- 您現在的位置：買賣IC網 > PDF目錄98285 > TPS65167RHAT (TEXAS INSTRUMENTS INC) 4.9 A SWITCHING REGULATOR, 900 kHz SWITCHING FREQ-MAX, PQCC40 PDF資料下載
參數資料
| 型號： | TPS65167RHAT |
| 廠商： | TEXAS INSTRUMENTS INC |
| 元件分類： | 穩壓器 |
| 英文描述： | 4.9 A SWITCHING REGULATOR, 900 kHz SWITCHING FREQ-MAX, PQCC40 |
| 封裝： | 6 X 6 MM, GREEN, PLASTIC, MO-220VJJD-2, QFN-40 |
| 文件頁數： | 19/41頁 |
| 文件大小： | 1270K |
| 代理商： | TPS65167RHAT |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁當前第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁
www.ti.com
CTRL
VGH
VH
VL
T
td
Timing:
1. tdissetbythecapacitorCE
2.TheslopeissetbytheresistorRE
3. VL issetbythevoltageappliedtoVD
High Voltage Stress Test (positive charge pump)
Negative Charge Pump Driver
SLVS760C – APRIL 2007 – REVISED MARCH 2008
With CTRL=high, Q4 is turned on, and the charge pump output voltage is present at VGH. When the CTRL pin is
pulled low, then Q4 is turned off, and Q5 is turned on discharging VGH. The slope and time for discharging VGH
is determined by the LC Display capacitance and the termination on DRN. It is not required or recommended to
connect an additional output capacitor on VGH. There are three options available to terminate the DRN pin. The
chosen solution depends mainly on the LC Display capacitance and required overall converter efficiency.
Figure 28. High Voltage Switch (Gate Voltage Shaping) Timing Diagram
Option 1 in Figure 27 discharges VGH to Vs. The lower the resistor the faster the discharge.
Option 3 in Figure 27 constantly draws current from Vs due to the voltage divider connected to Vs. The
advantage of this solution is that the low level voltage VL is given by the voltage divider assuming the feedback
resistor values are small and allow to discharge the LC Display capacitance during the time, toff. Therefore, the
solution is not recommended for large display panels since the feedback divider resistors needs to be selected
too low which draws too much current from Vs.
Option 2 does not draw any current from Vs and; therefore, is better in terms of converter efficiency. The voltage
level VL where VGH is discharge to is determined by the LC Display capacitance, the resistor connected to DRN
and the off time, toff. The lower the resistor value connected to DRN the lower the discharge voltage level VL.
Adding any additional output capacitance to VGH is not recommend. If more capacitance is required, it needs to
be added to POUT instead.
The TPS65167 incorporates a high voltage stress test where the output voltage of the boost converter Vs and
the positive charge pump POUT are set to a higher output voltage compared to the nominal programmed output
voltage. The High Voltage Stress test is enabled by pulling HVS pin to high. This sets POUT, respectively VGH
to 30 V, and the output voltage of the boost converter Vs is programmed to a higher voltage determined by the
resistor connected to RHVS. With HVS = high, the RHVS pin is pulled to GND which sets the voltage for the
boost converter during High Voltage Stress.
The TPS65167A has the high voltage stress test for the positive charge pump POUT disabled. The high voltage
stress test function is only enabled for the boost converter Vs.
The negative charge pump provides a regulated output voltage set by the external resistor divider. The negative
charge pump inverts the input voltage applied to the SUPN pin and regulates it to the programmed voltage.
26
Copyright 2007–2008, Texas Instruments Incorporated
相關PDF資料 |
PDF描述 |
|---|---|
| TPS65170RHDT | 4.2 A SWITCHING REGULATOR, 900 kHz SWITCHING FREQ-MAX, PQCC28 |
| TPS65171RHAR | 4 A SWITCHED CAPACITOR REGULATOR, 900 kHz SWITCHING FREQ-MAX, PQCC40 |
| TPS65182BRGZT | POWER SUPPLY SUPPORT CKT, PQCC48 |
| TPS65182RGZT | POWER SUPPLY SUPPORT CKT, PQCC48 |
| TPS65182RGZR | POWER SUPPLY SUPPORT CKT, PQCC48 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| TPS65167RHATG4 | 功能描述:LCD 驅動器 12V/3.5A(I/O) 4-CH Multi-Converter RoHS:否 制造商:Maxim Integrated 數位數量:4.5 片段數量:30 最大時鐘頻率:19 KHz 工作電源電壓:3 V to 3.6 V 最大工作溫度:+ 85 C 最小工作溫度:- 20 C 封裝 / 箱體:PDIP-40 封裝:Tube |
| TPS65168RSBR | 功能描述:LCD 驅動器 Hi ResFully Prgrm LCD Bias IC RoHS:否 制造商:Maxim Integrated 數位數量:4.5 片段數量:30 最大時鐘頻率:19 KHz 工作電源電壓:3 V to 3.6 V 最大工作溫度:+ 85 C 最小工作溫度:- 20 C 封裝 / 箱體:PDIP-40 封裝:Tube |
| TPS65170EVM-559 | 功能描述:電源管理IC開發工具 TPS65170 Eval Mod RoHS:否 制造商:Maxim Integrated 產品:Evaluation Kits 類型:Battery Management 工具用于評估:MAX17710GB 輸入電壓: 輸出電壓:1.8 V |
| TPS65170RHDR | 功能描述:其他電源管理 LCD Bias Supply RoHS:否 制造商:Texas Instruments 輸出電壓范圍: 輸出電流:4 mA 輸入電壓范圍:3 V to 3.6 V 輸入電流: 功率耗散: 工作溫度范圍:- 40 C to + 110 C 安裝風格:SMD/SMT 封裝 / 箱體:VQFN-48 封裝:Reel |
| TPS65170RHDT | 功能描述:其他電源管理 LCD Bias Supply RoHS:否 制造商:Texas Instruments 輸出電壓范圍: 輸出電流:4 mA 輸入電壓范圍:3 V to 3.6 V 輸入電流: 功率耗散: 工作溫度范圍:- 40 C to + 110 C 安裝風格:SMD/SMT 封裝 / 箱體:VQFN-48 封裝:Reel |
發布緊急采購，3分鐘左右您將得到回復。