- 您現在的位置：買賣IC網 > PDF目錄373911 > AD7641ACP (ANALOG DEVICES INC) 18-Bit, 2 MSPS SAR ADC PDF資料下載
參數資料
| 型號： | AD7641ACP |
| 廠商： | ANALOG DEVICES INC |
| 元件分類： | ADC |
| 英文描述： | 18-Bit, 2 MSPS SAR ADC |
| 中文描述： | 1-CH 18-BIT SUCCESSIVE APPROXIMATION ADC, PARALLEL ACCESS, QCC48 |
| 封裝： | MO-220-VKKD, LFCSP-48 |
| 文件頁數： | 21/24頁 |
| 文件大?。?/td> | 324K |
| 代理商： | AD7641ACP |
Preliminary Technical Data
AD7641
MICROPROCESSOR INTERFACING
The AD7641 is ideally suited for traditional dc measurement
applications supporting a microprocessor, and ac signal
processing applications interfacing to a digital signal processor.
The AD7641 is designed to interface either with a parallel 8-bit
or 16-bit wide interface or with a general purpose serial port or
I/O ports on a microcontroller. A variety of external buffers can
be used with the AD7641 to prevent digital noise from coupling
into the ADC. The following section illustrates the use of the
AD7641 with an SPI equipped DSP, the ADSP-219x.
SPI Interface (ADSP-219x)
Figure 22 shows an interface diagram between the AD7641 and
an SPI-equipped DSP, ADSP219x. To accommodate the slower
speed of the DSP, the AD7641 acts as a slave device and data
must be read after conversion. This mode also allows the “daisy
chain” feature. The convert command could be initiated in
response to an internal timer interrupt. The 18-bit output data
are read with 3 SPI byte access. The reading process could be
initiated in response to the end-of-conversion signal (BUSY
going low) using an interrupt line of the DSP. The Serial
Rev. Pr E | Page 21 of 24
Peripheral Interface (SPI) on the ADSP-219x is configured for
master mode (MSTR) = 1, Clock Polarity Bit (CPOL) = 0, Clock
Phase Bit (CPHA) = 1 and SPI interrupt enable (TIMOD) =00
by writing to the SPI Control Register (SPICLTx). It should be
noted that to meet all timing requirements, the SPI clock should
be limited to 17Mbits/s which allow to read an ADC result in
about 1.1 μs. When higher sampling rate is desired, it is
recommended to use one of the parallel interface mode with the
ADSP-219x.
SPIxSEL (PFx)
ADSP-219x*
CNVST
AD7641*
CS
MISOx
SCKx
PFx or TFSx
SDOUT
SCLK
INVSCLK
EXT/INT
DVDD
*ADDITIONAL PINS OMITTED FOR CLARITY
SER/PAR
RD
PFx
BUSY
Figure 24. Interfacing the AD7641 to SPI Interface
相關PDF資料 |
PDF描述 |
|---|---|
| AD7641ACPRL | ECONOLINE: REC2.2-S_DRW(Z)/H* - 2.2W DIP Package- 1kVDC Isolation- Regulated Output- 4.5-9V, 9-18V, 18-36V, 36-72V Wide Input Range 2 : 1- UL94V-0 Package Material- Continuous Short Circiut Protection- Cost Effective- 100% Burned In- Efficiency to 84% |
| AD7641AST | 18-Bit, 2 MSPS SAR ADC |
| AD7641ASTRL | 18-Bit, 2 MSPS SAR ADC |
| AD7650 | 16-Bit 1 MSPS SAR Unipolar ADC with Ref |
| AD7651 | Circular Connector; MIL SPEC:MIL-DTL-38999 Series III; Body Material:Metal; Series:D38999 Series III; No. of Contacts:4; Connector Shell Size:13; Connecting Termination:Crimp; Circular Shell Style:Straight Plug; Body Style:Straight RoHS Compliant: No |
相關代理商/技術參數 |
參數描述 |
|---|---|
| AD7641ACPRL | 制造商:Analog Devices 功能描述:ADC SGL SAR 2MSPS 18BIT PARALLEL/SERL 48LFCSP - Tape and Reel |
| AD7641AST | 制造商:Analog Devices 功能描述:ADC SGL SAR 2MSPS 18BIT PARALLEL/SERL 48LQFP - Bulk |
| AD7641ASTRL | 制造商:Analog Devices 功能描述:ADC SGL SAR 2MSPS 18BIT PARALLEL/SERL 48LQFP - Tape and Reel |
| AD7641BCPZ | 功能描述:IC ADC 18BIT 2MSPS SAR 48-LFCSP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 其它有關文件:TSA1204 View All Specifications 標準包裝:1 系列:- 位數:12 采樣率（每秒）:20M 數據接口:并聯 轉換器數目:2 功率耗散（最大）:155mW 電壓電源:模擬和數字 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:48-TQFP 供應商設備封裝:48-TQFP（7x7） 包裝:Digi-Reel® 輸入數目和類型:4 個單端，單極；2 個差分，單極 產品目錄頁面:1156 (CN2011-ZH PDF) 其它名稱:497-5435-6 |
| AD7641BCPZRL | 功能描述:IC ADC 18BIT 2MSPS SAR 48-LFCSP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1 系列:- 位數:14 采樣率（每秒）:83k 數據接口:串行，并聯 轉換器數目:1 功率耗散（最大）:95mW 電壓電源:雙 ± 工作溫度:0°C ~ 70°C 安裝類型:通孔 封裝/外殼:28-DIP（0.600"，15.24mm） 供應商設備封裝:28-PDIP 包裝:管件 輸入數目和類型:1 個單端，雙極 |
發布緊急采購，3分鐘左右您將得到回復。