- 您現在的位置：買賣IC網 > PDF目錄98282 > TPS51220ARTVR (TEXAS INSTRUMENTS INC) DUAL SWITCHING CONTROLLER, 333 kHz SWITCHING FREQ-MAX, PQCC32 PDF資料下載
參數資料
| 型號： | TPS51220ARTVR |
| 廠商： | TEXAS INSTRUMENTS INC |
| 元件分類： | 穩壓器 |
| 英文描述： | DUAL SWITCHING CONTROLLER, 333 kHz SWITCHING FREQ-MAX, PQCC32 |
| 封裝： | 5 X 5 MM, PLASTIC, QFN-32 |
| 文件頁數： | 15/53頁 |
| 文件大小： | 1380K |
| 代理商： | TPS51220ARTVR |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁當前第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁
SLUS897D – DECEMBER 2008 – REVISED FEBRUARY 2010
www.ti.com
3.3-V, 10-mA LDO (VREG3)
A 3.3-V, 10-mA, linear regulator is integrated in the TPS51220A. This LDO services some of the analog circuit in
the device and provides a handy standby supply for 3.3-V Always On voltage in the notebook system. Apply a
2.2-mF (at least 1-mF), high quality X5R or X7R ceramic capacitor from VREG3 to (signal) GND in adjacent to the
device.
2-V, 100-mA Sink/Source Reference (VREF2)
This voltage is used for the reference of the loop compensation network. Apply a 0.22-mF (at least 0.1-mF),
high-quality X5R or X7R ceramic capacitor from VREF2 to (signal) GND in adjacent to the device.
5.0-V, 100-mA LDO (VREG5)
A 5.0-V, 100-mA, linear regulator is integrated in the TPS51220A. This LDO services the main analog supply rail
and provides the current for gate drivers until switch-over function becomes enable. Apply a 10-mF (at least
4.7-mF), high-quality X5R or X7R ceramic capacitor from VREG5 to (power) GND in adjacent to the device.
VREG5 SWITCHOVER
When EN1 is high, PGOOD1 indicates GOOD and a voltage of more than 4.8 V is applied to V5SW, the internal
5V-LDO is shut off and the VREG5 is shorted to V5SW by an internal MOSFET after an 7.7-ms delay. When the
V5SW voltage becomes lower than 4.65 V, EN1 becomes low, or PGOOD1 indicates BAD, the internal switch is
turned off, and the internal 5V-LDO resumes immediately.
BASIC PWM OPERATIONS
The main control loop of the SMPS is designed as a fixed frequency, pulse width modulation (PWM) controller. It
supports two control schemes; a peak current mode and a proprietary D-CAP mode. Current mode achieves
stable operation with any type of output capacitors, including low ESR capacitor(s) such as ceramic or specialty
polymer capacitors. D-CAP mode does not require an external compensation circuit, and is suitable for relatively
larger ESR capacitor(s) configuration. These control schemes are selected with FUNC pin. See Table 4.
CURRENT MODE
The current mode scheme uses the output voltage information and the inductor current information to regulate
the output voltage. The output voltage information is sensed by VFBx pin. The signal is compared with the
internal 1-V reference and the voltage difference is amplified by a transconductance amplifier (VFB-AMP). The
inductor current information is sensed by CSPx and CSNx pins. The voltage difference is amplified by another
transconductance amplifier (CS-AMP). The output of the VFB-AMP indicates the target peak inductor current. If
the output voltage decreases, the TPS51220A increases the target inductor current to raise the output voltage.
Alternatively, if the output voltage rises, the TPS51220A decreases the target inductor current to reduce the
output voltage.
At the beginning of each clock cycle, the high-side MOSFET is turned on, or becomes ‘ON’ state. The high-side
MOSFET is turned off, or becomes OFF state, after the inductor current becomes the target value which is
determined by the combination value of the output of the VFB-AMP and a ramp compensation signal. The ramp
compensation signal is used to prevent sub-harmonic oscillation of the inductor current control loop. The
high-side MOSFET is turned on again at the next clock cycle. By repeating the operation in this manner, the
controller regulates the output voltage. The synchronous low-side or the rectifying MOSFET is turned on each
OFF state to keep the conduction loss minimum.
D-CAP MODE
With the D-CAP mode operation, the PWM comparator compares VREF2 with the combination value of the
COMP voltage, VFB-AMP output, and the ramp compensation signal. When the both signals are equal at the
peak of the voltage sense signal, the comparator provides the OFF signal to the high-side MOSFET driver.
Because the compensation network is implemented on the part and the output waveform itself is used as the
error signal, external circuit is simplified. Another advantage is its inherent fast transient response. A trade-off is
a sufficient amount of ESR required in the output capacitor. The D-CAP mode is suitable for relatively larger
output ripple voltage application. The inductor current information is used for the overcurrent protection and light
load operation.
22
Copyright 2008–2010, Texas Instruments Incorporated
Product Folder Link(s) :TPS51220A
相關PDF資料 |
PDF描述 |
|---|---|
| TPS51221RTVRG4 | DUAL SWITCHING CONTROLLER, 333 kHz SWITCHING FREQ-MAX, PQCC32 |
| TPS51315RGFR | SWITCHING REGULATOR, 1000 kHz SWITCHING FREQ-MAX, PQCC40 |
| TPS51315RGFT | SWITCHING REGULATOR, 1000 kHz SWITCHING FREQ-MAX, PQCC40 |
| TPS51317RGBT | SWITCHING REGULATOR, 1500 kHz SWITCHING FREQ-MAX, PQCC20 |
| TPS51317RGBR | SWITCHING REGULATOR, 1500 kHz SWITCHING FREQ-MAX, PQCC20 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| TPS51220ARTVT | 功能描述:電流型 PWM 控制器 Fixed-Freq,Notebook Sys Pwr Controller RoHS:否 制造商:Texas Instruments 開關頻率:27 KHz 上升時間: 下降時間: 工作電源電壓:6 V to 15 V 工作電源電流:1.5 mA 輸出端數量:1 最大工作溫度:+ 105 C 安裝風格:SMD/SMT 封裝 / 箱體:TSSOP-14 |
| TPS51220ARTVT | 制造商:Texas Instruments 功能描述:Controller IC |
| TPS51220ATRTVRQ1 | 功能描述:電流型 PWM 控制器 Current-Mode NB Sys Pwr Controller RoHS:否 制造商:Texas Instruments 開關頻率:27 KHz 上升時間: 下降時間: 工作電源電壓:6 V to 15 V 工作電源電流:1.5 mA 輸出端數量:1 最大工作溫度:+ 105 C 安裝風格:SMD/SMT 封裝 / 箱體:TSSOP-14 |
| TPS51220EVM | 功能描述:電源管理IC開發工具 TPS51220EVM Hi Perf Synch Buck RoHS:否 制造商:Maxim Integrated 產品:Evaluation Kits 類型:Battery Management 工具用于評估:MAX17710GB 輸入電壓: 輸出電壓:1.8 V |
| TPS51220RHBR | 功能描述:電流型 PWM 控制器 Fixed Freq 99% Duty Cycle Peak Current RoHS:否 制造商:Texas Instruments 開關頻率:27 KHz 上升時間: 下降時間: 工作電源電壓:6 V to 15 V 工作電源電流:1.5 mA 輸出端數量:1 最大工作溫度:+ 105 C 安裝風格:SMD/SMT 封裝 / 箱體:TSSOP-14 |
發布緊急采購，3分鐘左右您將得到回復。