欧美成人免费电影,国产欧美一区二区三区精品酒店,精品国产a毛片,色网在线免费观看

參數資料
型號: ADSP-21160NCB-TBD
廠商: Analog Devices, Inc.
元件分類: 基準電壓源/電流源
英文描述: Cap-Free, NMOS, 150mA Low Dropout Regulator with Reverse Current Protection
中文描述: 無電容,NMOS管,150mA的低壓差穩壓器的反向電流保護
文件頁數: 3/53頁
文件大小: 1680K
代理商: ADSP-21160NCB-TBD
This information applies to a product under development. Its characteristics and specifications are subject to change without notice. Analog
Devices assumes no obligation regarding future manufacturing unless otherwise agreed to in writing.
3
REV. PrB
For current information contact Analog Devices at 800/262-5643
ADSP-21160N
April 2002
PRELIMINARY TECHNICAL DATA
processor that supports 14 DMA channels, two serial ports,
six link ports, external parallel bus, and glueless
multiprocessing.
The functional block diagram
on page 1
shows a block
diagram of the ADSP-21160N, illustrating the following
architectural features:
Two processing elements, each made up of an ALU, Mul-
tiplier, Shifter, and Data Register File
Data Address Generators (DAG1, DAG2)
Program sequencer with instruction cache
PM and DM buses capable of supporting four 32-bit data
transfers between memory and the core every core
processor cycle
Interval timer
On-Chip SRAM (4M bits)
External port that supports:
Interfacing to off-chip memory peripherals
Glueless multiprocessing support for six
ADSP-21160N SHARCs
Host port
DMA controller
Serial ports and link ports
JTAG test access port
Figure 1
shows a typical single-processor system. A multi-
processing system appears in
Figure 4
.
ADSP-21160N Family Core Architecture
The ADSP-21160N includes the following archi-
tectural features of the ADSP-2116x family core. The
ADSP-21160N is code compatible at the assembly level
with the ADSP-2106x and ADSP-21161.
SIMD Computational Engine
The ADSP-21160N contains two computational process-
ing elements that operate as a Single Instruction Multiple
Data (SIMD) engine. The processing elements are referred
to as PEX and PEY, and each contains an ALU, multiplier,
shifter, and register file. PEX is always active, and PEY may
be enabled by setting the PEYEN mode bit in the MODE1
register. When this mode is enabled, the same instruction
is executed in both processing elements, but each processing
element operates on different data. This architecture is
efficient at executing math-intensive DSP algorithms.
Entering SIMD mode also has an effect on the way data is
transferred between memory and the processing elements.
When in SIMD mode, twice the data bandwidth is required
to sustain computational operation in the processing
elements. Because of this requirement, entering SIMD
mode also doubles the bandwidth between memory and the
processing elements. When using the DAGs to transfer data
in SIMD mode, two data values are transferred with each
access of memory or the register file.
Independent, Parallel Computation Units
Within each processing element is a set of computational
units. The computational units consist of an arith-
metic/logic unit (ALU), multiplier, and shifter. These units
perform single-cycle instructions. The three units within
each processing element are arranged in parallel, maximiz-
ing computational throughput. Single multifunction
instructions execute parallel ALU and multiplier opera-
tions. In SIMD mode, the parallel ALU and multiplier
operations occur in both processing elements. These com-
putation units support IEEE 32-bit single-precision
floating-point, 40-bit extended precision floating-point,
and 32-bit fixed-point data formats.
Data Register File
A general-purpose data register file is contained in each
processing element. The register files transfer data between
the computation units and the data buses, and store inter-
mediate results. These 10-port, 32-register (16 primary, 16
secondary) register files, combined with the ADSP-2116x
enhanced Harvard architecture, allow unconstrained data
flow between computation units and internal memory. The
registers in PEX are referred to as R0–R15 and in PEY
as S0–S15.
Single-Cycle Fetch of Instruction and Four Operands
The ADSP-21160N features an enhanced Harvard archi-
tecture in which the data memory (DM) bus transfers data,
and the program memory (PM) bus transfers both instruc-
tions and data (see the functional block diagram
on page 1
).
