- 您現在的位置：買賣IC網 > PDF目錄98282 > TPS54320RHLR (TEXAS INSTRUMENTS INC) SWITCHING REGULATOR, 1320 kHz SWITCHING FREQ-MAX, PQCC14 PDF資料下載
參數資料
| 型號： | TPS54320RHLR |
| 廠商： | TEXAS INSTRUMENTS INC |
| 元件分類： | 穩壓器 |
| 英文描述： | SWITCHING REGULATOR, 1320 kHz SWITCHING FREQ-MAX, PQCC14 |
| 封裝： | 3.50 X 3.50 MM, GREEN, PLASTIC, QFN-14 |
| 文件頁數： | 3/39頁 |
| 文件大?。?/td> | 1358K |
| 代理商： | TPS54320RHLR |
第1頁第2頁當前第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁
Vout
Vref
R8
R9
Vref
-
=
www.ti.com
SLVS982A – AUGUST 2010 – REVISED SEPTEMBER 2010
Adjusting the Output Voltage
The output voltage is set with a resistor divider from the output (VOUT) to the VSENSE pin. It is recommended to
use 1% tolerance or better divider resistors. Referring to the application schematic of Figure 34, start with a 10
k
Ω resistor for R9 and use Equation 1 to calculate R8. To improve efficiency at light loads, consider using larger
value resistors. If the values are too high, the regulator is more susceptible to noise and voltage errors from the
VSENSE input current are noticeable.
(1)
Where Vref = 0.8V
The minimum output voltage and maximum output voltage can be limited by the minimum on time of the
high-side MOSFET and bootstrap voltage (BOOT-PH voltage) respectively. More discussions are located in
Safe Start-up into Pre-Biased Outputs
The device has been designed to prevent the low-side MOSFET from discharging a prebiased output. During
monotonic pre-biased startup, the low-side MOSFET is not allowed to turn on until the SS/TR pin voltage is
higher than the VSENSE pin voltage.
Error Amplifier
The device uses a transconductance error amplifier. The error amplifier compares the VSENSE pin voltage to the
lower of the SS/TR pin voltage or the internal 0.8V voltage reference. The transconductance of the error amplifier
is 1300 mA/V during normal operation. The frequency compensation network is connected between the COMP
pin and ground.
Slope Compensation
The device adds a compensating ramp to the switch current signal. This slope compensation prevents
sub-harmonic oscillations. The available peak inductor current remains constant over the full duty cycle range.
Enable and Adjusting Under-Voltage Lockout
The EN pin provides an electrical on/off control of the device. Once the EN pin voltage exceeds the threshold
voltage, the device starts operation. If the EN pin voltage is pulled below the threshold voltage, the regulator
stops switching and enters a low Iq state.
The EN pin has an internal pull-up current source, allowing the user to float the EN pin for enabling the device. If
an application requires controlling the EN pin, use an open drain or open collector output logic to interface with
the pin.
The device implements internal UVLO circuitry on the VIN pin. The device is disabled when the VIN pin voltage
falls below the internal VIN UVLO threshold. The internal VIN UVLO threshold has a hysteresis of 150mV.
If an application requires either a higher UVLO threshold on the VIN pin or a secondary UVLO on the PVIN pin,
in split rail applications, then the EN pin can be configured as shown in Figure 17, Figure 18 or Figure 19. When
using the external UVLO function, it is recommended to set the hysteresis to be greater than 500mV.
The EN pin has a small pull-up current Ip which sets the default state of the pin to enable when no external
components are connected. The pull-up current is also used to control the voltage hysteresis for the UVLO
function since it increases by Ih once the EN pin crosses the enable threshold. The UVLO thresholds can be
calculated using Equation 2 and Equation 3.
Copyright 2010, Texas Instruments Incorporated
11
Product Folder Link(s) :TPS54320
相關PDF資料 |
PDF描述 |
|---|---|
| TPS54320RHL | SWITCHING REGULATOR, PQCC14 |
| TPS54327DDAR | 5.7 A SWITCHING REGULATOR, 700 kHz SWITCHING FREQ-MAX, PDSO8 |
| TPS54328DDA | 5.7 A SWITCHING REGULATOR, 700 kHz SWITCHING FREQ-MAX, PDSO8 |
| TPS54328DDAR | 5.7 A SWITCHING REGULATOR, 700 kHz SWITCHING FREQ-MAX, PDSO8 |
| TPS54331DG4 | 2 A SWITCHING REGULATOR, 684 kHz SWITCHING FREQ-MAX, PDSO8 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| TPS54320RHLT | 功能描述:直流/直流開關調節器 4.5-17V Inp3A Sync Step Down Cnvrtr RoHS:否 制造商:International Rectifier 最大輸入電壓:21 V 開關頻率:1.5 MHz 輸出電壓:0.5 V to 0.86 V 輸出電流:4 A 輸出端數量: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:PQFN 4 x 5 |
| TPS54320RHLT | 制造商:Texas Instruments 功能描述:IC SYNC STEP-DOWN CONTROLLER 1.2MHZ Q 制造商:Texas Instruments 功能描述:IC, SYNC STEP-DOWN CONTROLLER, 1.2MHZ, QFN-14 |
| TPS54325 | 制造商:TI 制造商全稱:Texas Instruments 功能描述:4.5-V to 18-V, 3-A OUTPUT SYNCHRONOUS STEP DOWN SWITCHER WITH INTEGRATED FET (SWIFT?) |
| TPS54325_10 | 制造商:TI 制造商全稱:Texas Instruments 功能描述:4.5-V to 18-V, 3-A OUTPUT SYNCHRONOUS STEP DOWN SWITCHER WITH INTEGRATED FET (SWIFT?) |
| TPS54325EVM | 功能描述:電源管理IC開發工具 5-17V Input 3A SWIFT CVTR Eval RoHS:否 制造商:Maxim Integrated 產品:Evaluation Kits 類型:Battery Management 工具用于評估:MAX17710GB 輸入電壓: 輸出電壓:1.8 V |
發布緊急采購，3分鐘左右您將得到回復。