- 您現在的位置：買賣IC網 > PDF目錄98286 > TRF7960RHBR (TEXAS INSTRUMENTS INC) SPECIALTY CONSUMER CIRCUIT, PQCC32 PDF資料下載
參數資料
| 型號： | TRF7960RHBR |
| 廠商： | TEXAS INSTRUMENTS INC |
| 元件分類： | 消費家電 |
| 英文描述： | SPECIALTY CONSUMER CIRCUIT, PQCC32 |
| 封裝： | 5 X 5 MM, GREEN, PLASTIC, QFN-32 |
| 文件頁數： | 39/52頁 |
| 文件大小： | 1023K |
| 代理商： | TRF7960RHBR |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁當前第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁
SLOU186F – AUGUST 2006 – REVISED AUGUST 2010
www.ti.com
5.7.2.1
FIFO Operation
The FIFO is a 12-byte register at address 1Fh with byte storage locations 0 to 11. FIFO data is loaded in a
cyclical manner and can be cleared by a reset command (0F).
Associated with the FIFO are two counters and three FIFO status flags. The first counter is a 4-bit FIFO
byte counter (bits B0–B3 in register 1Ch) that keeps track of the number of bytes loaded into the FIFO. If
the number of bytes in the FIFO is n, the register value is n – 1 (number of bytes in FIFO register). If 8
bytes are in the FIFO, the FIFO counter (bits B0–B3 in register 1Ch) has the value 7.
A second counter (12 bits wide) indicates the number of bytes being transmitted (registers 1Dh and 1Eh)
in a data frame. An extension to the transmission-byte counter is a 4-bit broken-byte counter also provided
in register 1Eh (bits B0-B3). Together these counters make up the TX length value that determines when
the reader generates the EOF byte.
FIFO status flags are as follows:
1. FIFO overflow (bit B4 of register 1Ch) – indicates that the FIFO was loaded too soon
2. FIFO level too low (bit B5 of register 1Ch) – indicates that only three bytes are left to be transmitted
(Can be used during transmission)
3. FIFO level high (bit B6 of register 1Ch) – indicates that nine bytes are already loaded into the FIFO
(Can be used during reception to generate a FIFO reception IRQ. This is to notify the MCU to service
the reader in time to ensure a continuous data stream.)
During transmission, the FIFO is checked for an almost-empty condition, and during reception for an
almost-full condition. The maximum number of bytes that can be loaded into the FIFO in a single
sequence is 12 bytes. (Note: The number of bytes in a frame, transmitted or received, can be greater than
12 bytes.)
During transmission, the MCU loads the reader's FIFO (or during reception the MCU removes data from
the FIFO), and the FIFO counter counts the number of bytes being loaded into the FIFO. Meanwhile, the
byte counter keeps track of the number of bytes being transmitted. An interrupt request is generated if the
number of bytes in the FIFO is less than 3 or greater than 9, so that MCU can send new data or remove
the data as necessary. The MCU also checks the number of data bytes to be sent, so as to not surpass
the value defined in TX length bytes. The MCU also signals the transmit logic when the last byte of data is
sent or was removed from the FIFO during reception. Transmission starts automatically after the first byte
is written into FIFO.
5.8
External Power Amplifier Application
Applications requiring an extended read range can use an external power amplifier together with the
TRF7960/61. This can be implemented by adding an external power amplifier on the transmit side and
external sub-carrier detectors on the receive side.
To implement the external power amplification feature, certain registers must be programmed as shown
below.
1. Set bit B6 of the Regulator and I/O Control register to 1 (see Table 5-21).
This setting has two functions, first to provide a modulated signal for the transmitter if needed, and
second to configure the TRF7960/61 receiver inputs for an external demodulated sub-carrier input.
2. Set bit B3 of the modulation and SYS_CLK control register to 1 (see Table 5-19).
This function configures the ASK / OOK pin for either a digital or analog output (B3 = 0 enables a
digital output, B3 = 1 enables an analog output).
44
System Description
Copyright 2006–2010, Texas Instruments Incorporated
相關PDF資料 |
PDF描述 |
|---|---|
| TRF7960RHBT | SPECIALTY CONSUMER CIRCUIT, PQCC32 |
| TRF7961RHBR | SPECIALTY CONSUMER CIRCUIT, PQCC32 |
| TRF7961RHBT | SPECIALTY CONSUMER CIRCUIT, PQCC32 |
| TS(X)8387MFDSSC/SMD | 1-CH 8-BIT PROPRIETARY METHOD ADC, PARALLEL ACCESS, CQFP68 |
| TS(X)8387MF_ | 1-CH 8-BIT PROPRIETARY METHOD ADC, PARALLEL ACCESS, CQFP68 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| TRF7960RHBRG4 | 功能描述:RFID應答器 Multi-Std Fully Int 13.56MHz RFID AFE RoHS:否 制造商:Murata 存儲容量:512 bit 工作溫度范圍:- 40 C to + 85 C 安裝風格:SMD/SMT 封裝 / 箱體: 封裝:Reel |
| TRF7960RHBT | 功能描述:RFID應答器 Mulit-Standard High Freq RFid Reader RoHS:否 制造商:Murata 存儲容量:512 bit 工作溫度范圍:- 40 C to + 85 C 安裝風格:SMD/SMT 封裝 / 箱體: 封裝:Reel |
| TRF7960RHBT | 制造商:Texas Instruments 功能描述:RFID Reader IC 制造商:Texas Instruments 功能描述:IC, RFID READER, 13.56MHZ, QFN-32 |
| TRF7960RHBTG4 | 功能描述:RFID應答器 Mulit-Standard High Freq RFID Read/Writ RoHS:否 制造商:Murata 存儲容量:512 bit 工作溫度范圍:- 40 C to + 85 C 安裝風格:SMD/SMT 封裝 / 箱體: 封裝:Reel |
| TRF7960TB | 功能描述:射頻識別變換器工具 TRF7960 Target Board RoHS:否 制造商:Olimex Ltd. 產品:RFID Readers 用于:ISO15693 |
發布緊急采購，3分鐘左右您將得到回復。