- 您現在的位置：買賣IC網 > Datasheet目錄47 > TPS24711DGSR (Texas Instruments)IC CTRLR HOT SWAP 2.5-18V 10MSOP Datasheet資料下載
參數資料
| 型號： | TPS24711DGSR |
| 廠商： | Texas Instruments |
| 文件頁數： | 22/34頁 |
| 文件大小： | 2792K |
| 描述： | IC CTRLR HOT SWAP 2.5-18V 10MSOP |
| 標準包裝： | 1 |
| 類型： | 熱交換控制器 |
| 應用： | 通用 |
| 內部開關： | 無 |
| 電流限制： | 可調 |
| 電源電壓： | 2.5 V ~ 18 V |
| 工作溫度： | -40°C ~ 85°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 10-TFSOP，10-MSOP（0.118"，3.00mm 寬） |
| 供應商設備封裝： | 10-MSOP |
| 包裝： | 標準包裝 |
| 其它名稱： | 296-28562-6 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁當前第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁
(
)
VCC SENSE
SENSE
LIM
SENSE
V
,
I
herefore,
25 mV
2 m
-
=
=
?/DIV>
W
LOAD
PROTECTION
0.1 F
0.1 F
-
M
1
12-VMainBusSupply
TIMER
TPS2471x
Specifications(atOutput):
PeakCurrentLimit=12 A
NominalCurrent=10 A
R
1.2
LOAD
W
C
470 F
OUT
C
T
R
SENSE
R
GATE
TPS24710,TPS24711
TPS24712,TPS24713
SLVSAL2E JANUARY 2011REVISED NOVEMBER 2013
www.ti.com
DESIGN EXAMPLE: POWER-LIMITED START-UP
This design example assumes a 12-V system voltage with an operating tolerance of ? V. The rated load current
is 10 A, corresponding to a dc load of 1.2 &. If the current exceeds 12 A, then the controller should shut down
and then attempt to restart. Ambient temperatures may range from 20癈 to 50癈. The load has a minimum input
capacitance of 470 糉. Figure 34 shows a simplified system block diagram of the proposed application.
This design procedure seeks to control the junction temperature of MOSFET M
1
under both static and transient
conditions by proper selection of package, cooling, r
DS(on)
, current limit, fault timeout, and power limit. The design
procedure further assumes that a unit running at full load and maximum ambient temperature experiences a brief
input-power interruption sufficient to discharge C
OUT
, but short enough to keep M
1
from cooling. A full C
OUT
recharge then takes place. Adjust this procedure to fit your application and design criteria.
Figure 34. Simplified Block Diagram of the System Constructed in the Design Example
STEP 1. Choose R
SENSE
From the TPS24710/11/12/13 electrical specifications, the current-limit threshold voltage, V
(VCC SENSE)
, is around
25 mV. A resistance of 2 m& is selected for the peak current limit of 12 A, while dissipating only 200 mW at the
rated 10-A current (see Equation 5). This represents a 0.17% power loss.
(5)
STEP 2. Choose MOSFET M
1
The next design step is to select M
1
. The TPS24710/11/12/13 is designed to use an N-channel MOSFET with a
gate-to-source voltage rating of 20 V.
Devices with lower gate-to-source voltage ratings can be used if a Zener diode is connected so as to limit the
maximum gate-to-source voltage across the transistor.
The next factor to consider is the drain-to-source voltage rating, V
DS(MAX)
, of the MOSFET. Although the
MOSFET only sees 12 V DC, it may experience much higher transient voltages during extreme conditions, such
as the abrupt shutoff that occurs during a fast trip. A TVS may be required to limit inductive transients under such
conditions. A transistor with a V
DS(MAX)
rating of at least twice the nominal input power-supply voltage is
recommended regardless of whether a TVS is used or not.
22
Submit Documentation Feedback
Copyright ?20112013, Texas Instruments Incorporated
Product Folder Links: TPS24710 TPS24711 TPS24712 TPS24713
相關PDF資料 |
PDF描述 |
|---|---|
| TPS2491DGSG4 | IC POS HV HOT-SWAP CTRLR 10-MSOP |
| W83772G | IC H/W MONITOR 8-TSSOP |
| W83L786G | IC H/W MONITOR 28-SSOP |
| X96011V14IZ | IC SENSOR TEMP BIAS SGL 14-TSSOP |
| XR4151CP-F | IC CONV VF/FV 8PDIP |
相關代理商/技術參數 |
參數描述 |
|---|---|
| TPS24711EVM-004 | 功能描述:電源管理IC開發工具 TPS24711 Eval Mod RoHS:否 制造商:Maxim Integrated 產品:Evaluation Kits 類型:Battery Management 工具用于評估:MAX17710GB 輸入電壓: 輸出電壓:1.8 V |
| TPS24712DGS | 功能描述:熱插拔功率分布 2.5-18V Hi Eff Pwr- Ltd Hot-Swap Cntrlr RoHS:否 制造商:Texas Instruments 產品:Controllers & Switches 電流限制: 電源電壓-最大:7 V 電源電壓-最小:- 0.3 V 工作溫度范圍: 功率耗散: 安裝風格:SMD/SMT 封裝 / 箱體:MSOP-8 封裝:Tube |
| TPS24712DGSR | 功能描述:熱插拔功率分布 2.5-18V Hi Eff Pwr- Ltd Hot-Swap Cntrlr RoHS:否 制造商:Texas Instruments 產品:Controllers & Switches 電流限制: 電源電壓-最大:7 V 電源電壓-最小:- 0.3 V 工作溫度范圍: 功率耗散: 安裝風格:SMD/SMT 封裝 / 箱體:MSOP-8 封裝:Tube |
| TPS24713DGS | 功能描述:熱插拔功率分布 2.5-18V Hi Eff Hot- Swap Controller RoHS:否 制造商:Texas Instruments 產品:Controllers & Switches 電流限制: 電源電壓-最大:7 V 電源電壓-最小:- 0.3 V 工作溫度范圍: 功率耗散: 安裝風格:SMD/SMT 封裝 / 箱體:MSOP-8 封裝:Tube |
| TPS24713DGSR | 功能描述:熱插拔功率分布 2.5-18V Hi Eff Hot- Swap Controller RoHS:否 制造商:Texas Instruments 產品:Controllers & Switches 電流限制: 電源電壓-最大:7 V 電源電壓-最小:- 0.3 V 工作溫度范圍: 功率耗散: 安裝風格:SMD/SMT 封裝 / 箱體:MSOP-8 封裝:Tube |
發布緊急采購，3分鐘左右您將得到回復。