欧美成人免费电影,国产欧美一区二区三区精品酒店,精品国产a毛片,色网在线免费观看

參數資料
型號: MC68C912B32FU8
廠商: MOTOROLA INC
元件分類: 微控制器/微處理器
英文描述: 16-Bit Microcontroller
中文描述: 16-BIT, FLASH, 8 MHz, MICROCONTROLLER, PQFP80
封裝: QFP-80
文件頁數: 28/128頁
文件大小: 748K
代理商: MC68C912B32FU8
MOTOROLA
28
MC68HC912B32
MC68HC912B32TS/D
EME — Emulate Port E
Removing the registers from the map allows the user to emulate the function of these registers exter-
nally. In single-chip mode PORTE and DDRE are always in the map regardless of the state of this bit.
0 = PORTE and DDRE are in the memory map.
1 = PORTE and DDRE are removed from the internal memory map (expanded mode).
Normal modes: write once; special modes: write anytime EXCEPT the first time. Read anytime.
5.3 Internal Resource Mapping
The internal register block, RAM, Flash EEPROM and EEPROM have default locations within the 64-
Kbyte standard address space but may be reassigned to other locations during program execution by
setting bits in mapping registers INITRG, INITRM, and INITEE. During normal operating modes these
registers can be written once. It is advisable to explicitly establish these resource locations during the
initialization phase of program execution, even if default values are chosen, in order to protect the reg-
isters from inadvertent modification later.
Writes to the mapping registers go into effect between the cycle that follows the write and the cycle after
that. To assure that there are no unintended operations, a write to one of these registers should be fol-
lowed with a NOP instruction.
If conflicts occur when mapping resources, the register block will take precedence over the other re-
sources; RAM, Flash EEPROM, or EEPROM addresses occupied by the register block will not be avail-
able for storage. When active, BDM ROM takes precedence over other resources although a conflict
between BDM ROM and register space is not possible.
Table 10
shows resource mapping precedence.
All address space not utilized by internal resources is by default external memory. The memory expan-
sion module manages three memory overlay windows: program, data, and one extra page overlay. The
size and location of the program and data overlay windows are fixed. One of two locations can be se-
lected for the extra page (EPAGE).
5.3.1 Register Block Mapping
After reset the 512 byte register block resides at location $0000 but can be reassigned to any 2-Kbyte
boundary within the standard 64-Kbyte address space. Mapping of internal registers is controlled by five
bits in the INITRG register. The register block occupies the first 512 bytes of the 2-Kbyte block.
REG[15:11] — Internal register map position
These bits specify the upper five bits of the 16-bit registers address.
Write once in normal modes or anytime in special modes. Read anytime.
Table 10 Mapping Precedence
Precedence
1
2
3
4
5
6
Resource
BDM ROM (if active)
Register Space
RAM
EEPROM
Flash EEPROM
External Memory
INITRG —
Initialization of Internal Register Position Register
$0011
Bit 7
6
5
4
3
2
1
Bit 0
REG15
REG14
REG13
REG12
REG11
0
0
MMSWAI
RESET:
0
0
0
0
0
0
0
0
相關PDF資料
PDF描述
MC68B912B32FU8 16-Bit Microcontroller
MC68C912B32CFU8 16-Bit Microcontroller
MC68CK338 Highly Integrated, Low-Power, 32-Bit Microcontroller
MC68EC060 32-Bit Microprocessors.(32位微處理器)
MC68EN360RC25V QUad Integrated Communications Controller Users Manual
相關代理商/技術參數
參數描述
MC68CK16Z1 制造商:FREESCALE 制造商全稱:Freescale Semiconductor, Inc 功能描述:M68HC16Z Series
MC68CK16Z1CAG16 功能描述:16位微控制器 - MCU 16BIT 1KRAM 32KHZ CRYSTAL RoHS:否 制造商:Texas Instruments 核心:RISC 處理器系列:MSP430FR572x 數據總線寬度:16 bit 最大時鐘頻率:24 MHz 程序存儲器大小:8 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:2 V to 3.6 V 工作溫度范圍:- 40 C to + 85 C 封裝 / 箱體:VQFN-40 安裝風格:SMD/SMT
MC68CK16Z1CAG16 制造商:Freescale Semiconductor 功能描述:Microcontroller
MC68CK16Z1CFC16 制造商:FREESCALE 制造商全稱:Freescale Semiconductor, Inc 功能描述:M68HC16Z Series
MC68CK16Z1CPV16 功能描述:16位微控制器 - MCU 16 Bit 16MHz RoHS:否 制造商:Texas Instruments 核心:RISC 處理器系列:MSP430FR572x 數據總線寬度:16 bit 最大時鐘頻率:24 MHz 程序存儲器大小:8 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:2 V to 3.6 V 工作溫度范圍:- 40 C to + 85 C 封裝 / 箱體:VQFN-40 安裝風格:SMD/SMT
主站蜘蛛池模板: 阿拉善左旗| 陆川县| 禹州市| 广东省| 山西省| 临海市| 全州县| 长武县| 安平县| 黔西县| 牟定县| 叙永县| 瑞金市| 志丹县| 昌乐县| 黄平县| 新龙县| 安化县| 政和县| 顺平县| 潢川县| 扎兰屯市| 株洲市| 巴彦淖尔市| 鹤壁市| 涿鹿县| 隆尧县| 伊春市| 新乡县| 邹平县| 射洪县| 苍溪县| 婺源县| 泰州市| 金山区| 遂昌县| 靖远县| 闻喜县| 铁岭县| 金川县| 翼城县|