欧美成人免费电影,国产欧美一区二区三区精品酒店,精品国产a毛片,色网在线免费观看

參數資料
型號: 73S1209F-68IMR/F
廠商: MAXIM INTEGRATED PRODUCTS INC
元件分類: 電源管理
英文描述: POWER SUPPLY MANAGEMENT CKT, QCC68
封裝: LEAD FREE, QFN-68
文件頁數: 94/123頁
文件大小: 1385K
代理商: 73S1209F-68IMR/F
73S1209F Data Sheet
DS_1209F_004
Figure 15: Asynchronous Activation Sequence Timing
VCC
IO
RST
CLK
t1
t2
t3
t4
t5
Firmware sets
VCCSEL to 00
CMDVCCnB
t5 delay or
Card Event
t1: Time after either a “card event” occurs or firmware sets the VCCSela and VCCSelb bits to 0 (see
t5, VCCOff_tmr) occurs until RST is asserted low.
t2: Time after RST goes low until CLK stops.
t3: Time after CLK stops until IO goes low.
t4: Time after IO goes low until VCC is powered down.
t5: Delayed VCC off time (in ETUs per VCCOff_tmr bits). Only in effect due to firmware deactivation.
Figure 16: Deactivation Sequence
1.7.13.3 Data Reception/Transmission
When a 12Mhz crystal is used, the smart card UART will generate a 3.69Mhz (default) clock to both
smart card interfaces. This will allow approximately 9600bps (1/ETU) communication during ATR (ISO
7816 default). As part of the PPS negotiation between the smart card and the reader, the firmware may
determine that the smart card parameters F & D may be changed. After this negotiation, the firmware
may change the ETU by writing to the SFR FDReg to adjust the ETU and CLK. The firmware may also
change the smart card clock frequency by writing to the SFR SCCLK (SCECLK for external interface).
Independent clock frequency control is provided to each smart card interface. Clock stop high or Clock
stop low is supported in asynchronous mode. Figure 17 shows the ETU and CLK control circuits. The
firmware determines when clock stop is supported by the smart card and when it is appropriate to go into
that mode (and when to come out of it). The smart card UART is clocked by the same clock that is
provided to the selected smart card. The transition between smart card clocks is handled in hardware to
eliminate any glitches for the UART during switchover. The external smart card clock is not affected
when switching the UART to communicate with the internal smart card.
72
Rev. 1.2
相關PDF資料
PDF描述
73S1209F-44IMR/F POWER SUPPLY MANAGEMENT CKT, QCC44
73S1209F-68IMR/F POWER SUPPLY MANAGEMENT CKT, QCC68
73S1209F-68IM/F POWER SUPPLY MANAGEMENT CKT, QCC68
73S1209F-44IMR/F POWER SUPPLY MANAGEMENT CKT, QCC44
73S1209F-44IM/F POWER SUPPLY MANAGEMENT CKT, QCC44
相關代理商/技術參數
參數描述
73S1209F-68M/F/P1 功能描述:8位微控制器 -MCU Contained 80515-SoC Serial Hst Interface RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT
73S1209F-EB 功能描述:開發板和工具包 - 8051 73S1209F Eval Brd (Doc. Cd, Cable) RoHS:否 制造商:Silicon Labs 產品:Development Kits 工具用于評估:C8051F960, Si7005 核心: 接口類型:USB 工作電源電壓:
73S1209F-IM44 DK 制造商:Maxim Integrated Products 功能描述:Development Boards & Kits - 8051 73S1209F Dev Kit Eval Bd Ice Cable Cd
73S1209F-IM44 EB 制造商:Maxim Integrated Products 功能描述:Development Boards & Kits - 8051 73S1209F Eval Brd Eval Bd Doc Cd Cable
73S1209F-IM68 DK 制造商:Maxim Integrated Products 功能描述:Development Boards & Kits - 8051 73S1209F Dev Kit Eval Bd Ice Cable Cd
主站蜘蛛池模板: 额敏县| 逊克县| 福州市| 象山县| 扬中市| 阿尔山市| 大新县| 安平县| 泾阳县| 汉寿县| 肇源县| 昌都县| 巨野县| 固阳县| 蕉岭县| 西乌珠穆沁旗| 北京市| 澄江县| 鸡东县| 康定县| 高要市| 洱源县| 大余县| 桃江县| 瑞丽市| 广南县| 铁力市| 青浦区| 丹阳市| 阜南县| 新泰市| 始兴县| 谷城县| 公安县| 金乡县| 崇仁县| 海阳市| 顺平县| 威信县| 芦溪县| 大兴区|