欧美成人免费电影,国产欧美一区二区三区精品酒店,精品国产a毛片,色网在线免费观看

參數資料
型號: TSB14C01HV
廠商: Texas Instruments, Inc.
英文描述: 5-V IEEE 1394-1995 BACKPLANE TRANSCEIVER/ARBITER
中文描述: 5V的電機及電子學工程師聯合會1394-1995背板收發器/仲裁者
文件頁數: 31/35頁
文件大小: 224K
代理商: TSB14C01HV
6
11
6.3.3
Arbitration Sequence Format
The following format for the arbitration sequence is used:
PRIORITY
ARBITRATION NUMBER
4-bits
6-bits
Each module on the backplane has unique 6-bit arbitration number that is equal to the nodes Physical_ID.
The arbitration number is preceded by four bits of priority. The MSB of the priority field is transmitted first.
The LSB of the priority field is followed by the MSB of the arbitration number.
Dynamic assignment of priority is accommodated.
The lowest priority level (all zeroes) is reserved for fair arbitration, and the highest priority level (all ones)
is reserved for the identification of the cycle start packet.
6.4
Arbitration
Unless a node is using immediate arbitration to access the bus (in which case there is no contention for the bus), it
is possible that more than one node can attempt to access the bus at a given time. Consequently, it is necessary for
a node to arbitrate for the bus in order to gain access to the bus.
NOTE:
A node uses immediate arbitration to send an acknowledge. Since there is no
contention for the bus in this case, arbitration is not necessary. A node that is transmitting an
acknowledge does not arbitrate for the bus, but merely waits for an acknowledge gap to be
detected before it begins transmission. If a node is attempting to gain access to the bus without
using immediate access, it must first arbitrate for the bus.
Arbitration occurs in response to a PHY arbitration request from the link. Nodes begin arbitrating once the bus has
become idle for a predetermined amount of time (the appropriate gap indication occurs). Once this happens, nodes
begin a bit-by-bit transmission of their arbitration sequence.
A node can obtain access to the bus in a limited number of ways. Since some arbitration classes allow nodes to begin
arbitration before others, nodes arbitrating with certain arbitration classes can detect that the bus is busy before they
can begin to arbitrate. In this way, certain arbitration classes can be bypassed, e.g., fair and urgent nodes do not get
a chance to arbitrate when another node is sending an acknowledge.
The backplane environment supports the fair, urgent, and immediate arbitration classes.
6.4.1
Fairness Intervals
The fairness protocol is based on the concept of a fairness interval. A fairness interval consists of one or more periods
of bus activity separated by short idle periods called subaction gaps and is followed by a longer idle period known
as an arbitration reset gap. At the end of each gap, bus arbitration is used to determine the next bus owner. This
concept is shown in Figure 6
9.
arb
data
a
a
arb
data
a
arb
a
arb
data
a
arb
Owner A
Owner B
Owner M
Fairness Interval N
Fairness
Interval N
1
Fairness
Interval N+1
Subaction Gaps
Arbitration
Reset Gap
Arbitration
Reset Gap
Subaction
Figure 6
9. Fairness Interval
The implementation of the fair arbitration protocol is defined in terms of these fairness intervals as is discussed in
the following paragraphs.
相關PDF資料
PDF描述
TSB21LV03MHV IC APEX 20KE FPGA 200K 484-FBGA
TSB21LV03CHV IEEE 1394-1995 TRIPLE-CABLE TRANSCEIVER/ARBITER
TSB2203X6MMX30M IC APEX 20KE FPGA 200K 240-PQFP
TSB2204.5X12MMX20M IC APEX 20KE FPGA 200K 240-PQFP
TSB2204.5X19MMX20M IC APEX 20KE FPGA 200K 240-PQFP
相關代理商/技術參數
參數描述
TSB14C01MHV 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Transceiver
TSB14C01PM 制造商:Rochester Electronics LLC 功能描述:- Bulk
TSB15 制造商:未知廠家 制造商全稱:未知廠家 功能描述:EURO TERMINAL BLOCKS
TSB150002DS 制造商:TE Connectivity 功能描述:
TSB150004DS 制造商:TE Connectivity 功能描述:Conn Europa Terminal Blocks 8 POS 13.5mm Screw ST Cable Mount 40A/Contact
主站蜘蛛池模板: 凉山| 洪洞县| 仪陇县| 蚌埠市| 赣州市| 荣昌县| 富源县| 平利县| 胶南市| 石景山区| 平罗县| 芦溪县| 栾城县| 孟州市| 龙泉市| 昂仁县| 全椒县| 胶州市| 黔东| 尼勒克县| 汶上县| 莲花县| 崇仁县| 宁津县| 清新县| 年辖:市辖区| 隆化县| 大安市| 中牟县| 宜州市| 柘城县| 肃宁县| 江孜县| 禹州市| 岳普湖县| 南溪县| 敖汉旗| 南充市| 濉溪县| 筠连县| 河北区|