Figure 1. Single-Processor System
3
4
RESET
JTAG
6
ADSP-21160
CLKIN
BMS
CLOCK
LINK
DEVICES
(6 MAX)
(OPTIONAL)
CS
BOOT
EPROM
(OPTIONAL)
ADDR
MEMORY/
MAPPED
DEVICES
(OPTIONAL)
OE
WE
DATA
DMA DEVICE
(OPTIONAL)
DATA
ADDR
DATA
HOST
PROCESSOR
INTERFACE
(OPTIONAL)
CS
RDx
WRx
PAGE
CLKOUT
DMAR1–2
DMAG1–2
ACK
MS3–0
BR1–6
IRQ2–0
FLAG3–0
TIMEXP
LXCLK
LXACK
LXDAT7–0
TCLK0
RCLK0
RPBA
ID2–0
4
CLK_CFG3–0
EBOOT
LBOOT
DR0
DT0
TFS0
TCLK1
RCLK1
DR1
DT1
RSF1
TFS1
SERIAL
DEVICE
(OPTIONAL)
SERIAL
DEVICE
(OPTIONAL)
PA
REDY
HBG
HBR
SBTS
DATA63–0
DATA
ADDR
CS
ACK
ADDR31–0
D
C
A
CIF
BRST
相關PDF資料
PDF描述
ADSP-21161N DSP Microcomputer
ADSP-21161NCCA-100 DSP Microcomputer
ADSP-21161NKCA-100 DSP Microcomputer
ADSP-21262SBBC-150 Embedded Processor
ADSP-21262SBBCZ150 Embedded Processor
相關代理商/技術參數
參數描述
ADSP-21160NCBZ-100 功能描述:IC DSP CONTROLLER 32BIT 400-PBGA RoHS:是 類別:集成電路 (IC) >> 嵌入式 - DSP(數字式信號處理器) 系列:SHARC® 標準包裝:40 系列:TMS320DM64x, DaVinci™ 類型:定點 接口:I²C,McASP,McBSP 時鐘速率:400MHz 非易失內存:外部 芯片上RAM:160kB 電壓 - 輸入/輸出:3.30V 電壓 - 核心:1.20V 工作溫度:0°C ~ 90°C 安裝類型:表面貼裝 封裝/外殼:548-BBGA,FCBGA 供應商設備封裝:548-FCBGA(27x27) 包裝:托盤 配用:TMDSDMK642-0E-ND - DEVELPER KIT W/NTSC CAMERA296-23038-ND - DSP STARTER KIT FOR TMS320C6416296-23059-ND - FLASHBURN PORTING KIT296-23058-ND - EVAL MODULE FOR DM642TMDSDMK642-ND - DEVELOPER KIT W/NTSC CAMERA
ADSP-21160NCE-100 制造商:Analog Devices 功能描述:
ADSP-21160NKB-100 功能描述:IC DSP CONTROLLER 32BIT 400BGA RoHS:否 類別:集成電路 (IC) >> 嵌入式 - DSP(數字式信號處理器) 系列:SHARC® 標準包裝:2 系列:StarCore 類型:SC140 內核 接口:DSI,以太網,RS-232 時鐘速率:400MHz 非易失內存:外部 芯片上RAM:1.436MB 電壓 - 輸入/輸出:3.30V 電壓 - 核心:1.20V 工作溫度:-40°C ~ 105°C 安裝類型:表面貼裝 封裝/外殼:431-BFBGA,FCBGA 供應商設備封裝:431-FCPBGA(20x20) 包裝:托盤
ADSP-21160NKB-95 制造商:AD 制造商全稱:Analog Devices 功能描述:DSP Microcomputer
ADSP-21160NKB-X 制造商:Analog Devices 功能描述:
主站蜘蛛池模板: 武穴市| 西乌珠穆沁旗| 疏勒县| 安国市| 集贤县| 无锡市| 苍溪县| 花莲市| 鄂伦春自治旗| 垣曲县| 苍溪县| 南漳县| 尖扎县| 凤翔县| 互助| 肃南| 随州市| 平远县| 阳泉市| 厦门市| 遵义县| 会同县| 内黄县| 临邑县| 历史| 武强县| 富民县| 怀宁县| 隆化县| 齐河县| 慈利县| 广灵县| 清水河县| 台北县| 东方市| 平和县| 台湾省| 北票市| 来凤县| 夹江县| 桐梓县|