欧美成人免费电影,国产欧美一区二区三区精品酒店,精品国产a毛片,色网在线免费观看

參數資料
型號： TRF7960RHBR
廠商： TEXAS INSTRUMENTS INC
元件分類： 消費家電
英文描述： SPECIALTY CONSUMER CIRCUIT, PQCC32
封裝： 5 X 5 MM, GREEN, PLASTIC, QFN-32
文件頁數： 35/52頁
文件大?。?/td> 1023K
代理商： TRF7960RHBR
b7
b6
b5
b4
b3
b2
b1
b0
Start
Condition
Stop
Condition
SCLK
DataIN
DataOut
50ns
SLOU186F – AUGUST 2006 – REVISED AUGUST 2010
www.ti.com
5.7
Serial Interface Communication
When an SPI interface is required, parallel I/O pins, I/O_2, I/O_1, and I/O_0, must be hard wired
according to Table 5-31. On power up, the reader looks for the status of these pins; if they are not the
same (not all high, or not all low), the reader enters into one of two possible SPI modes.
The serial communications work in the same manner as the parallel communications with respect to the
FIFO, except for the following condition. On receiving an IRQ from the reader, the MCU reads the reader's
IRQ register to determine how to service the reader. After this, the MCU must to do a dummy read to clear
the reader's IRQ status register. The dummy read is required in SPI mode because the reader's IRQ
status register needs an additional clock cycle to clear the register. This is not required in parallel mode
because the additional clock cycle is included in the Stop condition.
A procedure for a dummy read is as follows:
A. Starting the dummy read:
(a) When using slave select (SS): set SS bit low.
(b) When not using SS: start condition is when SCLK is high (See Table 5-30).
B. Send address word to IRQ status register (0Ch) with read and continuous address mode bits set to 1
C. Read 1 byte (8 bits) from IRQ status register (0Ch).
D. Dummy-read 1 byte from register 0Dh (collision position and interrupt mask).
E. Stopping the dummy read:
(a) When using slave select (SS): set SS bit high.
(b) When not using SS: stop condition when SCLK is high (See Table 5-30).
5.7.1
SPI Interface Without SS* (Slave Select) Pin
The serial interface without the slave select pin must use delimiters for the start and stop conditions.
Between these delimiters, the address, data, and command words can be transferred. All words must be 8
bits long with MSB transmitted first.
Figure 5-8. Serial – SPI Interface Communication (No SS* Pin)
In this mode, a rising edge on data-in (I/O_7, pin 24) while SCLK is high resets the serial interface and
prepares it to receive data. Data-in can change only when SCLK is low and is taken by the reader on the
SCLK rising edge. Communication is terminated by the stop condition when the data-in falling edge occurs
during a high SCLK period.
5.7.2
SPI Interface With SS* (Slave Select) Pin
The serial interface is in reset while the SS* signal is high. Serial data-in (MOSI) changes on the falling
edge, and is validated in the reader on the rising edge, as shown in Figure 5-9. Communication is
terminated when the SS* signal goes high.
All words must be 8 bits long with the MSB transmitted first.
40
System Description
Copyright 2006–2010, Texas Instruments Incorporated
Product Folder Link(s): TRF7960 TRF7961
相關PDF資料
PDF描述
TRF7960RHBT SPECIALTY CONSUMER CIRCUIT, PQCC32
TRF7961RHBR SPECIALTY CONSUMER CIRCUIT, PQCC32
TRF7961RHBT SPECIALTY CONSUMER CIRCUIT, PQCC32
TS(X)8387MFDSSC/SMD 1-CH 8-BIT PROPRIETARY METHOD ADC, PARALLEL ACCESS, CQFP68
TS(X)8387MF_ 1-CH 8-BIT PROPRIETARY METHOD ADC, PARALLEL ACCESS, CQFP68
相關代理商/技術參數
參數描述
TRF7960RHBRG4 功能描述:RFID應答器 Multi-Std Fully Int 13.56MHz RFID AFE RoHS:否 制造商:Murata 存儲容量:512 bit 工作溫度范圍:- 40 C to + 85 C 安裝風格:SMD/SMT 封裝 / 箱體: 封裝:Reel
TRF7960RHBT 功能描述:RFID應答器 Mulit-Standard High Freq RFid Reader RoHS:否 制造商:Murata 存儲容量:512 bit 工作溫度范圍:- 40 C to + 85 C 安裝風格:SMD/SMT 封裝 / 箱體: 封裝:Reel
TRF7960RHBT 制造商:Texas Instruments 功能描述:RFID Reader IC 制造商:Texas Instruments 功能描述:IC, RFID READER, 13.56MHZ, QFN-32
TRF7960RHBTG4 功能描述:RFID應答器 Mulit-Standard High Freq RFID Read/Writ RoHS:否 制造商:Murata 存儲容量:512 bit 工作溫度范圍:- 40 C to + 85 C 安裝風格:SMD/SMT 封裝 / 箱體: 封裝:Reel
TRF7960TB 功能描述:射頻識別變換器工具 TRF7960 Target Board RoHS:否 制造商:Olimex Ltd. 產品:RFID Readers 用于:ISO15693
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*
主站蜘蛛池模板： 东乡县| 花垣县| 琼结县| 大厂| 台前县| 新田县| 南澳县| 宁陵县| 汾西县| 门头沟区| 辛集市| 咸阳市| 苍山县| 新巴尔虎右旗| 沁阳市| 吕梁市| 林州市| 裕民县| 绍兴市| 巴彦淖尔市| 临夏县| 扬州市| 墨江| 甘肃省| 拉孜县| 宝应县| 禹州市| 泗水县| 建昌县| 上杭县| 安塞县| 灵川县| 五华县| 永寿县| 义马市| 江津市| 东平县| 光山县| 镶黄旗| 仁寿县| 泉州市|