- 您現在的位置：買賣IC網 > PDF目錄98229 > THS8083CPZP (TEXAS INSTRUMENTS INC) SPECIALTY CONSUMER CIRCUIT, PQFP100 PDF資料下載
參數資料
| 型號： | THS8083CPZP |
| 廠商： | TEXAS INSTRUMENTS INC |
| 元件分類： | 消費家電 |
| 英文描述： | SPECIALTY CONSUMER CIRCUIT, PQFP100 |
| 封裝： | POWER, THERMALLY ENHANCED, PLASTIC, TQFP-100 |
| 文件頁數： | 9/61頁 |
| 文件大小： | 266K |
| 代理商： | THS8083CPZP |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁當前第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁
2–3
Ext. Logic
PFD_FREEZE
CS
THS8083
HS
Frame Period
PFD_FREEZE High in VBI on Lines Where CS
Has Multiple Rising/Falling Edges Per Line
Option 1: Using PFD_FREEZE
Sync.
Separator
CS
THS8083
HS
Option 2: Using HS Derived From CS
PFD_FREEZE
VS
Figure 2–4. Using THS8083 With a Composite Sync
Note that the slicer will only work when no video levels are lower than the blanking level and when the internal clamp
circuit is used. This is normally satisfied for G and Y channels, but not for U and V channels. To prevent unnecessary
toggling of the CS output signal, the CS output is switched off automatically when mid-level clamping is chosen for
channel 1 (i.e., CLP1_RG=1 in register <CLP_CTRL>). CS can be permanently disabled by setting CS_DIS=1 in
register <AUX_CTRL>.
When CS is disabled, the CS output will be Hi-Z.
NOTE:
While PFD_FREEZE keeps the DTO output frequency constant, it does not disable the
phase/frequency detector (PFD) from internally updating its error value at every active edge
on HS. Therefore, when deasserting PFD_FREEZE and no external sync separator is used,
a discontinuity on the frequency increment to the DTO occurs which will cause an
instantaneous frequency shift. To prevent this, the user should gate the CS signal externally
with the PFD_FREEZE signal as shown in Figure 2.4. This will keep the PFD from updating
during PFD_FREEZE high, since HS will remain low during the VBI. By using both
PFD_FREEZE and gating during the vertical blanking interval, THS8083 can be locked to
signals with a composite sync.
To support sync-on-Y/sync-on-G extraction, the user should provide an external dc biasing to
the Y/G channel. This can be done by establishing a dc clamp through a diode with its cathode
connected to the ac-coupling capacitor (at the side of THS8083) on the AGY channel and
anode connected to a dc level. Since the slicing level is around 1.35 V and the sync amplitude
is ~300 mV, the negative sync-tip should be clamped by the diode to a level of approximately
1.2 V. For example, using a Schottky switching diode (type 1N5711) with a low forward voltage
drop of maximum 0.4 V, the dc level at the anode can be approximately 1.6 V. This level can
be derived through a resistive voltage divider off the power supply.
相關PDF資料 |
PDF描述 |
|---|---|
| THS8133ACPHP | PARALLEL, WORD INPUT LOADING, 0.005 us SETTLING TIME, 10-BIT DAC, PQFP48 |
| THS8133BCPHP | PARALLEL, WORD INPUT LOADING, 0.005 us SETTLING TIME, 10-BIT DAC, PQFP48 |
| THS8133BCPHPG4 | PARALLEL, WORD INPUT LOADING, 0.005 us SETTLING TIME, 10-BIT DAC, PQFP48 |
| THS8133CPHP | PARALLEL, WORD INPUT LOADING, 0.005 us SETTLING TIME, 10-BIT DAC, PQFP48 |
| THS8134BCPHP | PARALLEL, 8 BITS INPUT LOADING, 0.005 us SETTLING TIME, 8-BIT DAC, PQFP48 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| THS8083EVM | 制造商:Texas Instruments 功能描述:THS8083EVM - Bulk |
| THS8083T | 制造商:TI 制造商全稱:Texas Instruments 功能描述:Triple 8-Bit, 80 MSPS, 3.3-V Video and Graphics Digitizer With Digital PLL |
| THS8-10R-D | 制造商:Thomas & Betts 功能描述:CATAMOUNT CABLE TIES |
| THS8133 | 制造商:TI 制造商全稱:Texas Instruments 功能描述:TRIPLE 10-BIT, 80 MSPS VIDEO D/A CONVERTER WITH TRI-LEVEL SYNC GENERATION WITH TRI-LEVEL SYNC GENERATION |
| THS8133_07 | 制造商:TI 制造商全稱:Texas Instruments 功能描述:TRIPLE 10-BIT, 80 MSPS VIDEO D/A CONVERTER WITH TRI-LEVEL SYNC GENERATION WITH TRI-LEVEL SYNC GENERATION |
發布緊急采購，3分鐘左右您將得到回復。