欧美成人免费电影,国产欧美一区二区三区精品酒店,精品国产a毛片,色网在线免费观看

參數資料
型號: HMS77C1001A
廠商: Hynix Semiconductor Inc.
元件分類: 數學處理器
英文描述: 8-BIT SINGLE-CHIP MICROCONTROLLERS
中文描述: 8位單晶片微控制器
文件頁數: 31/45頁
文件大小: 549K
代理商: HMS77C1001A
HMS77C1000A/HMS77C1001A
28
Oct. 2001 Ver. 2.0
Legend: x = unknown, u = unchanged.
11.3 Using Timer0 with an External Clock
When an external clock input is used for Timer0, it must
meet certain requirements. The external clock requirement
is due to internal phase clock (T
OSC
) synchronization. Al-
so, there is a delay in the actual incrementing of Timer0 af-
ter synchronization.
11.3.1 External Clock Synchronization
The synchronization of EC0 input with the internal phase
clocks is accomplished by sampling EC0 clock or the pres-
caler output on the Q2 and Q4 falling of the internal phase
clocks.
After the synchronization, counter increments on the next
instruction cycle (Q4). There is a small delay from the time
the external clock edge occurs to the time the Timer0 mod-
ule is actually incrementing. Figure 11-5 shows the syn-
chronization and the increment of the counter mode.
EC0 clock specification
- No Prescaler (PSA = 0)
High or low time(min)
2T
XIN
+ 20ns
- With Prescaler (PSA = 1)
High or low time(min)
4T
XIN
+ 40ns
But, there is a noise filter on the EC0 pin, the minimum low
or high time(10ns) should be required.
11.3.2 Timer0 Increment Delay
Since the prescaler output is synchronized with the internal
clocks, there is a small delay from the time the external
clock edge occurs to the time the Timer0 module is actual-
ly incrementing. Figure 11-5 shows the delay from the ex-
ternal clock edge to the timer incrementing.
11.4 Prescaler
The prescaler may be used by either the Timer0 module or
the Watchdog Timer, but not both. Thus, a prescaler as-
signment for the Timer0 module means that there is no
prescaler for the WDT, and vice-versa.
The prescaler assignment is controlled in software by the
control bit PSA (OPTION<3>). Clearing the PSA bit will
assign the prescaler to Timer0. The prescaler is neither
readable nor writable.
The PSA and PS2:PS0 bits (OPTION<3:0>) determine
prescaler assignment and prescale ratio. When the prescal-
er is assigned to the Timer0 module, prescale values of 1:2,
Name
Address
Bit7
Bit6
Bit5
Bit4
Bit3
Bit2
Bit1
Bit0
Power-On
Reset
RESET and
WDT Reset
TMR0
01
H
8-bit real-time clock/counter
xxxx xxxx
uuuu uuuu
OPTION N/A
LOWOPT
PFDEN
T0CS
T0SE
PSA
PS2
PS1
PS0
0011 1111
0011 1111
TABLE 11-1 REGISTERS ASSOCIATED WITH TIMER0
FIGURE 11-5 TIMER0 TIMING WITH EXTERNAL CLOCK
Q1 Q2 Q3 Q4
Q1 Q2 Q3 Q4 Q1 Q2 Q3 Q4
T0
T0+1
Note 1: Delay from clock input change to TMR0 increment is 3T
XIN
to 7T
XIN
. (Duration of Q = T
XIN
).
Therefore, the error in measuring the interval between two edges on TMR0 input =
±
4T
XIN
max.
2: External clock if no prescaler selected, prescaler output otherwise.
3: The arrows indicate the points in time where sampling occurs.
Q1 Q2 Q3 Q4
T0+2
External Clock Input or
Prescaler Output
(2)
External Clock/Prescaler
Output After Sampling
Increment TMR0 (Q4)
TMR0
Small Pulse
misses sampling
(1)
(3)
相關PDF資料
PDF描述
HMS81020TL HYNIX SEMICONDUCTOR 8-BIT SINGLE-CHIP MICROCONTROLLERS
HMS81032TL HYNIX SEMICONDUCTOR 8-BIT SINGLE-CHIP MICROCONTROLLERS
HMS81004E HYNIX SEMICONDUCTOR 8-BIT SINGLE-CHIP MICROCONTROLLERS
HMS81008E HYNIX SEMICONDUCTOR 8-BIT SINGLE-CHIP MICROCONTROLLERS
HMS81016E HYNIX SEMICONDUCTOR 8-BIT SINGLE-CHIP MICROCONTROLLERS
相關代理商/技術參數
參數描述
HMS77C2000 制造商:未知廠家 制造商全稱:未知廠家 功能描述:[General Purpose(2) : ADC/ LED/ SCI/ PWM]
HMS77C2001 制造商:未知廠家 制造商全稱:未知廠家 功能描述:[General Purpose(2) : ADC/ LED/ SCI/ PWM]
HMS81004 制造商:未知廠家 制造商全稱:未知廠家 功能描述:REMOTE CONTROLLER
HMS81004E 制造商:HYNIX 制造商全稱:Hynix Semiconductor 功能描述:HYNIX SEMICONDUCTOR 8-BIT SINGLE-CHIP MICROCONTROLLERS
HMS81008 制造商:未知廠家 制造商全稱:未知廠家 功能描述:REMOTE CONTROLLER
主站蜘蛛池模板: 和龙市| 和硕县| 望谟县| 怀集县| 扎鲁特旗| 婺源县| 平舆县| 镇平县| 台山市| 孟州市| 商城县| 遂平县| 买车| 万山特区| 德清县| 都安| 临武县| 开原市| 琼海市| 高碑店市| 尉氏县| 龙州县| 三原县| 怀仁县| 伊金霍洛旗| 和顺县| 石家庄市| 休宁县| 密山市| 南昌市| 舞阳县| 砀山县| 陵川县| 九龙城区| 镇安县| 汉阴县| 建阳市| 双辽市| 格尔木市| 罗山县| 顺平县|