- 您現在的位置：買賣IC網 > PDF目錄18702 > EFM32-TG110F32-SK (Energy Micro)IC MICRO KIT GECKO 24QFN PDF資料下載
參數資料
| 型號： | EFM32-TG110F32-SK |
| 廠商： | Energy Micro |
| 文件頁數： | 130/136頁 |
| 文件大小： | 0K |
| 描述： | IC MICRO KIT GECKO 24QFN |
| 標準包裝： | 1 |
| 系列： | Tiny Gecko |
| 套件類型： | 微控制器 |
| 值： | 2 件 - 閃存 - 32KB |
| 包裝： | 紙板盒 |
| 安裝類型： | 表面貼裝 |
| 包括封裝： | 24-QFN |
| 工具箱內容： | (2) 914-1033-2-ND - MCU 32BIT 32KB FLASH 24-QFN |
| 其它名稱： | 914-1022 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁第118頁第119頁第120頁第121頁第122頁第123頁第124頁第125頁第126頁第127頁第128頁第129頁當前第130頁第131頁第132頁第133頁第134頁第135頁第136頁
...the world's most energy friendly microcontrollers
2011-02-04 - d0002_Rev1.00
93
www.energymicro.com
byte offset 2 refers to register bits[23:16]
byte offset 3 refers to register bits[31:24].
4.2.8 Software Trigger Interrupt Register
Write to the STIR to generate a Software Generated Interrupt (SGI). See the register summary in
Table 4.2 (p. 88) for the STIR attributes.
When the USERSETMPEND bit in the SCR is set to 1, unprivileged software can access the STIR, see
Note
Only privileged software can enable unprivileged access to the STIR.
The bit assignments are:
9
31
0
Reserved
INTID
8
Table 4.10. STIR bit assignments
Bits
Field
Function
[31:9]
-
Reserved.
[8:0]
INTID
Interrupt ID of the required SGI, in the range 0 to (n-1), where n denotes the number of interrupts given
by Table 1.1 (p. 5) . For example, a value of b000000011 specifies interrupt IRQ3.
4.2.9 Level-sensitive interrupts
All interrupt lines in the EFM32 devices are level sensitive interrupts. A level-sensitive interrupt is held
asserted until the peripheral deasserts the interrupt signal. Typically this happens because the ISR
accesses the peripheral, causing it to clear the interrupt request.
When the processor enters the ISR, it automatically removes the pending state from the interrupt, see
Section 4.2.9.1 (p. 93) . If the signal is not deasserted before the processor returns from the ISR, the
interrupt becomes pending again, and the processor must execute its ISR again. This means that the
peripheral can hold the interrupt signal asserted until it no longer needs servicing.
4.2.9.1 Hardware and software control of interrupts
The Cortex-M3 latches all interrupts. A peripheral interrupt becomes pending for one of the following
reasons:
the NVIC detects that the interrupt signal is HIGH and the interrupt is not active
the NVIC detects a rising edge on the interrupt signal
software writes to the corresponding interrupt set-pending register bit, see Section 4.2.4 (p. 90) ,
or to the STIR to make an SGI pending, see Section 4.2.8 (p. 93) .
A pending interrupt remains pending until one of the following:
The processor enters the ISR for the interrupt. This changes the state of the interrupt from pending
to active. Then:
When the processor returns from the ISR, the NVIC samples the interrupt signal. If the signal
is asserted, the state of the interrupt changes to pending, which might cause the processor to
immediately re-enter the ISR. Otherwise, the state of the interrupt changes to inactive.
Software writes to the corresponding interrupt clear-pending register bit.
相關PDF資料 |
PDF描述 |
|---|---|
| FAM1-400-400-2.0-1A | FAM1 SHEET 400X400X2MM W/ADH |
| EFM32-TG108F32-SK | IC MICRO KIT GECKO 24QFN |
| FAM1-400-400-1.5-1A | FAM1 SHEET 400X400X1.5MM W/ADH |
| EFM32-G890F128-SK | IC MICRO KIT GECKO 112BGA |
| 176C | TRANSFORMER AUTO STEP UP/PLG IN |
相關代理商/技術參數 |
參數描述 |
|---|---|
| EFM32TG110F32-T | 制造商:Energy Micro AS 功能描述:IC MCU 32BIT 32KB FLASH 24QFN |
| EFM32TG110F4 | 功能描述:ARM微控制器 - MCU 4KB Flash 1KB RAM RoHS:否 制造商:STMicroelectronics 核心:ARM Cortex M4F 處理器系列:STM32F373xx 數據總線寬度:32 bit 最大時鐘頻率:72 MHz 程序存儲器大小:256 KB 數據 RAM 大小:32 KB 片上 ADC:Yes 工作電源電壓:1.65 V to 3.6 V, 2 V to 3.6 V, 2.2 V to 3.6 V 工作溫度范圍:- 40 C to + 85 C 封裝 / 箱體:LQFP-48 安裝風格:SMD/SMT |
| EFM32TG110F4-QFN24 | 制造商:Energy Micro AS 功能描述:TINY GECKO MCU - Tape and Reel 制造商:Energy Micro 功能描述:energy micro EFM32TG110F4-QFN24 Microcontrollers (MCU) 制造商:Energy Micro AS 功能描述:IC MCU 32BIT 4KB FLASH 24QFN |
| EFM32TG110F4-QFN24T | 制造商:Energy Micro AS 功能描述:32 BIT ARM MPU, TINY GECKO - Trays |
| EFM32TG110F4-QFN24-T | 制造商:Energy Micro AS 功能描述:IC MCU 32BIT 4KB FLASH 24QFN |
發布緊急采購，3分鐘左右您將得到回復。