time, voice quality will increase if the number of speech bits can be maximized.
相關PDF資料 |
PDF描述 |
|---|---|
| AMC0802A | CONTOUR DRAWING & BLOCK DIAGRAM |
| AMC317 | 1.5A / 3- TERMINAL ADJUSTABLE REGULATOR |
| AMC317T | 1.5A / 3- TERMINAL ADJUSTABLE REGULATOR |
| AMC317ST | 1.5A / 3- TERMINAL ADJUSTABLE REGULATOR |
| AMC5902 | 6CH Motor Driver for CD-ROM, DVD-ROM |
相關代理商/技術參數 |
參數描述 |
|---|---|
| AMB-EHS160 | 制造商:Schroff/Pentair Electronic Packaging 功能描述: |
| AMBF22 | 制造商:ABRACON 制造商全稱:Abracon Corporation 功能描述:MULTILAYER CHIP BALANCE-EMI FILTER |
| AMBI LIGHT SENSOR | 制造商:LIQUIDWARE 功能描述:Ambient Light Sensor |
| AMB-KIT1 | 功能描述:TEST LEAD SET FOR INSUL RESIST 制造商:amprobe 系列:AMB 包裝:袋 零件狀態:有效 套件類型:測試引線 內容:短頭鱷魚夾，測試引線，測試探針 標準包裝:1 |
| AMB-KIT2 | 制造商:Amprobe Test Tools 功能描述:10 KV SHIELDED LEAD WITH TIP FOR AMB-110 AMB-110 |
發布緊急采購，3分鐘左右您將得到回復。